Question is ⇒ Which of the following is anti-ferromagnetic material?, Options are ⇒ (A) CrSb, (B) NIO, (C) MnO, (D) All of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is anti-ferromagnetic material?, Options are ⇒ (A) CrSb, (B) NIO, (C) MnO, (D) All of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is anti-ferromagnetic material?
A.	CrSb [Wrong Answer]
B.	NIO [Wrong Answer]
C.	MnO [Wrong Answer]
D.	All of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The conductivity of germanium increases by about 6 percent per degree increase in temperature.
TRUE
FALSE

⇒ Which of the following is invalid in Basic?
A ** B + - C
A ** B - C
A * B - C
A * B - C ** D

⇒ In figure, power in 6 Ω resistor is zero then
202∠45°
20 ∠30°
20 ∠45°
202∠30°

⇒ What is the direction of address
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into up and some others out of μp

⇒ The electron and hole concentration in a intrinsic semiconductor are n_i and P_i respectively when doped with a P type material, these change to n and P, respectively. Then
n + P = n_i + P_i
n + n_i = P + P_i
nP_i = n_iP
n_P = n_i P_i

⇒ A 12 bit ADC is operating with 1 μs clock period. Total conversion time is 14 μs. ADC is
flash type
counting type
integrating type
successive approximation type

⇒ The slope of log-magnitude asymptote changes by - 40 dB/ decade at a frequency ω₁. This means that
a double pole is present
a pair of complex conjugate poles is present
either a double pole or a pair of complex conjugate poles is present
a pole or zero at origin is present

⇒ The most important set of specifications of transformer oil includes
dielectric strength and viscosity
dielectric strength and flash point
flash point and viscosity
dielectric strength, flash point and viscosity

⇒ For a BJT if β = 50, I_CEO = 3 μA and I_C = 1.2 mA then I_E
1 mA
1.2 mA
1.3 mA
1.4 mA

⇒ A parallel connection of circuit is at below resonance circuit behave as
RC circuit
RL
RLC
resistive only

⇒ Microwaves
get reflected by ionosphere
are absorbed by ionosphere
are neither reflected nor absorbed by ionosphere
are both reflected and absorbed by ionosphere

⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is
114 kW
336 kW
384 kW
455 kW

⇒ Which of the following statement about the photo electric emission is incorrect?
The maximum velocity of emission varies with the frequency of incident light
The maximum velocity of emission varies with the intensity of light
The amount of photoelectric emission is directly proportional to the intensity of light
The quantum yield depends on the frequency and not the intensity of incident light

⇒ Given a power supply filter circuit, what measurements must be made of determine percentage regulation
current through and voltage across the capacitor
d.c. load voltage and r.m.s. load voltage
current through load and voltage across load resistance
number of turns and gauge of secondary winding of transformer

⇒ The circuit shown in the figure, with R = 1/3 Ω, L = 1/4H, C = 3F has input voltage v(t) = sin2t. The resulting current i(t
5 sin (2t + 53.1°)
5 sin (2t - 53.1°)
25 sin (2t + 53.1°)
25 sin (2t - 53.1°)

⇒ In a transistor operating in forward active mode
depletion layer between emitter and base is thin and that between base and collector is also thin
both depletion regions are thick
depletion layer between emitter and base is thin and that between base and collector is thick
depletion layer between emitter and base is thick and that between base and collector is thin

⇒ An A/D converter uses for reference purposes
DC voltage
a saw tooth generator
set of keys
a flip-flop

⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ .
decreases, decreases
decreases, increases
increases, decreases
increases, increases

⇒ SSI refers to ICs with
less than 12 gates on the same chip
less than 8 gates on the same chip
less than 6 gates on the same chip
less than 3 gates on the same chip

⇒ In measurements using strain gauge, the dummy strain gauge is used to
compensate for resistance of strain gauge
compensate for change in temperature
compensate for error due to change in voltage of battery
compensate for error in voltmeter

⇒

Match the following:

	List I		List II
A.	45	1.	10110100
B.	90	2.	11010010
C.	180	3.	01011010
D.	210	4.	00101101
		5.	10101000

A-3, B-4, C-5, D-2
A-4, B-3, C-5, D-2
A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1

⇒ In the generic microprocessor
instruction cycle time period is shorter than machine cycle time period
machine cycle time period is shorter than instruction cycle time period
instruction cycle time period is exactly half of machine cycle time period
instruction cycle time period is exactly equal to machine cycle time period

⇒ If D is mouth diameter of a paraboloid reflector, its directivity is proportional to
D
D²
D
D³

⇒

Assertion (A): Demodulation of SSB and AM signals is exactly similar

Reason (R): The basic SSB demodulation device is product detector.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which circuit has its output signal from, the emitter?
Common base
Common emitter
Emitter follower
None of the above

⇒ Which of the following is used for generating time varying wave forms?
MOSFET
PIN diode
Tunnel diode
UJT

⇒

Assertion (A): A ballistic galvanometer is used to measure charge.

Reason (R): In a flux meter, the damping is large.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ As the temperature of an intrinsic semiconductor material is increased
protons get excited
neutrons acquire charge
energy of the atom is increased
additional holes are created in the conduction band

⇒ During induction heating of metals which of the following is abnormally high?
Frequency
Voltage
Current
Power factor

⇒ Which is correct for a vacuum triode?
μ = r_pg_m
r_p = μg_m
g_m = μr_p
r_pg_m