Question is ⇒ Which of the following is incorrect?, Options are ⇒ (A) (111)2 + (10)2 = 9, (B) (111)2 + (2)10 = (9)16, (C) 7 + 2 = (1001)2, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is incorrect?, Options are ⇒ (A) (111)2 + (10)2 = 9, (B) (111)2 + (2)10 = (9)16, (C) 7 + 2 = (1001)2, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is incorrect?
A.	(111)₂ + (10)₂ = 9 [Wrong Answer]
B.	(111)₂ + (2)₁₀ = (9)₁₆ [Wrong Answer]
C.	7 + 2 = (1001)₂ [Wrong Answer]
D.	None of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Find current flowing through 1 H inductor at t = 0, at which switch 'S' is ope
0
2
3
5

⇒ The mass of proton and electron are
1.672 x 10^-26 kg and 9.107 x 10^-31 kg respectively
9.107 x 10^-26 kg and 9.107 x 10^-31 kg respectively
9.107 x 10^-29 kg and 9.107 x 10^-31 kg respectively
9.107 x 10^-30 kg and 9.107 x 10^-31 kg respectively

⇒ Antiferromagnetic materials do not have permanent dipoles.
TRUE
FALSE

⇒ The unit of thermal resistance of a semi-conductor device is
Ohms
Ohms/°C
°C/ohm
°C/watt

⇒ Which of the following is a valid real constant in FORTRAN 77?
1.2 E 231
3 E - 2
-3.2 E 2.3
1.2 E 23

⇒ In the circuit of figur
I₁ will always lag I₃
I₂ may be in phase or lag I₃
I₃ will always lag I₂
I₂ and I₃ will be in phase

⇒ A rectangular pulse train s(t) is shown in figure is convolved with the signal cos²(4p x 10³t). The convolved signal will
DC
12 kHZ sinusoidal
8 kHZ sinusoidal
14 kHZ sinusoidal

⇒ Which of the following number specification refers to FET with one gate?
2N
3N
3Y
3X

⇒ A discrete random variable X takes values from 1 to 5 with probabilities as shown in the table. A student calculates the mean of X and 3.5 and her teacher calculates the variance of X as 1.5. Which of the following statements is t
Both the student and the teacher are right
Both the student and the teacher are wrong
Both the student is wrong but the teacher is right
The student is right but the teacher is wrong

⇒

Assertion (A): If integral control action is included in the controller the offset can be eliminated.

Reason (R): Integral control action may lead to oscillatory response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The Boolean expression (A + B) (A + C) (B + C) simplifies to
(A + B) C
(A + B) C
(A + B) C
none of these

⇒ The purpose of providing groundings rings with MOSFET is to
avoid any stray voltage at the gate that may destroy SiO₂ layer
protect against any descaling
ground all eddy currents
protect against any physical injury

⇒ Microwave links are typically 50 km apart
because of atmospheric attenuation
because of output tube power limitation
because of earth's curvature
to ensure that applied dc voltage is not excessive

⇒ Common emitter transistor has
high current and high voltage gain
low current gain and low voltage gain
high current gain and low voltage gain
low current and voltage gain

⇒ FM has poor efficiency than
AM
AM-SC
PAM
PCM

⇒ In a superheterodyne receiver with an IF of 450 kHz is tuned to a signal at 1200 kHz. The image frequency is
750 kHz
990 kHz
1650 kHz
2100 kHz

⇒ In a square law modulator, the carrier frequency should be __________ times than the highest modulating frequency.
1
2
4
3

⇒ In filter system of sideband suppression the advantage of using mechanical filter is
smaller size
good bandpass
good attenuation characteristics
all of the above

⇒ The Y plates of a CRO are excited by a voltage 2 sin 100 t and the X plates are not connected. The display would be
a vertical line
a horizontal line
sine wave
slant line

⇒ 'WRITE' is a
Word processor
Line editor
Text editor
Column editor

⇒ Two identical silicon diodes D₁ and D₂ are connected back to back shown in figure. The reverse saturation current I_s of each diode is 10^-8 amps and the breakdown voltage V_Br is 50 v. Evaluate the voltages V_D1 and V_D2 dropped across the diodes D₁ and D₂ assuming KT/q to be 25
4.983 V, 0.017 V
- 4.98 V, - 0.017 V
0.17 V, 4.983 V
- 0.017 V, - 4.98 V

⇒ The first pulse in a TV remote control is
start pulse
preliminary pulse
either start pulse or preliminary pulse
erase pulse

⇒ Primary advantage of a crystal oscillator is that
it can oscillate at any frequency
it gives a high O/P voltage
its frequency of oscillation remains almost constant
it operates on a very low dc supply voltage

⇒ The maximum forward current in case of signal diode is in the range of
1 A to 10 A
0.1 A to 1 A
few milli amperes
few nano amperes

⇒ In FM, as bandwidth increases
distortion increases
distortion decreases
distortion remains unaffected
all

⇒ The surface charge density on a conductor is 1.55 x 10^-9C/m². The conductor is immersed in water with ε = 78ε₀.The electric field will be __________ .
3 V/m
1.55 V/m
2 V/m
2.25 V/m

⇒ Choose the correct statement
The reflection coefficient (r) of a transmission line is greater than 1
r varies from 0 to ∞
r is less than or equal to 1
r varies from - ∞ to + ∞

⇒ To measure an unknown ac voltage by an ac potentiometer it is desirable that supply for the potentiometer is taken
from a battery
from a source which is not the same as unknown voltage
from the same source as the unknown voltage
either (a) or (b)

⇒ The characteristic impedance of coaxial cable is about
1000 ohm
500 ohm
250 ohm
75 ohm

⇒ When the number of quantising levels is 16 in PCM, the number of pulses in a code group will be
3
4
8
16