Question is ⇒ Which of the following microphones has highest output impedance?, Options are ⇒ (A) Carbon, (B) Ribbon, (C) Crystal, (D) Condenser, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following microphones has highest output impedance?, Options are ⇒ (A) Carbon, (B) Ribbon, (C) Crystal, (D) Condenser, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following microphones has highest output impedance?
A.	Carbon [Wrong Answer]
B.	Ribbon [Wrong Answer]
C.	Crystal [Wrong Answer]
D.	Condenser [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ One of the function of the Sio₂ layer in an IC is to
act as a dielectric for capacitors
prevent shorting of elements by interconnections
from cathodes for diodes
afford protection from the radiations

⇒ The main difference between the broadside arrays and end fire arrays is that
individual elements are fed with same current in broadside arrays and of different magnitude in end fire arrays
in broadside arrays the elements are equidistant whereas in end fire array the distance between elements increases progressively
the total number of elements in broadside array is always one and a half times that of elements in end fire arrays
in broadside array the individual elements are fed in, out of phase by 180° whereas in end fire array individual elements are fed with currents of equal magnitude but their phases vary progressively along the line in such a way as to make the entire arrangement substantially unidirectional

⇒ A magic tee is to be used as CW duplexer. Then port 1, port 2, port 3 (E arm), port 4 (H arm) respectively should be connected to
matched load, antenna, receiver and CW transmitter
CW transmitter, antenna, receiver and matched load
CW transmitter, receiver, antenna and matched load
CW transmitter, matched load, receiver and antenna

⇒ The question below consists of a pair of related words followed by four pairs of words. Select the pair that best expresses the relation in the original p
fallow : land
unaware : sleeper
wit : jester
renovated : house

⇒ An antenna has a resistance of 50 Ω and an equivalent noise resistance of 30 Ω The noise figure in decibels is
1.6 dB
2 dB
3.6 dB
6 dB

⇒

Assertion (A): The output of an 8 bit ADC is 80 H if input is 2.5 V

Reason (R): ADC has an output range of 00 to FF H if input range is - 5 to + 5 V

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In an FM signal, the power
increases as the modulation index increases
reduces as the modulation index increase
increases as the modulation index decreases
remains constant when the modulation index increases

⇒ The open wired circuit in the given figure works
EX - NOR gate
AND gate
XOR gate
NOR gate

⇒ Which impurity atom will give p type semiconductor when added to intrinsic semiconductor?
Phosphorus
Boron
Arsenic
Antimony

⇒ In 8085, Whenever a signal is received at TRAP terminal its program execution is transferred to a subroutine on address __________ .
0000 H
0024 H
002 CH
provided by the address generation logic

⇒ Thermistor is used in
temperature measurement
temperature control
high temperature alarm circuits of devices
all of the above

⇒ 8085 data bus has 8 lines and is bidirectional.
TRUE
FALSE

⇒ The traffic-handling capacity of an Earth station on the uplink depends on
its EIRP
satellite antenna gain
noise associated with the satellite
all of the above

⇒ In an impedance smith chart, a clockwise movement along a constant resistance circle gives rise to
decrease in the value of reactance
an increase in the value of reactance
no change in the reactance value
no change in the impedance value

⇒ The maximum temperature limit of class B insulation is
90°C
105°C
120°C
130°C

⇒ Find I in 4 Ω resis
0.0416666666666667
0.5 A
0.75 A
0.95 A

⇒ Which of the following methods is used for solving differential equations numerically?
Runge-Kutta method
Gauss-elimination method
Newton-Raphson method
Any one of these

⇒ In solids the current flow is due to electrons only.
TRUE
FALSE

⇒ In a colour TV receiver, the sound intercarrier IF is generated in
video detector
video IF amplifier
tuner mixer stage
limiter stage

⇒ A narrow band noise show
AM only
AM and FM
FM
PCM

⇒ In the given figure forward current wave has a magnitud
0.45 A
0.3 A
0.2 A
0.1 A

⇒ The colour of an object is decided by
the reflected colour
the wavelength transmitted through it
reflected colour for opaque object and wavelength transmitted through it for transparent objects
none of the above

⇒ CD4010 is a
inverting buffer
non-inverting hex buffer
NOR IC
NAND IC

⇒ A half adder can be used only for adding
1 s
2 s
4 s
8 s

⇒ The network shown in figur
reciprocal
reciprocal and symmetrical
non-reciprocal
unsymmetrical

⇒ To produce p type semiconductor we add
acceptor atoms
donor atoms
pentavalent impurity
trivalent impurity

⇒ What does the B register contain after the first MOV B, A has been executed?
40 H
60 H
80 H
80 D

⇒ Read the following statements about files in Pascal

A file can grow or shrink dynamically.
A file which consists of only characters is called text file.
Text files may be read and written using standard Pascal READ and WRITE procedures.
Every file must have a beginning but may or may not have an end.

Which of the above are correct?
All
1, 2, 3 only
2, 3, 4 only
1, 2 and 4 only

⇒ Calculate the O/P voltage of a non-inverting constant gain multiplier with R₁ = 100 kΩ, R_f= 600 kΩ, V₁ = 2 volt, then O/P voltage V_o of non inverting op-amp is given by
16 V
14 V
20 V
15 V

⇒ Some desirable features of a computer communication network are

It should accept an intended transmission without excessive delay
The data arriving at a receiving point should be processed rapidly
When a transmission calls for a response, the delay of response should be minimum.

Which of the above are true?
1 and 2 only
1 and 3 only
1, 2, 3
2 and 3 only