Question is ⇒ Which of the following flip-flop is used as a latch?, Options are ⇒ (A) J K flip-flop, (B) R S flip-flop, (C) T flip-flop, (D) D flip-flop, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following flip-flop is used as a latch?, Options are ⇒ (A) J K flip-flop, (B) R S flip-flop, (C) T flip-flop, (D) D flip-flop, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following flip-flop is used as a latch?
A.	J K flip-flop [Wrong Answer]
B.	R S flip-flop [Wrong Answer]
C.	T flip-flop [Wrong Answer]
D.	D flip-flop [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which antenna is a wideband antenna?
Hertz antenna
Marconi antenna
Folded dipole
None of the above

⇒ For a junction FET in the pinch off region, as the drain voltage is increased, the drain current
becomes zero
abruptly decrease
abruptly increases
remains constant

⇒ The peak factor is the ratio of
peak and rms values
peak and average values
rms and average values
none of the above

⇒ Dielectric loss due to polarisation occurs in
bipolar dielectrics
non-metallic dielectrics
liquid dielectrics
all of the above

⇒ The command ^C in MS WORD
copies the text in clip board
copies the text in secondary storage device
copies the text in file
None of the above

⇒ One of the advantages of base modulation over collector modulation in a class C transistor amplifier is
higher efficiency
more linear operation
more power output per transistor
lesser requirement of modulating power

⇒ A reflex klystron oscillator uses
one cavity resonator
two cavity resonators
three cavity resonators
none of the above

⇒ In a digital system there are three inputs ABC. Output should be high when atleast two inputs are high. Then output =
AB + BC + AC
ABC + ABC + A BC + ABC
AB + BC + AC
AB + BC + AC

⇒

Assertion (A): When a square periodic wave is applied to an RC circuit, the voltage across capacitor is observed to be a triangular periodic wave.

Reason (R): The RC circuit works as integrator and its time constant is much larger than time period of input wave.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In flip flops the duration of clock pulse is about
3 ns
10 ns
25 ns
50 ns

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the modulation index is
1
2
3
4

⇒ A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance
increases
decreases
remains constant
may increases or decreases

⇒ Which of the following oscillator is not in FM?
Crystal oscillator
Hartley oscillator
Colpitts oscillator
All of the above

⇒ The orbital period of a geostationary communication satellite is
12 hours
24 hours
36 hours
48 hours

⇒ Which has volatile memory?
Magnetic tape
RAM
Diskette
Hard disk

⇒ The ripple factor of a full wave rectifier is about 0.5
TRUE
FALSE

⇒ A megger has a hand driven dc generator.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Interface	1.	A measure of rate of data transmission
B.	A bit	2.	A binary digit
C.	Band speed	3.	The common boundary between various sections and subsections
		4.	A/D converter

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-4, C-1
A-4, B-2, C-3

⇒ In the circuit of figure the current through 5 Ω resistance at t = &infin
0.166666666666667
2.5 A
3.1 A
0

⇒ Quantization error occurs in
D/A converter
A/D converter
both D/A and A/D converter
neither D/A nor A/D converter

⇒ An instruction used to set cany flag in a computer is classified as
data transfer
arithmetic
logical
program control

⇒ RMS value of i(t) = 10[1 + sin (- t)] is
10
10/2
l50
102

⇒ In the case of a 70-MHz IF carrier for a transponder bandwidth of 36 MHz, energy must lie between MHz.
34 and 106
52 and 88
106 and 142
34 and 142

⇒ It is found that a ship to ship communication suffers from fading. This can be avoided by using
space diversity
frequency diversity
broad band antenna
directional antenna

⇒ Consider a loss less antenna with a directive gain of + 6 dB. If 1 mW of power is fed to it the total power radiated by the antenna will be
4 mW
1 mW
7 mW
1/4 mW

⇒ In C-language f- = 9 is equivalent to
f = -9
f = f - 9
f = 9 - 1
-f = 9

⇒ A wave is frequency modulated with an index of 0.1 and its frequency is multiplied by 8 times, the modulation index is
not changed
decreased 8 times
increased 4 times
increased 8 times

⇒ A resistor of 10 kΩ has an rms noise voltage of 1 mV under a certain set of conditions. A resistor of 20 kΩ under the same conditions will have an rms noise voltage of
1 mV
2 mV
1.414 mV
4 mV

⇒ The absolute values of pinch-off voltage and gate-source cut-off voltage are
nearly zero
complementary to each other
never equal
equal

⇒ In a transistor E mode the collector current with the transistor in cut off region is
zero
high
equal to saturated value
none of the above