Question is ⇒ Which of the following exhibits negative resistance in a portion of its characteristics?, Options are ⇒ (A) Tunnel diode, (B) Zener diode, (C) JFET, (D) MOSFET and tunnel diode, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following exhibits negative resistance in a portion of its characteristics?, Options are ⇒ (A) Tunnel diode, (B) Zener diode, (C) JFET, (D) MOSFET and tunnel diode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following exhibits negative resistance in a portion of its characteristics?
A.	Tunnel diode [Correct Answer]
B.	Zener diode [Wrong Answer]
C.	JFET [Wrong Answer]
D.	MOSFET and tunnel diode [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Words having 8 bits are to be stored into computer memory. The number of lines required for writing into memory are
1
2
4
8

⇒ A function is given f(t) = sin²t + cos²t. Which of the following is true?
f has frequency components at 0 and 1/2p Hz
f has frequency components at 0 and 1/p Hz
f has frequency components at 1/2p and 1/p Hz
f has frequency components at 0, l/2p and 1/p Hz

⇒ Which of the following is not a travelling wave?
e = E_m sin (βx - ωt)
e = E_m cos (βx - ωt)
e = E_m sin (ωt - βx)
e = E_m sin (βx)

⇒ The counter shown in figure is built using 4 negative edge triggered toggle FFs. The FFs can be set synchronously when R = 0. The combinational logic required to realize a modulo 13 counte
F= Q₄ Q₃ Q₂ Q₁
F= Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ Q₃ Q₂ Q₁

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ Rise time in a transistor is change from
10% of its final value to 90% of its final value
0% of its final value to 90% of its final value
10% of its final value to 100% of its final value
10% to its final value to 50% of its final value

⇒ A single element strain gauge bridge has two fixed resistances R₁ and R₁ of 120 Ω each and a variable resistance which gives full deflection at 120 Ω for zero strain and 120.6 Ω for straine e. If gauge factor is 2, strain e is
0.0025
0.0035
0.005
0.0075

⇒ In Z_RC (s) = constant at s = 0, the last element in first Foster cauer realization is
R
C
R and C in series
R and C in parallel

⇒ The race condition in NOR SR latch occurs when
S = R = 1
S = 0, R = 1
S = 0, R = 0
S = 1, R = 0

⇒ If a function has only cosine terms, it must satisfy the equation
f(t) = -f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒ For a 50 Ω resistor for 3 GHz application, the stray capacitance should be less than
1 μF
1 nF
1 pF
0.1 pF

⇒ Most of the transistor data sheets specify the power rating for an ambient temperature of
10°C
25°C
50°C
75°C

⇒ An m derived low pass filter has f_c = 1000 Hz and m = 0.6. This filter will have infinite attenuation at
f = 1250 Hz
all frequencies above 1000 Hz
f = 1562.5 Hz
f = 1666.67 Hz

⇒

Assertion (A): An ideal rectifier should have unity harmonic factor

Reason (R): An ideal rectifier should have unity displacement factor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ To increase Q factor of a coil, the wire should be
long
thin
thick
long and thin

⇒ A resistance wire strain gauge has gauge factor 2. If stress is 100 mega newton/m² and Young's modulus is 200 giga newton/ m², the percentage change in gauge resistance due to stress is
0.1
0.2
0.4
0.5

⇒ Which of the following is non-sinusoidal oscillator?
Multivibrator
Relaxation oscillator using UJT
Relaxation oscillator using tunnel diode
Any of the above

⇒

Assertion (A): The sign and magnitude of displacement can be measured by an LVDT.

Reason (R): LVDT is based on the principle of mutual inductance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): Damping in a vibration galvanometer is small.

Reason (R): Vibration galvanometer is a PMMC instrument.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The first machine cycle of an instruction is always
a memory read cycle
a fetch cycle
a input/output read cycle
a memory write cycle

⇒ Which of the following characteristics of a silicon p-n junction diode make it suitable for use as ideal diode?

It has low saturation current.
It has high value of cut in voltage.
It can withstand large reverse voltage.
When compared with germanium diode, silicon diode shows a lower degree of temperature dependence under reverse conditions.

Select the answer using the given below
1 and 2
1, 2, 3, 4
2, 3, 4
1, 3

⇒ Which of the following circuits cannot be demodulate SSB?
Product detector
Balanced modulator
Phase discriminator
BFO

⇒ Choose the correct option
tree does not contain any loop
tree contain all the nodes
tree is always open
all

⇒ Which one of the following gives maximum probability of error?
ASK
DPSK
FSK
PSK

⇒

Assertion (A): Orbital magnetic moment of an electron in an atom is of the order of 1 Bohr magneton.

Reason (R): 1 Bohr magneton = 9.27 x 10^-24 A/m².

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ An ammeter has a resistance of 50 ohms and a shunt of 0.01 Ω. The deflection is θ. If the shunt resistance is increased to 0.02 Ω, the deflection will be.
θ
2θ
0.5θ
0.25θ

⇒ The Gaussian filter characteristic figure is realiza
TRUE
FALSE

⇒ To find current in a resistance connected in a network, Thevenin's theorem is used V_TH = 20 V and R_TH = 5 Ω. The current through the resistance
is 4 A
is 4 A or less
is less than 4 A
may be 4 A or less or more than 4 A

⇒ Negative feedback lowers the cut off frequency and increase the upper cut off frequency of amplifier.
TRUE
FALSE

⇒ If D, G and η denote the directly, power gain and efficiency of an antenna, then which of the following relation holds :
DGη = 1
η = DG
D = ηG
D = G/η