Question is ⇒ Which of the following is correct in FORTRAN 77?, Options are ⇒ (A) <code>PARAMETER PMOS = 9.8, NMOS = X</code>, (B) <code>PARAMETER (PMOS = 9.8, NMOS = X)</code>, (C) <code>PARAMETER PMOS = 9.8, NMOS = X</code>, (D) <code>PARAMETER PMOS, NMOS = 9.8, X</code>, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is correct in FORTRAN 77?, Options are ⇒ (A) <code>PARAMETER PMOS = 9.8, NMOS = X</code>, (B) <code>PARAMETER (PMOS = 9.8, NMOS = X)</code>, (C) <code>PARAMETER PMOS = 9.8, NMOS = X</code>, (D) <code>PARAMETER PMOS, NMOS = 9.8, X</code>, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is correct in FORTRAN 77?
A.	`PARAMETER PMOS = 9.8, NMOS = X` [Wrong Answer]
B.	`PARAMETER (PMOS = 9.8, NMOS = X)` [Correct Answer]
C.	`PARAMETER PMOS = 9.8, NMOS = X` [Wrong Answer]
D.	`PARAMETER PMOS, NMOS = 9.8, X` [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider a parallel plate capacitor being charged. Identify the incorrect statements
Energy stored in the capacitor does not enter it through the connecting wires but through the space around the wires and plates uf capacitor
Rate at which energy flows into this volume is equal to the integration of the Poynting vector over the boundary of the volume between the plates.
The Poynting vector points everywhere radially outward of the volume between the plates
The Poynting vector points everywhere radially into the volume between the plates.

⇒

Match the following:

	List I		List II
A.	R = 0	1.	Undamped oscillation
B.	R < 2 L/C	2.	Damped oscillation
C.	R = 2 L/C	3.	Critically damped response
D.	R > 2 L/C	4.	Non-oscillatory response.

A-1, B-2, C-3, D-4
A-1, B-4, C-3, D-2
A-3, B-2, C-1, D-4
A-3, B-4, C-1, D-2

⇒ The op-amp used in nonlinear mode is
integrators
active filters
Schmitt triggers
instrumentation amplifiers

⇒ Full duplex operation-permits transmission in both directions at the same time.
TRUE
FALSE

⇒ In 8085 the data is stored in the stack on
First in First Out basis
Last in First Out basis
First in Last Out basis
Last in Last Out basis

⇒ In the given figure the phase angle of Fn is either 0 or &
TRUE
FALSE

⇒ Consider the draw backs

Slope overload
Serration noise
Granular noise

Which of these draw backs does Delta modulation have?
1 and 2 only
2 and 3 only
1 and 3 only
1, 2, 3

⇒ In the circuit of figure the switch is closed at t = 0, At t = 0⁺ this current through inductanc
0
0.416666666666667
6.67 A
5.1 A

⇒ In a self bias circuit for CE amplifier, the base voltage is
equal to supply voltage
more than supply voltage
equal to or more than supply voltage
less than supply voltage

⇒

Match the following:

	List I		List II
A.	Zener diode	1.	used in seven segment display
B.	Tunnel diode	2.	used in voltage regulator circuits
C.	LED	3.	used is solar energy utilization
D.	Photovoltaic cell	4.	used in digital circuits

A-1, B-3, C-2, D-4
A-2, B-3, C-1, D-4
A-2, B-4, C-1, D-3
A-3, B-2, C-4, D-1

⇒ In what range should Re(s) remains so that Laplace transform of the function e^{(a + 2)t + 5} exists?
Re(s) > a + 2
Re(s) > a + 7
Re(s) < a
Re(s) > a + 5

⇒ Loading effect is primarily caused by instruments having
high resistance
high sensitivity
low sensitivity
high range

⇒ In an SCR, the anode current is controlled by
gate current only
external circuit only
both gate current and external circuit
none of the above

⇒ The transfer function V₂/V₁ for figure
a zero at origin
a zero at infinity
no zero
a zero at j1

⇒ A 14 pin AND gate IC has __________ AND gates.
8
6
4
2

⇒

Assertion (A): A class C amplifier can also be used as frequency multiplier

Reason (R): When narrow current pulses drive a resonant circuit the output can be a near perfect sine wave

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A 1 MHz sinusoidal carrier is amplitude modulated by a symmetrical square wave of period 100 μ sec. Which of the following frequencies will not be in the modulated signal?
990 kHz
1010 kHz
1020 kHz
1030 kHz

⇒ A₁₆ X 2₁₆ __________ .
16₁₆
15₁₆
14₁₆
13₁₆

⇒ If a two port network is represented by an equivalent T network, the impedance of shunt arm in terms of ABCD parameters is equal to
1/C
(A - 1)/C
1/B
(D - 1)/C

⇒ Radar reciever has high sensitivity and low noise figure
TRUE
FALSE

⇒ Analysis of EM wave in waveguide based on
circuit theory
field theory
optical theory
both (a) and (b)

⇒ A geostationary satellite
is located at a height of 358, 00 km
appears stationary over earth's magnetic pole
is motionless in space but keeps spinning
orbits the earth within a 24 hour period

⇒ In figure the output V₀
2V₁ + V₂ - 2V₃
2(V₁ + V₂) - V₃
V₁ + V₂ + V₃
V₁ + 2V₂ - V₃

⇒ The circuits with active pull up are preferred because of their stability for
wired - AND operation
wired - OR operation
bus operated system
reasonable dissipation and speed of operation

⇒ Choose the correct match for input resistance of various amplifier configurations shown below configurat
CB-LO, CC-MO, CE-HI
CB-LO, CC-HI, CE-MO
CB-MO, CC-HI, CE-LO
CB-HI, CC-LO, CE-MO

⇒ The scale of hot wire ammeter is
linear
non-linear
cramped
absolute linear

⇒ In a colour TV receiver SAW filter consists of
piezoelectric substrate on which are deposited two inter, digital transducers
photo conductive substrate which are deposited two inter digital transducers
photo voltaic substrate which are deposited two inter digital transducers
photo resistive substrate which are deposited two inter digital transducers

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
0
1
32, 767
65, 535

⇒ The main use of JFET with a
frequency mixer
source follower
voltage doubler
trigger

⇒ Some advantages of optical fibre cables are

small diameter
Immunity to cross talk and EM interference
Laser and LED modulation methods lend themselves ideally to digital operation

Which of the above are correct?
1 only
1 and 2
1, 2, 3
2, 3