Question is ⇒ Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?, Options are ⇒ (A) Measurement of unknown voltage, (B) Measurement of resistance, (C) Measurement of unknown current, (D) Calibration of voltmeter, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?, Options are ⇒ (A) Measurement of unknown voltage, (B) Measurement of resistance, (C) Measurement of unknown current, (D) Calibration of voltmeter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?
A.	Measurement of unknown voltage [Wrong Answer]
B.	Measurement of resistance [Correct Answer]
C.	Measurement of unknown current [Wrong Answer]
D.	Calibration of voltmeter [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If operator 'a' = 1 ∠120° then (1 + a) =
-a
-a²
a
-1

⇒ The circuit shown in the figure is best described
bridge rectifier
ring modulator
frequency discriminator
voltage doubler

⇒ A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with ε_r = 4. The reflection coefficient for the normal incidence is
zero
0.5 ∠180°
0.33 ∠0°
0.33 ∠180°

⇒ A balun should have
low SWR at both ports
high SWR at both ports
high SWR at input port and low SWR at output port
low SWR at input port and high SWR at output

⇒ In high power AM transmission, modulation is done at
IF stage
buffer stage
RF stage
oscillator stage

⇒ The specified maximum junction temperature of thyristors is about
50°C
80°C
120°C
200°C

⇒ Consider the following statements

Dissipative attenuator has a fixed value of attenuation.
Reflective attenuator has a fixed value of attenuation.
Both dissipative and reflective attenuators are available only with fixed attenuation.
Both dissipative and reflective attenuators are available with either fixed or variable attenuation.

Which of the above are correct?
1 only
1 and 2
1, 2 and 3
4 only

⇒ In Bode analysis the correction at corner frequency is 3 dB.
TRUE
FALSE

⇒ Piezoelectric effect can be used to measure
force
strain
acceleration
all of the above

⇒ An ideal voltage amplifier should have
low input impedance and high output impedance
high input impedance and low output impedance
high input impedance and high output impedance
low input impedance and low output impedance

⇒ What will be output for decimal input 82?
0.82 V
8 V
0.1 V
10 mV

⇒ An interrupt in which the external device supplies its address as well as the interrupt is known as
vectored interrupt
maskable interrupt
polled interrupt
non-maskable interrupt

⇒ Nichrome is used for
overload line wires
heater coils
lamp filaments
all of the above

⇒ The circuit of figur
clipper, sine wave clipped at - 2 V
clamper
clamper, sine wave clamped at zero V
clipper, sine wave clipped at + 2 V

⇒ The given figure shows three Nyquist plots of G(s) H(s) = e^-sT/[s(s + 1)] for different values of T. The curves 1, 2, 3 ca
for T = 0, 0.5 and 1 respectively
for T = 1, 0.5 and 0 respectively
for T = 0.5, 1 and 0 respectively
for T = 0, 1 and 0.5 respectively

⇒ End fire coupler is formed
when two equal radiators are operated in phase quadrature at a distance of λ/4 apart
when two equal radiators are operated in parallel at a distance of λ/4 apart
when two equal radiators are operated in phase quadrature at a distance of λ/2 apart
none of the above

⇒ The function shown in figure, can represent a probability density function for A ________
A = 1/4
A = 1/6
A = 1/8
A = 1/2

⇒ In figure the total inductance of the circui
L₁ + L₂
L₁ + L₂ - M
L₁ + L₂ - 2M
L₁ + L₂ + M

⇒ The equivalent form of the logical expression ABC + A BC + ABC + ABC + AB C is
C + (A ⊕ B)
(A + B + C)(A + B + C)
(A + B + C)(A + B + C)(A + B + C)
(A + B + C)(A + B + C)(A + B + C)

⇒ For a resistance of about 15 kΩ operating in a frequency range of a few MHz, the noise voltage is in the range of
a few μV
about 100 μV
a few μV
a few volts

⇒ A minimum function has
poles and zeros on imaginary axis of s plane
no poles or zeros on imaginary axis of s plane
only poles but no zeros on imaginary axis of s plane
only zeros but no poles on imaginary axis of s plane

⇒ A periodic rectangular signal, x(t) has the waveform shown in the given figure. Frequency of the fifth harmonic of its spectrum is _______
200 Hz
250 Hz
400 Hz
1250 Hz

⇒ The integral of a unit impulse is unit step function.
TRUE
FALSE

⇒ Troposphere is the upper part of the Earth's atmosphere which absorbs large quantities of Sun's radiations.
TRUE
FALSE

⇒ The digit F in hexadecimal system is equivalent to number __________ in decimal system.
16
15
17
8

⇒ Consider the following features:

negative operands cannot be used
when immediate operand changes, the program should be reassembled
the program is difficult to read
the size of operand is restricted by word length of the computer

Disadvantages of immediate addressing include
1 and 2
2 and 4
2 and 3
1 and 4

⇒ If the valence electron is separated from a copper atom, the remaining part of atom has a net charge of
1
-1
0
3

⇒ For a type 0 system and unit ramp input, the steady state error is
0
∞
1
1/K_V

⇒ Value of 'K' for the system for which the system is stab
K < 1
K > 1
K < 2
K > 2

⇒ The 8085 microprocessor is interrupted while executing MOV instruction at location 0210 H. What is the location at which contents of register E are stored.
054 CH
054 DH
054 EH
054 FH