Question is ⇒ Which of the following is not a proper FORTRAN expression?, Options are ⇒ (A) B + A / C - D, (B) (A + C) / (B + D), (C) B + * A / C, (D) A ** (B + 2), (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is not a proper FORTRAN expression?, Options are ⇒ (A) B + A / C - D, (B) (A + C) / (B + D), (C) B + * A / C, (D) A ** (B + 2), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is not a proper FORTRAN expression?
A.	B + A / C - D [Wrong Answer]
B.	(A + C) / (B + D) [Wrong Answer]
C.	B + * A / C [Correct Answer]
D.	A ** (B + 2) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The early effect in BJT is caused by
fast turn on
fast turn off
large collector base reverse bias
large emitter base forward bias

⇒ In a two stage CE amplifier circuit, the ac collector resistance of the first stage depends on
load resistance
input impedance of first stage
input impedance of second stage
all of the above

⇒

Assertion (A): If power gain doubles the power gain increases by 3 dB

Reason (R): The bel power gain of cascaded stages is equal to sum of each bel power gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In cell communication
carrier frequency change
carrier frequency constant
depend upon location
depend upon geographical area

⇒ Non-coherently detection is not possible for
PSK
ASK
FSK
both (a) and (c)

⇒ The DTFT of x(n) = δ(n) will be
1
0
∞
not defined

⇒ In low pass filter of figure R₀ = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C
1 H and 2 F
1 H and 1 F
2 H and 1 F
1 H and 2 F

⇒ Which 8085 instruction causes exchange of contents of stack pointer with the contents of H L register pair?
XTHL
PCHL
LHLD
MVIA

⇒ In a PCM the amplitude levels are transmitted in a 7 unit code. The no. of levels is
18
14
128
64

⇒ Which of the following is an oscillator with best frequency stability?
Crystal oscillator
Clapp oscillator
Phase shift circuit
Multivibrator

⇒ Piezoelectric effect can be used to measure
force
strain
acceleration
all of the above

⇒ Sound wave travels as
longitudinal waves
transverse waves
both longitudinal and transverse waves
either longitudinal or transverse wave

⇒ h parameters are used in transistor analysis.
TRUE
FALSE

⇒ The MOS symbols shown indica
1, 3, 6
2, 4, 6
1, 3, 5
2, 3, 6

⇒ With an ac input from 50 Hz power line, the ripple frequency is
50 Hz in the dc output of half wave as well as full wave rectifier
100 Hz in the dc output of half wave as well as full wave rectifier
50 Hz in the dc output of half wave and 100 Hz in the dc output of full wave
100 Hz in the dc output of half wave and 50 Hz in the dc output of full wave

⇒ A cascade amplifier stage is equivalent to
a common emitter stage followed by a common stage
a common base stage followed by an emitter follower
an emitter follower stage followed by a common base stage
a common base stage followed by a common emitter stage

⇒

Assertion (A): Stubs, directional couplers and baluns are very commonly used in communication systems

Reason (R): Characteristic impedance of a line is an important parameter.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a synchro error detector, the output voltage is proportional to [ω(t)]ⁿ, where ω(t) is the rotor velocity and n equals :
-2
-1
1
2

⇒ Skin effect is more pronounced at high frequencies.
TRUE
FALSE

⇒ The action of bellows is similar to that of
mass
viscous friction
spring
none of the above

⇒ Some possible functions of AGC in a TV receiver are

To increase gain for weak signals
To decrease gain for strong signals
To change the contrast when we switch from one channel to other
To reduce flutter

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2, 3
2, 3, 4

⇒ For a base current of 10 μA, what is the value of collector current in common emitter if β_dc = 100
10 μA
100 μA
1 mA
10 mA

⇒ The currents fed to the two dipoles of turnstile antenna are
in phase
in quadrature
in phase opposition
either (a) or (c)

⇒

Assertion (A): In an op-amp the gain bandwidth product equals f_finity

Reason (R): The change in open loop gain of an amplifier has almost no effect on closed loop gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a BCD to 7 segment decoder the minimum and maximum number of outputs active at any time is
2 and 7
3 and 7
1 and 6
3 and 6

⇒ The ratio of the diffusion coefficient in a semiconductor has the units
V^-1
em.V^-1
V.cm^-1
V.s

⇒ If a number of even functions are added, the resultant sum is
even function
odd funtion
either even or odd function
mixture of odd amd even functions

⇒ A 3 phase induction motor is fed by a 3 phase ac regulator to change the stator voltage. The variation in speed will be more if
load torque is constant
load torque increases with increase in speed
load torque decreases with increase in speed
either (a) or (b)

⇒ The Boolean function/implemented in the figure using two I/P multiplexer
ABC + ABC
ABC + AB C
ABC + ABC
ABC + AB C

⇒ Brewster angle is the angle for which there is
no reflection and the incident wave is vertically polarized
reflection and the incident wave is horizontally polarized
no reflection and the incident wave is horizontally polarized
none of the above