Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Which of the following is incorrect? |

A. | (8)_{16} = (8)_{8} [Correct Answer] |

B. | (5)_{16} = (5)_{8} [Wrong Answer] |

C. | (8)_{2} = (2)_{10} [Wrong Answer] |

D. | (2)_{16} = (2)_{10} [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The system of linear equations 4x + 2y = 1 , 2x + y = 6 has

a unique solution

no solution

an infinite number of solutions

exactly two distinct solutions

⇒ A thyristor has a maximum allowable junction temperature of 120°C and the ambient temperature is 40°C. If thermal resistance is 1.6° C/W, the maximum allowable internal power dissipation is

20 W

50 W

92 W

128 W

⇒ The Thevenin's equivalent of network in figure(1) is a 10 V source in series with 2 Ω resistance. If a 3 Ω resistance is connected across AB as shown in figure(2) the Thevenin's equivalen

10 V in series with 1.2 Ω resistance

6 V in series with 1.2 Ω resistance

10 V in series with 5 Ω resistance

6 V in series with 5 Ω resistance

⇒

**Assertion (A):** The circuit of figure thyristor will conduct for 180° during positive half cycle if it is continuously fir

Both A and R are correct and R is correct explanation of A

Both A and R correct but R is not correct explanation of A

A is correct but R is wrong

A is wrong but R is correct

⇒ An RC series circuit has R = 20 Ω and X_{C} = 20 Ω. Then Z =

40 Ω

28.28 Ω

20 Ω

1 Ω

⇒

List I | List II | ||
---|---|---|---|

A. | RF amplifier | 1. | Amplifier received carrier and sidebands |

B. | Loudspeaker | 2. | Gives acoustic output |

C. | Demodulator | 3. | Has IF input and AF output |

D. | IF amplifier | 4. | Fixed-tuned to intermediate frequency |

A-1, B-2, C-3, D-4

A-2, B-1, C-3, D-4

A-3, B-4, C-1, D-2

A-1, B-4, C-3, D-2

⇒ Top loading in an antenna increases

effective height

beam width

input capacitance

bandwidth

⇒ Which of the following is not a valid real constant?

-73.1

10251,3

10.23

-5.7381

⇒ Voltage 1 + 2 sin ω

*t*is applied to the circuit shown be

0 volt

2 volts

-2 volts

-3 volts

⇒ Examine the following statements

- Pneumatic systems are fire proof.
- Pneumatic systems are explosion proof.
- Hydraulic systems are explosion proof.
- Hydraulic systems are fire proof.

1 only

1 and 2 only

1 2, 3, 4

2, 3, 4 only

⇒

**Assertion (A):** The hybrid p model of a transistor can be reduced to *h* parameter model and vice versa.

**Reason (R):** Hybrid p and *h* parameter models are interrelated as both of them describe the same device.

Both A and R are true and R is correct explanation of A

Both A and R are true but R is not a correct explanation of A

A is true but R is false

A is false but R is true

⇒ The reactance of coupling capacitor for AC signals in an amplifier, should be

as low as possible

as high as possible

neither low nor high

either low or high

⇒ In a circular waveguide TE

_{21}mode has lowest cutoff frequency

TRUE

FALSE

⇒ If a two port network is represented by an equivalent T network the admittance of series arm in term of ABCD parameter is equal to

C

1/C

(A - 1)/B

1/B

⇒

Match the following:

List I (Characteristic equation) | List II (Degree of damping) | ||
---|---|---|---|

A. | s^{2} + 15s + 56.25 | 1. | Undamped |

B. | s^{2} + 5s + 6 | 2. | Underdamped |

C. | s^{2} + 20.25 | 3. | Critically damped |

D. | s^{2} + 4.55s + 42.25 | 4. | Overdamped |

A-1, B-2, C-3, D-4

A-2, B-3, C-1, D-4

A-3, B-4, C-1, D-2

A-1, B-2, C-4, D-3

⇒ When a

*p*-

*n*junction is forward biased, the current remains zero till the applied voltage overcomes the barrier potential.

TRUE

FALSE

⇒ The effect of source inductance in a 3 phase fully controlled bridge converter is to

decrease the output voltage

increase the output voltage

decrease the output voltage and increase the output current

increase the output voltage and decrease the output current

⇒ For the truth table of the given figure

A + B + C

A + BC

A

B

⇒ The reverse saturation current of a diode does not depend on temperature.

TRUE

FALSE

⇒ The voltage and current distributions on a grounded λ/4 dipole (Marconi antenna) are similar to those of a half wave dipole in space.

TRUE

FALSE

⇒ For the BJT shown in figure, β = 50, the value of V

_{CE}

3.13 V

4.24 V

5.18 V

none

⇒ In measurements using strain gauge, the dummy strain gauge is used to

compensate for resistance of strain gauge

compensate for change in temperature

compensate for error due to change in voltage of battery

compensate for error in voltmeter

⇒ In a JFET, the drain current is maximum when

V

_{GS}= 0

V

_{GS}is not zero but is slightly negative

V

_{GS}is negative

V

_{GS}is negative and equal to V

_{DS}

⇒ An ac network has a power factor of 0.8 leading if the applied wave is of fundamental frequency. If the applied wave contains third and fifth harmonics, the overall power factor will be

0.8 leading

less than 0.8 leading

more than 0.8 leading

0.8 leading or more

⇒ Frequency domain of a periodic triangular function is a

discrete sinc function

continuous sampling function

discrete sampling function

continuous sampling square function

⇒ The relative permeability of an iron specimen is 400 when B = 0.2 T. If B = 0.4 T, μ

_{r}will be

400

less than 400

more than 400

more or less than 400

⇒ For a FM wave carrier modulating frequency is 10 kHz and bandwidth is 2 MHz. If the modulating signal amplitude is doubled, the bandwidth will be

0.5 MHz

1 MHz

2 MHz

4 MHz

⇒ An RC coupled amplifier has an open loop gain of 200 and a lower cutoff frequency of 50 Hz. If negative feedback with β = 0.1 is used, the lower cut off frequency will be

about 50 Hz

about 5 Hz

about 2.38 Hz

about 70.5 Hz

⇒ A class B chopper operates in third quadrant.

TRUE

FALSE

⇒ The bandwidth of DSB suppressed carrier modulation system when the modulating frequency varies between 500 Hz and 5 kHz is

555 kHz

505 kHz

500 kHz

9 kHz