Question is ⇒ Which of the following may result in instability problem?, Options are ⇒ (A) Large error, (B) High selectivity, (C) High gain, (D) Noise, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following may result in instability problem?, Options are ⇒ (A) Large error, (B) High selectivity, (C) High gain, (D) Noise, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following may result in instability problem?
A.	Large error [Wrong Answer]
B.	High selectivity [Wrong Answer]
C.	High gain [Correct Answer]
D.	Noise [Wrong Answer]
View Answer 2 -6 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 180° mode of operation of a 3 phase bridge inverter, two thyristors conduct at one time.
TRUE
FALSE

⇒ Find L_eq if each L is
4/3 H
1/3 H
2/3 H
3/2 D

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the speed is 1440 rpm. At 25 Hz, the speed is likely to be
about 1350 rpm
about 720 rpm
about 360 rpm
either (b) or (c)

⇒ In order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instructions are needed?
El only
SIM only
El and SIM only
None

⇒ In a waveguide if TE mode exist for z direction propagation, then
E_z = 0, H_z ≠ 0
E_z = 0, H_z = 0
E_z ≠ 0, H_z = 0
E_z ≠ 0, H_z ≠ 0

⇒ In tape recorders the hissing noise is due to irregularities in magnetic coating on tape.
TRUE
FALSE

⇒ If a sample of germanium and a sample of Si have the impurity density and are kept at room temperature then
both will have equal value of resistivity
both will have equal -ve resistivity
resistivity of germanium will be higher than that of silicon
resistivity of Si will be higher than of germanium

⇒ Which of the following circuits can operate class AB for audio power output?
Emitter follower
Push pull
Cascade
Darlington pair

⇒ In a class C operation V_CC = 30 V and V_CE(sat) = 2 V. The efficiency is
0.9375
0.88
0.0666
0.0333

⇒ The factor η for a UJT is about
0.1
0.2
0.6
0.9

⇒ In Bode diagram (log magnitude plot) of the factor 1/(1 + jωT) in the transfer function the log magnitude for ω << 1/T can be approximated by
0 dB
20 log ωT dB
-20 log ωT dB
none of the above

⇒ In 8085 microprocessor system, can an input and output port have same port address?
Yes
No
Insufficient data
None of these

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_CQ will be
910 mA
5 mA
5.25 mA
4.95 mA

⇒ An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis
will be a capacitor
may be R or C
will be R
will depend on the behaviour of function at s = ∞

⇒ In PCM, the quantization noise depends on
sampling rate
signal power
number of quantization level
signal energy

⇒

Assertion (A): Two terminal black boxes of R and C can be identified by plotting their static V-I characteristics.

Reason (R): The V-I characteristic of resistance is a straight line of slope R passing through origin.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a Vidicon camera tube,
both sides of the target plate have the coating of tin oxide
both sides of the target plate have the coating of antimony tri-sulphide
the side of target plate facing the light has a coating of tin oxide and the side facing electron gun has a coating of antimony trisulphide
the side of target plate facing the light has a coating of antimony trisulphide while the side facing the electron gun has a coating of tin oxide

⇒ Which of the following is not a valid variable in FORTRAN 77?
BRG
VS
VS 3A
3 VSA

⇒ The resistance of a photoconductor
increases with increase in light intensity
decreases with increase in light intensity
may increase or decrease with increase in light intensity
remains constant

⇒ The contents of stack location 2109 H after the call operation wil
1111
1010101
100000
100010

⇒ In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected
across the supply
across the resistance
either in two positions
preferably across the supply

⇒ Suppose a microprocessor has memory locations from 0000 to 3FFF, each storing I byte. How many bytes the memory can storing I bytes the memory can store?
4384
8644
12688
16384

⇒ A system is highly oscillatory if
gain margin is high
gain margin is close to 1
gain margin is close to 1 or phase margin is zero
gain margin is high and phase margin is 180°

⇒ The scale factor for half wave and full wave rectifier is __________ respectively.
1.11, 1.414
1.11, 1.57
1.57, 1.11
1.414, 1.11

⇒ Input and output impedance with feedback for voltage series feedback having A = -200, R₁ = 10 kΩ, R₀ = 50 kΩ and feedback factor β = -0.2 will be
410 kΩ, 2050 kΩ
410 kΩ, 1.219 kΩ
≈ 0.243 kΩ, 2050 kΩ
≈ 0.24 kΩ, 1.219 kΩ

⇒ The most commonly used microphone for public address systems is
carbon
crystal
moving coil
condenser

⇒ One T state is precisely equal to one clock period.
TRUE
FALSE

⇒ In broadcast television, the number of lines per frame is chosen to be odd number to
reduce the required bandwidth
improve resolution
reduce peak power requirement
make interlacing easier

⇒ The equivalent T circuit of this coupled network is shown in figure. Find the values of Z_A, Z_B and Z_{C-j, 6j, 2j
-j, 2j, 6j
j, 2j, - 6j
j, 2j, 6j}

⇒ For the logic circuit shown in figure, the simplified Boolean expression for the output
A + B + C
AB
B
C