Question is ⇒ Which of the following integer expressions is incorrect in Pascal?, Options are ⇒ (A) <code>L div M + P </code>, (B) <code>A * * B</code>, (C) <code>A div B - C </code>, (D) <code>A mod B</code>, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following integer expressions is incorrect in Pascal?, Options are ⇒ (A) <code>L div M + P </code>, (B) <code>A * * B</code>, (C) <code>A div B - C </code>, (D) <code>A mod B</code>, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following integer expressions is incorrect in Pascal?
A.	`L div M + P` [Wrong Answer]
B.	`A * * B` [Correct Answer]
C.	`A div B - C` [Wrong Answer]
D.	`A mod B` [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Two coupled coils with self inductances of 4 mH and 16 mH are connected in series. The maximum possible value of inductance can be
36 mH
20 mH
28 mH
64 mH

⇒ Between which points does UJT exhibit negative resistance characteristics
between peak and valley points
before peak point
after peak point
after valley point

⇒ The units of the spectrum obtained be Fourier transforming the covariance function of a stationery Stochastic Process is
Power per Hz
energy per Hz
Power per sec
Energy per second

⇒

Assertion (A): If minimum phase system has a gain margin of 8 dB and phase margin of 21°, the system is stable.

Reason (R): For a minimum phase system both GM and PM must be positive for the system to be stable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Permittivity has the units of F/m.
TRUE
FALSE

⇒ Which of the following is anti-ferromagnetic material?
CrSb
NIO
MnO
All of the above

⇒ For satellite communication, the frequency should be
equal to the critical frequency
more than the critical frequency
less than the critical frequency
none of these

⇒ The 'h' parameters of the circuit shown in the figure are h_ib = 25 Ω, h_fb = 0.999 and h_ob = 10^-6Ω The Voltage gai
0.99
1.98
2
4

⇒ To increase Q factor of a coil, the wire should be
long
thin
thick
long and thin

⇒ The effective length of antenna is different from actual length due to
top loading
end effects
both (a) and (b)
none of the above

⇒ In a CRO the Y plates are oriented
horizontally
vertically
at an angle of 20° of horizontal
at an angle of 70° of horizontal

⇒ When the ac base voltage in a CE amplifier circuit is too high, the ac emitter current is
zero
constant
alternating
distorted

⇒ A 3 phase semiconverter when supplying a certain load has a rectification efficiency of 0.6 and transformer utilisation factor of 0.35. When a 3 phase full converter is supplying the same load
rectification efficiency will be more than 0.6 and TUF will be more than 0.35
rectification efficiency will be more than 0.6 but TUF will be less than 0.35
rectification efficiency will be less than 0.6 and TUF will be less than 0.35
rectification efficiency will be less than 0.6 but TUF will be more than 0.35

⇒ In a CE amplifier circuit the emitter by pass capacitor is remove. The ac output voltage
increases
remains the same
increases or decreases
decreases

⇒ The mass of an electron is nearly
9.1 x 10^-27 kg
9.1 x 10^-29 kg
9.1 x 10^-31 kg
9.1 x 10^-35 kg

⇒ Double spotting in a receiver is due to
poor sensitivity of RF amplifier
high gain of IF amplifier
inadequate image frequency rejection
all of the above

⇒ If the number of information bits is m, the number of parity bits p in the Hamming code is given by equation
2^p = m + p + 1
2^p ≥ m + p + 1
2^P = m + p
2^p ≥ m + p

⇒ A narrowband amplifier is one that has a passband
limited to 2000 Hz only
limited to audio frequency range only
near cut off region of active device
approximately 10% of its central frequency

⇒ For an amplifier, the coupling method which gives the highest gain in
impedance coupling
transformer coupling
capacitance coupling
resistance coupling

⇒ In the op-amp circuit of figure, V_{0V_i
3 V_i
5 V_i
0.5 V_i}

⇒ In a second order system, the time constant t of exponential envelopes depends
only on damping factor
only on natural frequency
both on damping factor and natural frequency
neither on damping factor nor on natural frequency

⇒ In a microprocessor system the stack is used for
starting the program return address whenever a subroutine jump instruction is execute
transmitting and receiving input and output data
starting all important CPU register contents whenever an interrupt is to be serviced
storing program instructions for interrupt service routine

⇒ To multiply a number by 8 in 8085 we have to use RAL instruction
once
twice
thrice
four times

⇒ Which one the following is an advantage of AM over FM?
FM has wide bandwidth
FM has better
FM is more immune to noise
Probability of noise spike generation is less in AM

⇒ In an n type semiconductor the fermi level is 0.35 eV below the conduction band, the concentration of donor atoms is increased to three times. The new position of Fermi level will be
0.35 eV below conduction band
about 0.32 eV below conduction band
about 0.32 eV above conduction band
about 0.1 eV below conduction band

⇒ For a logic fa
V_IH > V_0H > V_IL > V_0L
V_OH > V_IH > V_IL > V_0L
V_IH > V_OH > V_OL > V_IL
V_OH > V_IH > V_OL > V_IL

⇒ In TV broadcast, UHF range is
606 - 790 MHz
100 - 150 MHz
41 - 68 MHz
174 - 230 MHz

⇒ Consider the following statements, SWR of a transmission line is infinite when the load is

a short circuit
a complex impedance
an open circuit
a pure reactance

Which of the above statements are correct?
1 and 3 only
1, 2, 3
2, 3, 4
1, 2, 4

⇒ A magnet does not attract
nickel
iron
copper
iron and copper

⇒ When a 10 K, 10%, 1/4 Ω resistor is connected in series with a 12 K, ± 1%, 1/4 Ω resistor, the resulting combination has the following specifications
22 K, ± 11%, 1/2 Ω
22 K, ± 5.5%, 1/2 Ω
22 K, ± 5.5%, 1/8 Ω
none of these