Question is ⇒ Which of the following is not a valid variable name in C?, Options are ⇒ (A) p_ce1, (B) 1p_ce, (C) p1_ce, (D) p _ced, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is not a valid variable name in C?, Options are ⇒ (A) p_ce1, (B) 1p_ce, (C) p1_ce, (D) p _ced, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is not a valid variable name in C?
A.	p_ce1 [Wrong Answer]
B.	1p_ce [Correct Answer]
C.	p1_ce [Wrong Answer]
D.	p _ced [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The total bandwidth needed for an AM signal at 55.25 MHz with 0.5 MHz video modulation is
0.25 MHz
0.5 MHz
1 MHz
10 MHz

⇒ Which device uses Pneumatic fluid?
LED
LCD
VF display
None of these

⇒ In a R-L-C circuit at resonance is
maximum in series resonance and minimum in parallel resonance.
maximum in parallel resonance and minimum in series resonance
minimum in both series and parallel resonances
maximum in both series and parallel resonances.

⇒ Minimum number of J-K flip-flop needed to construct a BCD counter is
2
3
4
5

⇒ If there is phase error in the carrier signal for the detection of SSB signals, then
the output gets reduced, but a phase distortion results
the output is not reduced, but a phase distortion results
the output is not reduced, and also no distortion
the output is reduced, no phase distortion

⇒ Skin effect is more pronounced at high frequencies.
TRUE
FALSE

⇒ A class A transformer coupled power amplifier is to deliver 10 W output. The power rating of transistor should not be less than
5 W
10 W
20 W
40 W

⇒ Figure shows current pulses of a class C power amplifier. The fundamental frequency of these pulse
100 kHz
1000 kHz
10 kHz
1 kHz

⇒ The coding system generally used in digital telemetry is
PPM (Pulse position modulation)
PAM (Pulse amplitude modulation)
PCM (Pulse code modulation)
PDM (Pulse duration modulation)

⇒ A quarter wave line short circuited at load end behaves as
an inductance
an inductance and capacitance in series
a capacitance
an inductance and capacitance in parallel

⇒ An air gap provided in the iron core of an inductor prevents
flux leakage
hysteresis loss
core saturation
heat generation

⇒ A single element strain gauge bridge has two fixed resistances R₁ and R₁ of 120 Ω each and a variable resistance which gives full deflection at 120 Ω for zero strain and 120.6 Ω for straine e. If gauge factor is 2, strain e is
0.0025
0.0035
0.005
0.0075

⇒ Start and stop bit do not contain any information but are used in serial communication for
error correction
error detection
synchronization
slowing down the communication

⇒ In 8085, the pins for SID and SOD are
4 and 5 respectively
5 and 4 respectively
3 and 4 respectively
4 and 3 respectively

⇒

Assertion (A): Alkali metals are used as emitters in phototubes.

Reason (R): Alkali metals have low work functions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Resistivity of metals is expressed in terms of
μ ohm
μ ohm/cm
μ ohm-cm
μ ohm-cm/°C

⇒ Foster Seeley discriminator uses a
double tuned circuit in which primary and secondary are tuned to different frequencies
double tuned circuit in which primary and secondary are tuned to same frequencies
single tuned circuit
three triodes in series

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40
4.878
1.212

⇒ In RLC circuits the state variables generally selected are
voltages across capacitors
currents through resistances and voltages across capacitors
currents through resistances and capacitances
currents through inductances and voltages across capacitances

⇒

Match the following:

	List I		List II
A.	h_ie	1.	49
B.	h_re	2.	25 x 10^-6siemens
C.	h_fe	3.	2.4 x 10^-4
D.	h_oe	4.	1000 ohms

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-4, B-3, C-1, D-2

⇒ The unit of permeability is
T
Wb
H/M
H

⇒

Assertion (A): If power gain doubles the power gain increases by 3 dB

Reason (R): The bel power gain of cascaded stages is equal to sum of each bel power gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Find E at P(1, 1, 1) caused by four identical 3 nC point charges located at P₁(1, 1, 0), P₂(- 1, 1, 0), P₃(- 1, - 1, 0) P₄(1, - 1, 0)
21.58a_x + 21.58a_y + 12a_z V/m
6.82a_x + 6.82a_y + 32.89a_z V/m
-6.82a_x - 6.82a_y - 32.89a_z V/m
-21.58a_x - 21.58a_y - 12az V/m

⇒ Which of the following memory is preferred in case of calculators?
Dynamic RAM
Dynamic ROM
Static ROM
Static RAM

⇒ An amplitude modulated signal occupies a frequency range from 395 kHz to 405 kHz. If can be demodulated by which of the following?
Using an envelope detector and filter
Multiplying with a 395 kHz local signal
Multiplying with a 405 kHz local signal
Low pass filtering with cut off at 400 kHz

⇒ The response to sinusoidal excitation can be found by
setting s = jω in the network function
setting s = -jω in the network function
taking inverse transform of network function
none of the above

⇒ Binary 1000 will be the result of which of the following?
Binary 1000 - 100
Binary 1011 - 1111
Binary 1111 - 111
Binary 11111 - 1111

⇒ To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to use
surge resistor
surge inductor
surge capacitor
both (a) and (b)

⇒ Fourier transform F(jω) of an arbitrary signal has the property
F(jω) = F(- jω)
F(jω) = - F(- jω)
F(jω) = F*(- jω)
F(jω) = - F*(jω)

⇒ Dual slope ADC uses an op amp comparator.
TRUE
FALSE