Question is ⇒ Which of the following plot can be used to show the input volt-ampere characteristics of a common-emitter configuration?, Options are ⇒ (A) VBE versus iB for constant values of VCE, (B) VCE versus iC for constant values of IB, (C) VCE versus iC for constant values of IE, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following plot can be used to show the input volt-ampere characteristics of a common-emitter configuration?, Options are ⇒ (A) VBE versus iB for constant values of VCE, (B) VCE versus iC for constant values of IB, (C) VCE versus iC for constant values of IE, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following plot can be used to show the input volt-ampere characteristics of a common-emitter configuration?
A.	V_BE versus i_B for constant values of V_CE [Correct Answer]
B.	V_CE versus i_C for constant values of I_B [Wrong Answer]
C.	V_CE versus i_C for constant values of I_E [Wrong Answer]
D.	None of the above [Wrong Answer]
View Answer 2 -5 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A system has its two poles on the negative real axis and one pair of poles lies on jω axis. The system is
stable
unstable
limitedly stable
either (a) or (c)

⇒ A speech signal, band limited to 4kHz and peak voltage varying between + 5V and - 5V is sampled at the Nyquist rate. Each sample is quantized and represented by 8 bits. The number of quantization levels required to reduce the quantization noise by a factor of 4 would be
1024
512
256
64

⇒ In the given figure shows a negative logic AND gate. If positive logic is used this gate is equivalen
AND gate
OR gate
NOR gate
NAND gate

⇒ Tropospheric scatter is used with frequencies in the
HF
VHF
UHF
VLF

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the base current will be
35 μA
25 μA
15 μA
5 μA

⇒ The maximum temperature limit of class B insulation is
90°C
105°C
120°C
130°C

⇒

Assertion (A): The conditions under which it is possible to write Fourier series of a periodic function are called Drichlet conditions.

Reason (R): If f(t) = - f(- t), it is refereed to as odd symmetry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ An instrument of accuracy class 1 can have an error equal to
+ 1% of reading
± 1% of reading
± 1% of full scale deflection
+ 1% of full scale deflection

⇒ When a unit step voltage drives a lag network the output
remains constant at unit step value
increases exponentially from zero to final value
decreases exponentially from 1 to 0
either (b) of (c) depending on values of R and C

⇒ What will be minimum conversion rate in 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
9000
9259
1000
1000

⇒ In figure, I = 2A, then
5 V
3 V
2 V
1 V

⇒ Which of these triggering methods for series connected SCRs use LASCR in the gate circuit?
Resistance triggering
Simultaneous triggering
Sequential triggering
Optical triggering

⇒ The function of a modulator is to
separate two frequencies
extract information from the carrier
amplify the audio frequency signal
impress the information on to a RF carrier

⇒ An electromagnetic wave incidents on a perfect insulator at an angle. If the wave is not entirely parallel polarized, then
the reflected wave will be entirely polarized parallel to the plane of incidence
there will be no reflection
the reflected wave will be entirely polarized perpendicular to the plane of incidence
any of the above

⇒ Radiation efficiency of an antenna is defined as the ratio of
Total power radiated by an antenna to the net power accepted by the antenna from the connected transmitter
The frequency at which minimum power is radiated to the frequency at which maximum power is radiated
Total power accepted from the transmitter to total power generated by the transmitter
Power in main lobe to that in the side lobe

⇒ In a communication system, a process in which statistical averages and time averages are equal is called as,
stationary
ergodic
Gaussian
BIBO stable

⇒ The temperature coefficient of a thermistor
is positive
is negative
zero
may be positive or negative depending on its composition

⇒ Low frequency boost can be easily compensated by
attenuating the frequencies from 0 to 1.25 MHz
using an appropriate de-emphasis circuit in the receiver
using an appropriate pre-emphasis circuit in the transmitter
none

⇒ Above ferroelectric curie temperature, spontaneous polarization in ferroelectric materials becomes stronger.
TRUE
FALSE

⇒ Counterpoise is used in coils having
high resistivity
low resistivity
medium resistivity
both (b) and (c)

⇒ A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be
0.004 Ω
0.005 Ω
0.05 Ω
0.1 Ω

⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts

⇒ A ripple counter has propagation delay.
TRUE
FALSE

⇒ The current I_CBO
increases with increases in temperature
is normally greater for silicon transistor than germanium transistors
mainly depends on the emitter base junction bias
depends largely on the emitter doping

⇒ ECL can be used to high frequencies in the order of
500 kHz
1 MHz
100 MHz
500 MHz

⇒ In a triode the potential of grid (with respect to cathode) is usually
zero
negative
positive
zero or positive

⇒ ECL is a saturating logic.
TRUE
FALSE

⇒ In single tone FM discriminator (S₀/N₀) is
proportional to deviation
proportional to cube of deviation
proportional to square of deviation
none of the above

⇒ What is the frequency of audio modulation?
1000 Hz
2000 Hz
3000 Hz
2000 kHz

⇒ An RL impedance function can also be realized as
RC impedance function
RC admittance function
LC impedance function
LC admittance function