Question is ⇒ Which of the following is the main difference between waveguide and transmission line?, Options are ⇒ (A) Waveguides cannot be coupled to coaxial lines, (B) Waveguides have no standing wave ratio, (C) Transmission line does not suffer from the effect of low cut off frequency, (D) Waveguides are not distributed like transmission lines, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is the main difference between waveguide and transmission line?, Options are ⇒ (A) Waveguides cannot be coupled to coaxial lines, (B) Waveguides have no standing wave ratio, (C) Transmission line does not suffer from the effect of low cut off frequency, (D) Waveguides are not distributed like transmission lines, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is the main difference between waveguide and transmission line?
A.	Waveguides cannot be coupled to coaxial lines [Wrong Answer]
B.	Waveguides have no standing wave ratio [Wrong Answer]
C.	Transmission line does not suffer from the effect of low cut off frequency [Correct Answer]
D.	Waveguides are not distributed like transmission lines [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If an inverter is placed at the input to an SR flip-flop, the result is
T flip-flop
D flip-flop
JK flip-flop
BCD decade counter

⇒ Which of the following alphanumeric characters is not allowed in Basic?
capital letters A to Z
lower case letters a to z
digits 0 to 9
special characters +, -, *, / etc

⇒ Symbol shown in figure represen
Enhancement only N-channel MOSFET
UJT with p-type base
N-channel DMOSFET with internal protection
Phototransistor

⇒ Open-circuit voltage is the potential difference between two point when the impedance between these points is
zero
infinity
capacitive
reactive

⇒ A cycloconverter for single phase operation has
one positive group and one negative group converters
two positive group and two negative group converters
three positive group and three negative group converters
any of the above

⇒ If number of information bits is 11, the number of parity bits in Hamming code is
5
4
3
2

⇒ In a purely capacitive circuit, the current __________ the voltage by __________ .
lags, 0°
leads, 90°
lags, 90°
lags, 45°

⇒ The total insulation resistance consists of insulation volume resistance and surface leakage resistance.
TRUE
FALSE

⇒ The circuit shown below is the equivalent circuit of which one of the following microwave resonator ty
Butterfly resonator
Parallel-wire resonator
Cavity resonator
Coaxial line resonator

⇒ What is the direction of control
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into μp an some others out of μp

⇒ Secondary emission results
when temperature of metals is raised to a level above the crystallization temperature
when metals are subjected to strong magnetic fields
when light rays fall on the metal surface
when a high velocity beam of electrons strikes as metal surface

⇒ The conduction band is
same as forbidden energy gap
generally located on the top of the crystal
generally located on the bottom of the crystal
a range of energies corresponding to the energies of the free electrons

⇒ The box on the external left of the title bar of menu is called control menu box.
TRUE
FALSE

⇒

Match the following:

	List I (Instruction)		List II (Flag's getting affected)
A.	ORI	1.	CY reset
B.	DAA	2.	CY reset and AC reset
C.	PCHIL	3.	S, Z, AC, P, CY flags affected
		4.	S, S, P are modified
		5.	No flags affected

A-2, B-3, C-5
A-4, B-3, C-5
A-1, B-2, C-3
A-2, B-4, C-1

⇒ If a short line is terminated in characteristic impedance it behaves as an infinite line.
TRUE
FALSE

⇒ Which one of the following parameters does not exist for the two port network shown in the given fig
ABCD
y
h
z

⇒ For the system in the given figure, the gain margi
0
low
+ ∞
none of the above

⇒ The conductivity of germanium increases by about 6 percent per degree increase in temperature.
TRUE
FALSE

⇒ Compared to coaxial lines, the advantages of wave guides are
higher power handling capacity
lower loss per unit length
cheaper and simple mechanical structure
all of the above

⇒ When subjected to alternating stresses, an insulating material is characterised by complex dielectric constant ∈^'_r - j∈^"_r . In such materials, the dielectric losses under alternating stress is proportional
∈^"_r
both ∈^'_r and ∈^"_r
∈^'_r
(∈^"_r)²

⇒ For the power amplifier circuit shown below, the maximum power dissipated by both output transisto
9.66 W
30.11 W
31.66 W
33.66 W

⇒ Large scale integration refers to
more than 50 gates on the same chip
more than 80 gates on the same chip
more than 100 gates on the same chip
none of the above

⇒ A sphere with charge Q was placed in, but not touching a larger hollow sphere. If there is any charge initially on the outer sphere; to remove it the outer sphere was earthed momentarily, and then the inner sphere was removed. The charge remaining on the outer sphere was then measured. This charge was found to be __________ to the charge on the inner sphere.
equal and of same again
equal and of opposite sign
unequal and of same sign
unequal and of opposite sign

⇒ In a thyristor the gate current is increased, then
anode current will increase
anode current will decrease
anode current will remain constant
anode current may increase or decrease

⇒ Which statement is correct?
BJT and MOSFET are current controlled devices
BJT is voltage controlled and MOSFET is current controlled device
BJT and MOSFET are voltage controlled devices
BJT is current controlled and MOSFET is voltage controlled device

⇒ For full wave rectification four diode bridge rectifier is claimed to have following advantages:

Less expensive transformer
Small size transformer
Suitable for higher voltage applications

Which of these are correct?
1 and 2 only
1 and 3 only
2 and 2 only
1, 2, 3

⇒

Assertion (A): A dual converter may be circulating current type or non circulating current type.

Reason (R): In circulating current dual converter only one converter can be operated at one time.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis is
synchro control transformer
LVDT
stepper motor
tacho generator

⇒ Poor power factor
reduces load handling capability of electrical system
results in more power losses in the electrical system
overloads alternators, transformers and distribution lines
all

⇒ When a 1 V increase in gate voltage changes the drain current 10 mA in an FET, its g_m equals
10 μμ
100 μμ
1000 μμ
10000 μμ