Question is ⇒ Which of the following is 'synchronous'?, Options are ⇒ (A) Half adder, (B) Full adder, (C) R-S flip-flop, (D) Clocked R-S flip-flop, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is 'synchronous'?, Options are ⇒ (A) Half adder, (B) Full adder, (C) R-S flip-flop, (D) Clocked R-S flip-flop, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is 'synchronous'?
A.	Half adder [Wrong Answer]
B.	Full adder [Wrong Answer]
C.	R-S flip-flop [Wrong Answer]
D.	Clocked R-S flip-flop [Correct Answer]
View Answer 3 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Out of modes TE₂₀ and TE₃₀ of propagation of electromagnetic engery
both have the same cutoff frequency
TE₂₀ has lower cut off frequency as compared to TE₃₀
TE₃₀ has lower cutoff frequency as compared to TE₂₀
either (a) or (c)

⇒ The rate of change of excess carrier density is proportional to carrier density.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in band-width
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope over load error
C.	Finer quantization	3.	Nyquist rate of signals
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1

⇒ The signal define by the equations u(t - a) = 0 for t < a and u(t - a) = 1 for t ≥ a is
a unit step function
a shifted unit step function orginating at t = a
a pulse function
none of the above

⇒ Which of the following can be used for measuring capacitance?
De sauty bridge
Maxwell's bridge
Anderson bridge
Hay's bridge

⇒ The advantage of transistor over vacuum tube is
no heat is required
small size and light in weight
very low power consumption
all of the above

⇒ A Weston frequency meter is
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ When a unit step voltage drives a lag network the output
remains constant at unit step value
increases exponentially from zero to final value
decreases exponentially from 1 to 0
either (b) of (c) depending on values of R and C

⇒ Consider the following statements

Acceptor level lies close the valence band.
Donor level lies close to the valence band.
n type semiconductor behaves as an insulator at 0 K.
p type semiconductor behaves as an insulator at 0 K.

Of these statements:
2 and 3 are correct
1 and 3 are correct
1 and 4 are correct
3 and 4 are correct

⇒ The bandwidth of an amplifier can be reduced by
miller effect compensation
pole zero compensation
dominant pole compensation
lead compensation

⇒ Binary 1111 when added to binary 11111, the result in binary is
111111
1111
1000
10000

⇒ How many flag are there in 8085 microprocessor?
4
5
6
8

⇒

Assertion (A): In an RC coupled amplifier the junction capacitances can be neglected at low frequencies but not at high frequencies

Reason (R): Capacitive reactance is inversely proportional to frequency.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Two identical FETs each having parameters g_m and r_d are connected is parallel. The composite FET has parameters
0.5 g_m and 2 r_d
0.5 g_m and 0.5 r_d
2 g_m and 2 r_d
2 g_m and 0.5 r_d

⇒ SCR turns of from conducting state to blocking state on
reducing gate current
reversing gate voltage
reducing anode current below holding current value
applying ac to the gate

⇒ It f(t) is an odd function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒ The figure shown below is designed to act as a constant current source across the load resistor. The β of transistor is 50. What is the value of load curr
1.96 mA
2 mA
2.04 mA
None

⇒ The cut off wavelength λ_c for TE₂₀ mode for a standard rectangles waveguide is
2/a
2a
a
2a²

⇒

Assertion (A): Negative feedback reduces the bandwidth of an amplifier

Reason (R): Negative feedback stabilizes the gain of an amplifier

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which camera tube has highest dark current?
Plumbicon
Vidicon
Saticon
GCD imager

⇒ Which among the following waveforms can be reconstructed from its samples without distort
1 and 2
2 and 3
1 and 3
Only 2

⇒ Consider the following in C 4.2 and 300
4 and 300 respectively
4.2 and 300.00 respectively
4 and 300.00 respectively

⇒ Which has the highest power dissipation per gate?
ECL
TTL
CMOS
PMOS

⇒ Consider the following galvanometers

D'Arsonval
Ballistic
Vibration

Which of these are permanent magnet moving coil instruments?
1 and 2 only
1, 2 and 3
2 and 3 only
1 and 3 only

⇒ In figure, transistor β_dc = 100 and LED voltage when it is conducting is 2 V. Then the base current which saturates the transisto
18 mA
1.8 mA
0.18 mA
0.018 mA

⇒ Power gain of an antenna in a given direction is the ratio of
average power to maximum power
radiation intensity in that direction to the total input radiated power
radiation intensity in that direction to the average radiated power
none of the above

⇒

Assertion (A): In p type semiconductor conduction is mainly due to holes.

Reason (R): In p type material the holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ An inverting amplifier has R₁ = 10 kΩ, and R_f = 150 kΩ then the O/P voltage, if input voltage V_i = 1 volt.
-15 V
-10 V
15 V
-14 V

⇒ If f is the frequency of electromagnetic wave, f_c is cutoff frequency, then in a rectangular waveguide
attenuation is low when f > f_c
attenuation is low when f < f_c
attenuation is high when f < f_c
either (b) or (c)

⇒

Assertion (A): The resolution of a DAC depends on the number of bits

Reason (R): Low resolution leads to fine control.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true