Question is ⇒ Which of the following input is not possible in case of a SR flip-flop?, Options are ⇒ (A) S = 0, R = 0, (B) S = 0, R = 1, (C) S = 1, R = 0, (D) S = 1, R = 1, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following input is not possible in case of a SR flip-flop?, Options are ⇒ (A) S = 0, R = 0, (B) S = 0, R = 1, (C) S = 1, R = 0, (D) S = 1, R = 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following input is not possible in case of a SR flip-flop?
A.	S = 0, R = 0 [Wrong Answer]
B.	S = 0, R = 1 [Wrong Answer]
C.	S = 1, R = 0 [Wrong Answer]
D.	S = 1, R = 1 [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following statement about JFET is true?
In a JFET, gate and source have opposite polarity with respect to drain irrespective of the type of FET
In its schematic symbol for JFET, the arrow always points to p-type material
In an n-channel JFET, the channel is the narrowest under zero gate bias condition
In JFET, gate source cut off voltage is numerically equal to the pinch off voltage

⇒ Multiple member of antennas are arranged in arrays in order to enhance what property?
Both directivity and bandwidth
Only directivity
Only bandwidth
Neither directivity nor bandwidth

⇒ Compared to coaxial lines, the advantages of wave guides are
higher power handling capacity
lower loss per unit length
cheaper and simple mechanical structure
all of the above

⇒ If a fuse is higher than required current rating is employed in a circuit, it will
blow more frequently since it carries more current
afford better protection to the circuit
seriously overload the circuit
lead to larger maintenance cost

⇒ Present day HVDC converters are all
3 pulse converters
6 pulse converters
12 pulse converters
either 6 pulse or 12 converters

⇒ In a television transmitter, the output stage is most likely to be
screen modulated class C amplifier
plate modulated class C amplifier
grid modulated class A amplifier
grid modulated class C amplifier

⇒ Consider the following statements for 8085

The most significant 8 bits of address are transmitted on the 8 lines on which data is transmitted.
Eight pins are dedicated to transmit the most significant 8 bits of memory address.
The least significant 8 bits of address are transmitted on the lines on which data is transmitted.
The data and leass significant 8 bits are transmitted at different points in time.

Which of the above statements are correct?
all
1, 2 and 3 only
2, 3 and 4 only
1, 3 and 4 only

⇒ A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be
0.6 Ω
0.06 Ω
0.1 Ω
0.004 Ω

⇒ Class-B amplifier has less efficiency compared to
class A
class B
class C
class A, AB and C

⇒ The amplitude modulated wave is given by __________ e = 25(1 + 0.7 cos 5000t - 0.3 cos 1000t) x sin 5 x 10⁶t The amplitude of carrier and sideband frequencies in magnitudes are
25, 0.7, 0.3
25, 0.7, - 0.3
24, 17.5, 7.5
25, 8.75, 3.75

⇒ In tape recorder erase head is active during recording.
TRUE
FALSE

⇒ Radiation resistance for wire antenna is
55 Ω
65 Ω
100 Ω
377 Ω

⇒ 1 GHz is equal to
10⁶ Hz
10⁸ Hz
10⁹ Hz
10¹⁰ Hz

⇒ Kirchoff's laws are applicable to
steady state conditions only
transient conditions only
both steady state and transient condition
both steady state and transient condition but with some constraints

⇒

Assertion (A): In a full wave rectifier output the lowest ac component is at twice the input frequency

Reason (R): In a full wave rectifier, the output waveform consists of half sinusoids

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The on voltage and forward breakover voltage of an SCR depend on
gate current alone
band gap of semiconductor alone
gate current and semiconductor band gap respectively
semiconductor band gap and gate current respectively

⇒ If γ = (S₀/N₀)/(S_i/N_m) where S₀ and S₁ are signal power output and signal power input and N₀ and N_m are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are
1 and 1
1 and 2
2 and 1
0.5 and 0.5

⇒ Conductivity is measured in terms of
mho/metre
ohm/metre
mho/metre²
ohm/metre²

⇒ A single phase full wave regulator feeds a resistive load. The firing angle of thyristors is 90°. The input power factor is
1
0.707 lagging
0.5 lagging
0.2 lagging

⇒ A short-circuit is that which is
used short pieces of wire
goes only a short distance
is used for dimming light
offer very low resistance path for current to flow

⇒ A magnetic field exists around
moving charges
static charges
iron
copper

⇒ A first-order system has a time constant t. For unit ramp input, the steady state error is
t²
t
t
1/t

⇒ The spectral component of noise associated with k^th frequency is given, in the limit as Δf → 0 by n_k(t) written as n_k(t) = C_k cos (2pk Δft + θ_{k1, 2 only
1, 3 only
1, 2, 3
2, 3 only}

⇒ For a semiconductor, the conductivity is a function of the products of the number of charge carriers and their mobilites. As result, if the temperature of a slab of intrinsic silicon increases, how does its conductivity vary?
Decreases
Increases
Remains unaffected
Increases or decreases depending upon the rise in temperature

⇒ In a hot wire instrument, the deflection is proportional to
peak value of ac current
average value of ac current
rms value of ac current
either (a) or (b)

⇒ μ₀ = 8.85 x 10^-12F/m.
TRUE
FALSE

⇒ The first and second subscripts in models of circular waveguides depict
the number of full sine wave variations in circumference in direction and Bessel function variations in radial direction respectively
the Bessel function variations in radial direction and the number of full sine wave variations in circumference direction respectively
the Bessel function variations in circumference direction and number of full sine wave variations in radial direction respectively
none of the above

⇒ In the above case the modulation index will be
9.6
28.8
57.6
100

⇒ Which one of the following is a transferred electron device?
BARITT diode
IMPATT diode
TRAPATT diode
Gunn diode

⇒ In any network of linear impedances the current flowing at any point equal to algebric sum of currents caused to flow at that point by each of the emf taken separately with all other emfs reduced to zero. The statement represents.
KCL
Norton's theorem
Thevenin's theorem
Superposition theorem