Question is ⇒ Which of the following is a valid logical expression in Pascal?, Options are ⇒ (A) 2.5 : = A, (B) (A + B) < < (C + D), (C) A = < B, (D) A > = B, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is a valid logical expression in Pascal?, Options are ⇒ (A) 2.5 : = A, (B) (A + B) < < (C + D), (C) A = < B, (D) A > = B, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is a valid logical expression in Pascal?
A.	2.5 : = A [Wrong Answer]
B.	(A + B) < < (C + D) [Wrong Answer]
C.	A = < B [Wrong Answer]
D.	A > = B [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The equivalent circuit shown in figure is
CE
CB
CC
None of the above

⇒ Consider the following applications

TV tuning
Active filter
Microwave frequency multiplication

In which of above can a varactor diode be used?
1 2 and 3
l and 2 only
1 and 3 only
2 and 3 only

⇒ If A = 7 ∠15, A² is
49 ∠225°
49 ∠30°
49 ∠15°
49 ∠7.5°

⇒ The unit of permeability is
T
Wb
H/M
H

⇒ The function off an oxide layer in an IC device is to

mask against diffusion or ion implantation
insulate the surface electrically
increase the melting point of Si
produce a chemically stable protective layer

1, 2, 3
1, 3, 4
2, 3, 4
4, 1, 2

⇒ The ideal characteristics of a stabilizer is
constant output voltage with low internal resistance
constant output current with low internal resistance
constant output voltage with high internal resistance
constant internal resistance and constant output current

⇒ In terms of z parameters, the condition for the network to be passive is
z₁₁ = z₂₂
z₁₂ = z₂₁
z₁₁ = 0
z₂₂ = 0

⇒ High speed counter
ring counter
ripple counter
synchronous counter
asynchronous counter

⇒ Consider the following amplifier with negative feed
-9 x 10^-3
9 x 10^-3
-11 x 10^-3
11 x 10^-3

⇒ In figure, V_C is approximately equa
2 V
4.6 V
8 V
7.6 V

⇒ The IF amplifier in a superheterodyne receiver is
single-stage single-timed amplifier
two stage of single tuned amplifier
double tuned amplifier
class-C amplifier

⇒ The output of the 74 series of TTL gates is taken from a BST in
totem pole and common collector configuration
either totem pole or open collector configuration
common base configuration
common collector configuration

⇒ Two resistances are R₁ = 36 ± 5% and R₂ = 75 ± 5%. If they are connected in parallel, the limiting error in percent will be
0.05
0.1
0.15
0.2

⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts

⇒ Vividh Bharati programme is transmitted in
short wave
medium frequency
very high frequency
all of the above

⇒ A 6 MHz channel is used by a digital signalling system initializing four-level signals. The maximum possible transmission rate is
6M bands/s
12M bands/s
6 M bits/s
12M bits/s

⇒ For an ideal 3000 Hz channel, S/N ratio is
3
1.5
4
2

⇒ For representing two sinusoidal voltages on a phasor diagram
Both voltages must be of the same frequency
Both voltages must be sinusoidal but may be of different frequencies
One of the voltages must be of 50 Hz
The frequency of one must be integral of that of other

⇒ Noise can be reduced by increasing sampling rate
TRUE
FALSE
can't say
insufficient data

⇒ A capacitor whose capacitance C_t = C₀ (1- cos ωt) is fed by a sinusoidal voltage v = V₀ sin ωt. The equation for current i is
ω C₀V₀ cos ωt
ω C₀V₀ sin ωt
ω C₀V₀ (cos ωt - cos² ωt)
none of the above

⇒ Which circuit has its output signal from, the emitter?
Common base
Common emitter
Emitter follower
None of the above

⇒ To measure dielectric loss you would use
Anderson bridge
Kelvin bridge
Schering bridge
Maxwell's bridge

⇒ What will be maximum input that can be converted for a 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
9 V
9.45
10 V
8 V

⇒ Mobility of electrons and holes are equal.
TRUE
FALSE

⇒ An intrinsic silicon sample has 1 million free electrons at room temperature. As the temperature is increased
the number of free electrons increases
the number of free electrons increases but the number of holes decreases
the number of free electrons and holes increase by the same amount
the number of free electrons and holes increase but not by the same amount

⇒ Degaussing in a picture tube means
Adding magnetism in mask and mounting frame
Removing residual magnetism in mask, shield etc...
Increasing resistance of coils to decrease time constant
Decreasing resistance of coils to increase time constant.

⇒ The quality of a space-link is measured in terms of the __________ ratio.
C/N
S/N
G/T
EIRP

⇒ When a potential is applied across an intrinsic semiconductor, holes flow
towards positive terminal
away from positive terminal
in the external circuit only
none of the above

⇒ ADM stands for
Angle Delta Modulation
Angle Digital Modulation
Adaptive Delta Modulation
Adaptive Digital Modulation

⇒ Which of the following is most likely to be found in an SSB transmitter?
Class A, RF output amplifier
Class B, RF amplifier
Tuned modulator
Class C, audio amplifier