Question is ⇒ Which of the following devices uses a helix?, Options are ⇒ (A) Klystron amplifier, (B) Klystron oscillator, (C) TWT, (D) Both (a) and (b), (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following devices uses a helix?, Options are ⇒ (A) Klystron amplifier, (B) Klystron oscillator, (C) TWT, (D) Both (a) and (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following devices uses a helix?
A.	Klystron amplifier [Wrong Answer]
B.	Klystron oscillator [Wrong Answer]
C.	TWT [Correct Answer]
D.	Both (a) and (b) [Wrong Answer]
View Answer 2 -9 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	? :	1.	Modulus
B.	[ ]	2.	Array expression
C.	%	3.	Conditional

A-3, B-2, C-1
A-1, B-2, C-3
A-1, B-3, C-2
A-2, B-3, C-1

⇒ The phase angle characteristic in the given figure is
all pass function
transport lag
minimum phase function
none of the above

⇒

Assertion (A): Derivative control action cannot be used alone.

Reason (R): Derivative control action is effective only during transient periods.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ One coulomb charge is equal to the charge on
6.24 x 10¹⁸ electrons
6.24 x 10²⁴ electrons
6.24 x 10¹⁸ atoms
none of the above

⇒ In a series regulated power supply circuit the voltage gain of pass transistor satisfies the condition
A_v → ∞
1 << A_v → ∞
A_v ≈ 1
A_v << 1

⇒ Wire-wound resistors are unsuitable for use at high frequencies because they
are likely to melt under excessive eddy current heat
exhibit unwanted inductive and capacitive effects
create more electrical noise
consume more power

⇒ Multiplexer can be used as logic function generator.
TRUE
FALSE

⇒ A narrowband amplifier is one that has a passband
limited to 2000 Hz only
limited to audio frequency range only
near cut off region of active device
approximately 10% of its central frequency

⇒ An amplifier with resistive -ve feedback has two left poles in its open loop transfer function. The amplifier
will always be unstable at high frequencies
will be stable for all frequencies
may be unstable, depending on the feedback factor
will oscillate at low frequencies

⇒ The use of SSB
halves the bandwidth required for transmission
does not affect the bandwidth for transmission
decreases the bandwidth required for transmission by 25%
decreases the bandwidth required for transmission by 66.6%

⇒ The polarization of dielectric materials results in
production of eddy currents
creation of electric dipoles
absorption of electrons
release of high velocity protons

⇒ In a Communication system, noise is most likely to affect the signal.
at the transmitter
In the channel
in Information source
at the destination

⇒ The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.
cut off, saturation
saturation, active
saturation, cut off
active saturation

⇒ In ac bridge measurements, 'Wagner ground' means
a special RC connection to eliminate stray magnetic effects
a special RC connection to eliminate stray capacitance effects
an unwanted and unintended ground connection
a large metal plate buried in ground connected to one corner of bridge

⇒ A three stage telephone switching structure is to have 128 input and 128 output terminals. There are 16 first stage and 16 third stage matrices. To avoid blocking the number of intermediate paths required is
16
15
8
1

⇒ The input and output signals for CE amplifier are always
equal
in phase
out of phase
complementary to each other

⇒ A capacitor used for power factor correction is single phase circuit decreases
power factor
line current
both line current and p.f.
the line current and increases p.f.

⇒ For most metals, Fermi level E_F is less than
0.1 eV
2 eV
5 eV
10 eV

⇒ FM receivers using the standard 88 to 108 MHz band use IF of
8 MHz
9.9 MHz
10.7 MHz
12.2 MHz

⇒ Assuming accumulator contain A 64 and the carry is set (1).What will register A and (CY) contain after RAR?
4 DH, 0
D 3H, 0
4 DH, 1
53 H, 0

⇒ A pulse function can be represented as difference of two equal step functions.
TRUE
FALSE

⇒ A constant k low pass filter has f_c = 1000 Hz. At f = 500 Hz, the phase shift is
p
zero
more than p
less than p

⇒ An amplifier with loop gain Aβ will be more stable for value of Aβ as
0.95
0.7
1.2
1.5

⇒ It is desired that transmission line and load should match for a range of frequencies. The best method is
to use a balun
to use a single stub of adjustable position
to use a double stub
to use a broad band amplifier

⇒ Which of the following has highest power gain?
CE
CC
CB
CB or CC

⇒

Assertion (A): In hot wire instrument the material of hot wire in generally platinum iridium.

Reason (R): A hot wire ammeter is suitable for ac only

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ IC counters are
synchronous only
asynchronous only
both synchronous and asynchronous
none of the above

⇒ When a circuit is excited by ac sinusoidal source, the admittance is obtained by letting s = jω in Y(s).
TRUE
FALSE

⇒ In a digital counter the number of flip-flops is
always 2
always even
always odd
equal to the number of bits required in the final binary count

⇒ A twisted ring counter consisting of 4 FF will have
4 states
8 states
2⁴ states
None of the above