Question is ⇒ Which of the following methods is used for laying of underground cables ?, Options are ⇒ (A) Direct laying, (B) Draw-in-system, (C) Solid system, (D) All of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following methods is used for laying of underground cables ?, Options are ⇒ (A) Direct laying, (B) Draw-in-system, (C) Solid system, (D) All of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following methods is used for laying of underground cables ?
A.	Direct laying [Wrong Answer]
B.	Draw-in-system [Wrong Answer]
C.	Solid system [Wrong Answer]
D.	All of the above [Correct Answer]
View Answer 13 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As compared to a 2-wire D.C. distributor, a 3-wire distributor with same maximum voltage to earth uses only
31.25 percent of copper
33.3 percent of copper
66.7 percent of copper
125 percent of copper

⇒ The effect of corona can be detected by
presence of zone detected by odour
hissing sound
faint luminous glow of bluish colour
all of the above

⇒ Corona results in
radio interference
power factor improvement
better regulation
none of the above

⇒ The distributors for residential areas are
single phase
three-phase three wire
three-phase four wire
none of the above

⇒ For which of the following, the excitation control method is satisfactory ?
Low voltage lines
High voltage lines
Short lines
Long lines

⇒ Earthing is necessary to give protection against
danger of electric shock
voltage fluctuation
overloading
high temperature of the conductors

⇒ The angular displacementbetween two interconnected stations is mainly due to
armature reactance of both alternators
reactance of the interconnector
synchronous reactance of both the alternators
all of the above

⇒ To increase the capacity of a transmission line for transmitting power which of the following must be decreased ?
Capacitance
Line inductance
Voltage
All of the above

⇒ If variable part of a.nnual cost on account of interest and depreciation on the capital outlay is equal to the annual cost of electrical energy wasted in the conductors, the total annual cost will be minimum and the corresponding size of conductor will be most economical. This statement is known as
Kelvin's law
Ohm's law
Kirchhoffs law
Faraday's law

⇒ Which of the following is not a constituent for making porcelain insulators ?
Quartz
Kaolin
Felspar
Silica

⇒ In a D.C. 3-wire distributor using balancers and having unequal loads on the two sides
both balancers run as generators
both balancers run as motors
balancer connected to lightly- loaded side runs as a motor
balancer connected to heavily- loaded side runs as a motor

⇒ Which of the following is the source of heat generation in the cables ?
Dielectric losses in cable insulation
IR losses in the conductor
Losses in the metallic sheathings and armourings
All of the above

⇒ In overhead transmission lines the effect of capacitance can be neglected when the length of line is less than
80 km
110 km
150 km
210 km

⇒ In a 70/6 A.C.S.R. conductor there are
35 aluminium conductors and 3 steel conductors
70 aluminium conductors and 6 steel conductors
70 steel conductors and 6 aluminium conductors
none of the above

⇒ Corona usually occurs when the electrostatic stress in air around the conductor exceeds
6.6 kV (r.m.s. value)/cm
11 kV (r.m.s. value)/cm
22 kV (maximum value)/cm
30 kV (maximum value)/cm

⇒ Owing to skin effect
current flows through the half cross-section of the conductor
portion of the conductor near the surface carries more current and core of the conductor carries less current
portion of the conductor near the surface carries less current and core of the conductor carries more current
any of the above

⇒ The minimum clearance between the ground and a 220 kV line is about
4.3 m
5.5 m
7.0 m
10.5 m

⇒ If the height of transmission tower is increased
the line capacitance will decrease but line inductance will remain unchanged
the line capacitance and inductance will not change
the line capacitance will increase but line inductance will decrease
the line capacitance will decrease and line inductance will increase

⇒ The operating voltage of supertension cables is upto
3.3 kV
6.6 kV
11 kV
33 kV

⇒ In a D.C. 3-wire distribution system, balancer fields are cross-connected in order to
boost the generated voltage
balance loads on both sides of the neutral
make both machines run as unloaded motors
equalize voltages on the positive and negative outers

⇒ The underground system cannot be operated above
440 V
11 kV
33 kV
66 kV

⇒ The limit of distance of transmission line may be increased by the use of
series resistances
shunt capacitors and series reactors
series capacitors and shunt reactors
synchronous condensers

⇒ Which of the following is the demerit of a 'constant voltage transmission system' ?
Increase of short-circuit, current of the system
Availability of steady voltage at all loads at the line terminals
Possibility of better protection for the line due to possible use of higher terminal reactances
Improvement of power factor at times of moderate and heavy loads

⇒ The usual spans with R.C.C. poles are
40-50 metres
60-100 metres
80-100 metres
300-500 metres

⇒ Due to which of the following reasons aluminium is being favoured as busbar material ?
Low density
Low cost
Ease of fabrication
None of the above

⇒ The conductors are bundled primarily to
increase reactance
reduce reactance
reduce radio interference
none of the above

⇒ The square root of the ratio of line impedance and shunt admittance is called the
surge impedance of the line
conductance of the line
regulation of the line
none of the above

⇒ By which of the following methods voltage of transmission can be regulated ?
Use of series capacitors to neutralise the effect of series reactance
Switching in shunt capacitors at the receiving end during heavy loads
Use of tap changing transformers
Any of the above methods

⇒ The operating voltage of high voltage cable's is upto
1.1 kV
3.3 kV
6.6 kV
11 kV

⇒ Induction regulators are used for voltage control in
alternators
primary distribution
secondary distribution
none of the above