Question is ⇒ Which of the following is a valid real constant?, Options are ⇒ (A) 1281, (B) 1281, (C) KM, (D) 11821, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is a valid real constant?, Options are ⇒ (A) 1281, (B) 1281, (C) KM, (D) 11821, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is a valid real constant?
A.	1281 [Wrong Answer]
B.	1281 [Correct Answer]
C.	KM [Wrong Answer]
D.	11821 [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For measuring a very high resistance we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (a) or (c)

⇒ The analog signal given below is sampled by 600 samples per se
600 Hz
120 Hz
300 Hz
360 Hz

⇒ The current through a 10 Ω resistance in a dc circuit having two emf sources is 3A. If this resistance is changed to 20 Ω, the new value of current will be
less than 3 A
equal or less than 3 A
equal to or less or more than 3 A
1.5 A

⇒ Which of the following terminations makes the input impedance of a line equal to characteristic impedance Z₀?
line open circuited at far end
line terminated in Z₀
line short circuited at far end
line terminated in inductance

⇒ Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
0.22
1.31
0.3
0.2

⇒ What is the chemical bonding in silicon semiconductor?
Metallic
Ionic
Covalent
van der Waals

⇒ A dielectric of relative permittivity ∈_r is subjected to a homogeneous electric field E. The dipole moment P per unit volume is given by
P = constant
P = ∈₀ E
P = ∈₀(∈_r - 1) E
P = ∈_r E

⇒ In the schematic representation of bipolar junction transistor, the direction of arrow shows the direction of flow of
holes
electrons
holes in pnp and electrons in npn
electrons in pnp and holes in npn

⇒ Which one of following is a stataic system?
y(n) = x(n) - x(n - 1)
y(n) = x(2n) - x(2n-1)
y(n) = x(n - 1)
y(n) = e^x(n)

⇒ The noise generated by a resistor depends upon
its resistance value
its operating temperature
both its resistance value and operating temperature
none of the above

⇒ A coil has a resistance of 2 Ω and inductance of 0.1 mH. The applied voltages is suddenly increased from 10 V to 20 V. After steady state condition have reached, the current is
0.0833333333333333
more than 2 A but less than 4 A
0.166666666666667
more than 4 A

⇒ Ripple factor RF and form factor FF are related as
RF = FF² - 1
RF = (FF² - 1)^0.5
RF = FF - 1
RF = (FF - 1)^0.5

⇒ A 256 x 4 EPROM has
8 address pins and 4 data pins
8 address pins and 8 data pins
4 address pins and 8 data pins
4 address pins and 4 data pins

⇒ At t = ∞; V_R2 and V_C wil
4, 4
2, 4
0, 2
2, 0

⇒ An active network has
an e.m.f source
a current source
neither of the above
either (a) or (b)

⇒ The density of states (i.e. number of states per eV per m³) in the conduction band for energy level E is proportional to
E
E
E^1.5
E²

⇒ A cascade amplifier stage is equivalent to
common emitter stage followed by a common base stage
common base stage followed by an emitter follower
an emitter follower stage followed by a common base stage
a common base stage followed by a common emitter stage

⇒

Assertion (A): A TRIAC is a bidirectional SCR.

Reason (R): A TRIAC is a four layers 3 terminal device and can conduct in both directions.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For broadside array, maxima will be obtain at
90°, 270°
180°
45°
at any angle

⇒ Which of the following is not a valid variable in FORTRAN 77?
BRG
VS
VS 3A
3 VSA

⇒ The series element in band pass filter is
capacitive
inductive
parallel combination of inductance and capacitance
series combination of inductance and capacitance

⇒ In the given figure the ratio T/d is the duty fac
TRUE
FALSE

⇒ In a push pull circuit the two transistors are
both pnp
both npn
one pnp and other npn
either (a) or (b)

⇒

Assertion (A): In hot wire instrument the material of hot wire in generally platinum iridium.

Reason (R): A hot wire ammeter is suitable for ac only

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a purely resistive circuit the instantaneous power varies from zero to maximum twice in each cycle.
TRUE
FALSE

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode

⇒ In a positive-edge-triggered JK flip-flop, a low J and a low K produce __________ state. A high __________ on the rising edge of the clock.
inactive, reset
active, reset
active, toggle
inactive, toggle

⇒ In a CE amplifier the collector resistance is short circuited. The ac output voltage will
increases
remains the same
increases or decreases
decreases

⇒ A scheme shown below is to generate a wide band FM modulate sign
30
6
250
12

⇒ The energy stored in a coil is 108 J. It is opened suddenly in 10 ms. The power dissipated instantaneously across the blades of switch is
108 W
1080 W
10800 W
108000 W