Question is ⇒ Which of the following is known as insulated gate FET?, Options are ⇒ (A) JFET, (B) MOSFET, (C) Both JFET and MOSFET, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is known as insulated gate FET?, Options are ⇒ (A) JFET, (B) MOSFET, (C) Both JFET and MOSFET, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is known as insulated gate FET?
A.	JFET [Wrong Answer]
B.	MOSFET [Correct Answer]
C.	Both JFET and MOSFET [Wrong Answer]
D.	None of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A voltage v(t) which is a gaussian ergodic random process witha mean of zero and a varance of 4 volt² is measured by a meter which first square and then reads its dc component. The reading will be
0
4
16
2

⇒ 2N 2430 could be a
semi-conductor diode
dual gate MOSFET
BJT
UJT

⇒ In figure the approximate voltage
base and emitter are - 8 V and - 7.3 V
base and collector are - 8 V and - 5 V
collector and emitter are - 5 V and - 7.3 V
base, emitter and collector are - 8, - 7.3 and - 5 V

⇒ The combination of registers in 8085 is B-C, D-E, H-L only.
TRUE
FALSE

⇒ If V_r is the reverse voltage across a graded P-N Junction, then the junction capacitance c_j is proportional to
(V_r)²
(V_r)ⁿ
(V_r)^-n
(V_r)^3/2

⇒ The percentage saving in power when the carrier and one of the sidebands are suppressed in an AM wave modulated to a depth of 100% will be nearly
0.5
0.66
0.75
0.83

⇒ If t_p is the pulse width, Δ_t is the propagation delay, T is period of pulse train then the following condition can avoid the race around condition
t_p = Δt = T
2t_p > Δt > T
t_p < Δt < T
t_p < Δt < T

⇒ If i = 10 + 12 cos 500t - 3.5 sin 500 t, then in amplitude phasse form i =
10 + 12.5 sin (500 t + 106.20°)
5 + 12.5 sin (500 t + 106.20°)
10 + 11 sin (500 t + 106.20°)
10 + 12.5 sin (500 t + 10°)

⇒ Which of the following quantities have same dimension in emu and esu?

Current
Electrical power
Electrical energy

Select the answer as per following codes
1 only
1 and 2
2 and 3
1 and 3

⇒ In a practical current source, the load current
is always equal to source current
is always less than source current
is always equal to or less than source current
cannot be higher than source current

⇒ How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?
3 dB
4 dB
5 dB
6 dB

⇒ In a AM wave the carrier and one of the side bands is suppressed. If m = 0.5, the percentage saving in power is
0.5
0.833
0.944
1

⇒ In cell communication
carrier frequency change
carrier frequency constant
depend upon location
depend upon geographical area

⇒ Tuned voltage amplifiers are not used
in public address systems
in radio receivers
in television receivers for sound signals
in television receivers for video signals

⇒ In figure, transistor β_dc = 100 and LED voltage when it is conducting is 2 V. Then the base current which saturates the transisto
18 mA
1.8 mA
0.18 mA
0.018 mA

⇒ The Boolean expression for the shaded area in the Venn diagra
X + Y + Z
XY + Z + X YZ
X Y Z + XY
X + Y + Z

⇒ For an RC impedance function Z
Z(∞) = Z(0)
Z(∞) < Z(0)
Z(∞) ≤ Z(0)
Z(∞) > Z(0)

⇒ In a forward biased p-n junction current enters p material as hole current and leaves n material as electron current of the same magnitude.
TRUE
FALSE

⇒ The disadvantage of FM over AM is that
high output power is needed
high modulating power is needed
noise is very high for high frequency
large bandwidth is required

⇒ If x^k = a^k and k &g
TRUE
FALSE

⇒ In figure the output v(t)
phase modulated signal
amplitude modulated signal
frequency modulated signal
none of the above

⇒ When avalanche breakdown occurs covalent bonds are not affected.
TRUE
FALSE

⇒ Figure shows the V-i characteristics of a material. The material is likely t
copper
carbon
zinc oxide
rubber

⇒ When a transistor is connected in common emitter mode, it with have
negligible input resistance and high output resistance
high input resistance and low output resistance
medium input resistance and high output resistance
low input resistance as well as output resistance

⇒ Which of the following instructions have only one operand?
Multiply
Add
Shift
Subtract

⇒ A Q meter uses the principle of
variation of self inductance
variation of mutual inductance
series resonance
none of the above

⇒ Earth's curvature affects the effective height of antenna.
TRUE
FALSE

⇒ The number of possible colours with a 4 line digital input monitor are
4
16
64
2

⇒ Polystyrene has a relative permittivity of 2.7. If the wave is incident at an angle θ_i of 30° from air into polystyrene, the angle of transmission will be nearly
0.2°
2°
18°
48°

⇒ The primary reason for the widespread use of Si in semiconductor device technology is
abundance of Si on the surface of earth
larger band gap of Si in comparison to Ge
favourable properties of Silicon-dioxide (SiO₂)
lower melting point