Question is ⇒ Which of the following frequency is likely to be associated with AM radio broadcast?, Options are ⇒ (A) 1000 kHz, (B) 100 MHz, (C) 500 MHz, (D) 10 GHz, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following frequency is likely to be associated with AM radio broadcast?, Options are ⇒ (A) 1000 kHz, (B) 100 MHz, (C) 500 MHz, (D) 10 GHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following frequency is likely to be associated with AM radio broadcast?
A.	1000 kHz [Correct Answer]
B.	100 MHz [Wrong Answer]
C.	500 MHz [Wrong Answer]
D.	10 GHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which capacitor-store higher amount of energy?
Air capacitor
Paper capacitor
Mica capacitor
Plastic film capacitor

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the starting torque is 100 N-m. At 25 Hz, the starting torque
will be less than 100 N-m
will be more than 100 N-m
may be more or less than 100 N-m depending on motor parameters
very small

⇒ Speech amplifiers are usually operated as
class A
classes AB
class B
class C

⇒ As the reverse voltage is increased, the depletion layer
becomes narrow
widens
remains the same
reduce to zero

⇒ Nibble is
a string of 4 bits
a string of 8 bits
a string of 16 bit
a string of 64 bits

⇒ A TE₁₀ rectangular waveguide is to be designed for operation over 25-35 GHz and the band centre is 1.5 times the cutoff frequency. The dimension of broadside is
15 mm
10 mm
9 mm
7.5 mm

⇒ Barkhausen criterion of oscillation is
Aβ > 1
Aβ = 1
Aβ = < 1
Aβ ≤ 1

⇒

Match the following:

	List I		List II
A.	loop antenna	1.	flat line
B.	folded dipole	2.	300 W
C.	SWR of 1	3.	sharp broadside full
D.	VHF band	4.	30 to 300 MHz

A-1, B-4, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ Which of the following is used to generate PDM?
Free running multi-vibrator
Monostable multi-vibrator
JK flip-flop
Schmitt trigger

⇒ As the viscosity of a liquid increases, the relaxation time
remains constant
increases
decreases
first decreases then increases

⇒ Which type of fading causes serious distortion of modulated signal?
Selective fading
Interference fading
Absorption fading
Polarization fading

⇒ If three cascaded stages of amplifier have gains 10, 20 and 30 the overall voltage will be
30
60
600
6000

⇒ Which 8085 instruction causes exchange of contents of stack pointer with the contents of H L register pair?
XTHL
PCHL
LHLD
MVIA

⇒ In a good voltage amplifier, its input impedance
must be high compared to the resistance of the source
must be low compared to the resistance of the source
must be equal to the resistance of the source
must be half the resistance of the source

⇒ The Wheatstone bridge method of measuring resistance is ideally suited for the measurement of resistance values in the range of
0.001 to 1 Ω
0.1 to 100 Ω
100 Ω to 10 kΩ
100 kΩ to 10 MΩ

⇒ In the NMOS inverter
the driver and active load are enhancement type
driver is enhancement type and load depletion type
driver is depletion type and load enhancement type
both driver and load are depletion type

⇒ Figure sho
bipolar transistor
JFET
p-channel MOSFET
n-channel enhancement MOSFET

⇒ Poles and zeros of a driving point function of a network are simple and alternate on jω axis. The network consists of
R and C
L and C
R and L
R, L and C

⇒ In the graph shown in the figure, for the tree with branches b, d and f the fundamental loops would inclu
abf, def, bdea
bdc, def, fba
abde, def, cdb
cea, bdea, abbf

⇒ Two wattmeter method of 3-phase power measurement can be used to find
total active power
total active power and power factor
total active power and reactive power
total active power, power factor, apparent power, and reactive power

⇒ A CMOS amplifier when compared to an N-channel. MOSFET, has the advantage of
higher cut off frequency
higher voltage gain
higher current gain
lower current drain from the power supply, there by less dissipation

⇒ The highest modulating frequency typically used in AM systems is
1 kHz
5 kHz
20 kHz
50 kHz

⇒

Assertion (A): Data communication using digital data must be very accurate.

Reason (R): In analog signals redundancy is available but in digital signals redundancy is not available.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Magnetic effect of current is used in
ammeters
voltmeters
wattmeters
ammeters, voltmeters, wattmeters and energy meters

⇒ Most of the communication satellites are stationed to the West of their service areas in order to reduce their
eclipse period
loss of power
battery power provision
mass of station-keeping fuel

⇒ One can format a disc using window explorer.
TRUE
FALSE

⇒ In a photodiode the current is due to
majority carriers
minority carriers
both majority and minority carriers
either (a) or (b)

⇒ In FM, increased depth of modulation increases
modulation
modulation index
bandwidth
all of the above

⇒ A moving iron instrument can be used for dc as well as ac.
TRUE
FALSE

⇒ In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
all calculations done earlier have to be repeated
replace all calculated voltages by reverse values
replace all calculated currents by reverse values
replace all calculated voltages and currents by reverse values