Question is ⇒ Which of the following could be the equation for non-linear resistor shown in figu, Options are ⇒ (A) a + be + ce2 + de3, (B) a - be - ce2 - de3, (C) a + be + ce2 - de3, (D) a + be - ce2 - de3, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following could be the equation for non-linear resistor shown in figu, Options are ⇒ (A) a + be + ce2 + de3, (B) a - be - ce2 - de3, (C) a + be + ce2 - de3, (D) a + be - ce2 - de3, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following could be the equation for non-linear resistor shown in figu
A.	a + be + ce² + de³ [Correct Answer]
B.	a - be - ce² - de³ [Wrong Answer]
C.	a + be + ce² - de³ [Wrong Answer]
D.	a + be - ce² - de³ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following statement is incorrect?
UJT is a 3-terminal diode having two unequally doped regions
A UJT can be triggered by any one of its three terminals
The bi-directional switching characteristics of a diac are symmetrical
As compared to JFETs, MOSFETs generate less noise in high gain amplifiers

⇒ A 1 MHz sinusoidal carrier is amplitude modulated by a symmetrical square wave of period 100 μ sec. Which of the following frequencies will not be in the modulated signal?
990 kHz
1010 kHz
1020 kHz
1030 kHz

⇒ In single tone AM modulation, the transmission efficiency for m = 1 is
0.333
0.5
1
0.1665

⇒ Epitaxial growth is used in ICs
because it produces low parasitic capacitance
because it yields back to back isolating pn junction
to grow single crystal n doped silicon on a single crystal p type substrate
to grow selectively single crystal p doped silicon of one resistivity on a p type substrate of a different resistivity

⇒ Which of the following represents constant magnitude locus for M = 1?
x = -0.5
x = 0
x² + y² = 1
(x + 1)² + y² = 1

⇒ The ratio of diffusion constant for hole D_P to the mobility for holes is proportional to
T²
T
1/T
T³

⇒ In microstrip line has dielectric material most commonly used is
silicon
rubber
plastic
bakelite

⇒ The energy of constant-amplitude complex valued exponential sequence is __________ (where A is the constant amplitude)
0
1
∞
A²

⇒ In an LC immittance H (s)
the slope of dH (jω)/dω is always negative
the slope of dH (jω)/dω is always positive
the slope of dH (jω)/dω may be positive or negative
the slope of dH (jω)/dω is constant

⇒ The signal in 8086 are in minimum mode when
MN / Mx pin is tied to V_cc
MN / Mx pin is grounded
MN / MX pin is left open
none of the above

⇒ For transistor 2 N 338 the manufacturer specifies P_max = 100 mW at 250°C free air temperature and maximum junction temperature of 125°C. Its thermal resistance is
10° C/W
100° C/W
1000° C/W
5000° C/W

⇒ The number of channels available in MF band (300 kHz - 3 MHz) for AM modulating signal of 20 kHz is
70
67
100
150

⇒ A semiconverter feeding an RLE load operates in
first quadrant only
first and second quadrants
first and fourth quadrants
first and third quadrants

⇒ What would be the reading of voltmeter as shown in below figure. The voltmeter has a 0-1 V scale and is a 20000 Ω/V me
0.4545 V
0.082 V
0.82 V
4.54 V

⇒ In common base amplifier the current gain is less than one, but the voltage gain may be anywhere from
0.5 to 1
1 to 5
5 to 10
50 to 2000

⇒ Heat sink results in
slower dissipation of heat to atmosphere
faster dissipation of heat to atmosphere
lower ambient temperature
lower transistor power

⇒ McMurray Bedford full bridge inverter uses
natural commutation
auxiliary commutation
complementary commutation
any of the above

⇒ If V_r is the reverse voltage across a graded P-N Junction, then the junction capacitance c_j is proportional to
(V_r)²
(V_r)ⁿ
(V_r)^-n
(V_r)^3/2

⇒ The input resistance of JFET ideally approaches
zero
1 ohm
100 ohm
infinity

⇒ A good ohmic contact on a P-type semiconductor chip is formed by introducing
gold as an impurity below the contact
high concentration of donors below the contact
high concentration of acceptors below the contact
thin insulator layer between the metal and semiconductor

⇒ Some sources of TV programs are

TV camera
Telecine
VTR
External signal

Which of the above are actually present in a TV studio?
1, 2, 3 and 4
1, 2, 3
1 and 3
1 2 and 4

⇒ For an insulating material, dielectric strength and dielectric loss should be respectively
high and high
low and high
high and low
low and low

⇒ In which of the following logical group instructions of 8085 do the contents of accumulator remain unchanged?
ORA r
ORA M
ORI data
CMP r

⇒

Assertion (A): A backward wave oscillator has an internal positive feedback.

Reason (R): A positive feedback is necessary for sustained oscillations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In N channel MOSFET with gate reverse biased, the gate current is of the order
10^-3 amp
10^-6 amp
10^-9 amp
10^-12 amp

⇒ If the inputs to a 3 bit binary adder are 111₂ and 111₂, the output will be 110₂
TRUE
FALSE

⇒ The main drawback in the performance of shunt peaked wide band amplifier is
two low gain at low frequency
poor phase response
reduce frequency at middle frequency
that the maximum gain of the stage is small

⇒ Consider a situation where number of minterms with even number of 0's are same as number of minterms with odd number of 1's. Then minterms with even number of 0's and minterms with odd number of 1's are __________ to each other then number of variables is __________ .
equivalent, even
complement, odd
complement, even
none of these

⇒ A dc power supply has no load voltage of 30 V and full load voltage of 25 V at full load current of 1 A. The output resistance and voltage regulation respectively are
5 Ω and 25%
25 Ω and 20%
5 Ω and 16.7%
25 Ω and 16.7%

⇒ The dc output voltage from a power supply
increases with higher values of filter capacitance and decreases with more load current
decreases with higher values of filter capacitance and increases with more load current
decreases with higher values of filter capacitance as well as with more load current
increases with higher values of filter capacitance as well as with more load current