Question is ⇒ Which of the following oscillators is used for the generation of high frequencies?, Options are ⇒ (A) R-C phase shift oscillator, (B) Wien bridge oscillator, (C) L-C oscillator, (D) Blocking oscillator, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following oscillators is used for the generation of high frequencies?, Options are ⇒ (A) R-C phase shift oscillator, (B) Wien bridge oscillator, (C) L-C oscillator, (D) Blocking oscillator, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following oscillators is used for the generation of high frequencies?
A.	R-C phase shift oscillator [Wrong Answer]
B.	Wien bridge oscillator [Wrong Answer]
C.	L-C oscillator [Correct Answer]
D.	Blocking oscillator [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Gunn diode is a transferred electron device.

Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For a BJT if β = 50, I_CEO = 3 μA and I_C = 1.2 mA then I_E
1 mA
1.2 mA
1.3 mA
1.4 mA

⇒ In the given figure the phase angle of Fn is either 0 or &
TRUE
FALSE

⇒ In which of the following circuits is op-amp used in open loop configuration?
Comparator
Summing amplifier
Integrating amplifier
Logarithmic amplifier

⇒ An e-mail message can be sent to many recipients.
TRUE
FALSE

⇒ In the circuit of figure diode will con
from 90 to 180° in the positive half cycle
from 30° to 180° in the positive half cycle
from 50° to 160° in the positive half cycle
from 30° to 150° in the positive half cycle

⇒ For a second order instrument, the optimum range of ξ (damping ratio), which gives good frequency response over a wide range of frequencies is
0.5 to 0.6
0.6 to 0.7
0.7 to 0.8
0.8 to 1.0

⇒ Shift left and shift right operations occur in a calculator.
TRUE
FALSE

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the wave impedance for dominant mode.
130 p
1.3 p
120 p
12 p

⇒ A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR
is forward biased
is reverse biased
may be forward biased or reverse biased
forward biased initially but reverse biased afterwards

⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒ Two capacitors of 20 μF each are in series. The total capacitance is
5 μF
10 μF
40 μF
400 μF

⇒ Three identical coils each having self inductance L are connected in series so that the fluxes of all the three are in the same direction. If mutual inductance between each pair of coils is M, the total inductance of the arrangement is
3 L + 9 M
1.5 L + 3 M
3 L + 3 M
3 L + 6 M

⇒ One volt equals
one joule
one joule/coulomb
one coulomb/joule
none of the above

⇒ The force in a magnetic field is given by F = qvB
F and q are perpendicular and v and B are perpendicular
F and q only are perpendicular to each other
F and v, F and B are mutually perpendicular to each other and v and B at any angle between them
All the four components are perpendicular to each other

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls calculate the phase velocity for dominant mode.
3 x 10⁸ m/sec
5 x 10⁸ m/sec
1.5 x 10⁸ m/sec
9 x 10⁸ m/sec

⇒ In a radio receiver with simple AGC
the highest AGC voltage is produced between stations
an increase in signal strength produces more AGC
the audio stage gain is normally controlled by AGC
the faster the time constant of AGC, more accurate the output

⇒ 1274₁₆ - 3A7₁₆ = __________ .
ACA₁₆
ACB₁₆
ECD₁₆
AAA₁₆

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_EQ will be
5.15 mA
5.2 mA
5 mA
990 mA

⇒

Assertion (A): Ferrites are very useful at very high frequencies.

Reason (R): Ferrites have high permeability and high resistivity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Circular polarization
is useful in reducing depolarization effect on received wave
involves critical alignment of transmitting and receiving antenna
is useful in discrimination between reception of adjacent beams
none of the above

⇒ All poles and zeros of a driving point immittance function of an L-C network
should lie on the jω axis
should lie on the +ve real axis
should lie on the - ve real axis
can lie anywhere in s-plane

⇒ For a reactance function H(s), the slope dH (jω)/dω is
0
always positive
always negative
either 0 or positive

⇒ Good smoothing factor of a coil depends on
inductance of the coil
terminal voltage
cross-sectional area of the wire of the coil
property of the wire of the coil

⇒ If a function has only cosine terms, it must satisfy the equation
f(t) = -f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒ The JFET in the circuit shown in figure has an I_DSS = 10 mA and V_p = -5 V. The value of the resistance R_s for a drain current I_DS = 6.4 mA is (select the nearest va
150 Ω
150 Ω
560 Ω
1 kΩ

⇒ A signal occupies a band 5 kHz to 10 kHz. For proper error free reconstruction at what rate it should be sampled?
10 kHz
20 kHz
5 kHz
(10 + 5) x 2 kHz

⇒ For a Gaussian process, auto-correlation also implies
statistical dependence
statistical independence
ergodic process
none of the above

⇒

Assertion (A): The speed of a shaft can be measured by using a dc tacho generator.

Reason (R): A two phase servometer can also be used as a speed transducer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Current having waveform in figure flows through 10 Ω resistance. Average powe
1000 W
500 W
333.3 W
250 W