Question is ⇒ Which of the following correctly declares a pointer to an array of intergers in C?, Options are ⇒ (A) int * P [20], (B) int * P, (C) int (* P) [20], (D) int * (P [20]), (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following correctly declares a pointer to an array of intergers in C?, Options are ⇒ (A) int * P [20], (B) int * P, (C) int (* P) [20], (D) int * (P [20]), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following correctly declares a pointer to an array of intergers in C?
A.	int * P [20] [Wrong Answer]
B.	int * P [Wrong Answer]
C.	int (* P) [20] [Correct Answer]
D.	int * (P [20]) [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The TTL output acts as a current sink in low state

Reason (R): The TTL input current is largest in low state.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A microcomputer has memory locations from 0000 to FFFF, each storing 1 byte. How many bytes can be the memory store?
12333
14666
16384
16655

⇒ Status register in the 8156 is read with
IN 20 H
OUT 20 H
either (a) or (b)
none of the above

⇒ Which of the following quantities have same dimension in emu and esu?

Current
Electrical power
Electrical energy

Select the answer as per following codes
1 only
1 and 2
2 and 3
1 and 3

⇒ Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 10¹² cm^-3. Density of electrons = 8 x 10¹³ cm^-3, mobility of conduction electron = 2.3 x 10⁴ cm²/ V-sec and mobility of holes = 100 cm²/V-sec.
0.43 Ω-m
0.34 Ω-m
0.42 Ω-m
0.24 Ω-m

⇒ A series RLC circuit is supplied from a variable frequency ac source. The resonant frequency is ω₀. The voltage across C is maximum at a frequency
equal to ω₀
slightly less than ω₀
slightly more than ω₀
none of the above

⇒ Windows can run several tasks simultaneously.
TRUE
FALSE

⇒ The maximum percent overshoot with maximum value of first overshoot as 3.5 V and steady state value as 2.575 V is
0.3592
0.2643
0.5761
0.1524

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in band-width
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope over load error
C.	Finer quantization	3.	Nyquist rate of signals
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1

⇒

Assertion (A): In class A amplifier the distortion is minimum

Reason (R): In class A amplifier collector current exists for 360° of input cycle

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ For the circuit of figure the input and output Miller resistances
5 kΩ each
1 ohm and 5 kΩ respectively
5 kΩ and 1 ohm respectively
1 ohm each

⇒ Figure shows an RC circuit. The magnitude plot V₂/V_{1will rise exponentially to R₂/(R₁ + R₂) as ω → ∞
will rise linearly to R₂/(R₁ + R₂) as ω → ∞
will decrease to zero as ω → ∞
will rise 1 at ω = 0 and then decrease as ω → ∞}

⇒ The number of flags available in 6800 are
6
5
7
4

⇒ Three Mod-16 counters are connected in cascade. The maximum counting range is
16
256
4096
none of the above

⇒ In Pascal if I = 55, 10 * I div 10 =
55
50
5.5
5

⇒ The value of 2⁵ in octal system is
40
20
100
200

⇒ In microprocessor 8088
8 data bits are multiplexed with 8 least significant bits of address bus
8 data bits are multiplexed with 8 most significant bits of address bus
16 data bits are multiplexed with 16 bits of address bus
none of the above

⇒ The switch in the circuit shown was on position a for a long time, and is moved to position b at time t = 0. The current i(t) for t > 0 is give
0.2e^-125tu(t) mA
20e^-1250tu(t) mA
0.2e^-1250tu(t) mA
20e^-1000tu(t) mA

⇒ E_G for silicon is 1.12 eV and that for germanium is 0.72 eV. Therefore it can be concluded that
more number of electron-hole pairs will be generated in silicon than in germanium at room temperature
less number of electron hole pairs will be generated in silicon than in germanium at room temperature
equal number of electron-hole pairs will be generated in both at lower temperatures
equal number of electron-hole pairs will be generated in both at higher temperatures

⇒ A current of 1 A in the coil of an iron cored electromagnet cause a flux density of 0.2.T. If the current is 2 A, B=
0.2 T
0.4 T
0.4 T or less
0.4 T or more

⇒ PIN diode has
p⁺ and n layers separated by i layer
p⁺ and n⁺ layers separated by i layer
p^- and n^- layers separated by i layer
none of the above

⇒ In a receiver, which of the following device has RF input but IF output?
Loudspeaker
Frequency changer
Demodulator
Audio amplifier

⇒ When an SCR is in forward blocking mode, the applied voltage
appears across only one junction
is equally shared by two junctions
is equally shared by three junctions
may appear across one or more junctions

⇒ If a line is open circuited Z_in = Z₀ tanh (gl).
TRUE
FALSE

⇒ In rectangular waveguides the ratio of width to height is about
0.5
1
2
4

⇒ For a periodic signal with finite number of discontinuities in each period, at isolated points of discontinuity the series converges to __________ .
difference value of signal on either side of discontinuity
highest value of signal on either side of discontinuity
average value of signal on either side of discontinuity
sum of value of signal on either side of discontinuity

⇒ How many free electrons does a p type semiconductor has?
only those produced by thermal energy
only those produced by doping
those produced by doping as well as thermal energy
any of the above

⇒

Assertion (A): In a CRT, grid is kept at negative potential with respect to cathode.

Reason (R): The function of grid in an electronic tube is to control the number of electrons.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ For the current wave i = 10 + 10 sin θ, the rms value is
0.416666666666667
12.247 A
20 A
14.14 A

⇒ In figure what is the base current if V_BE = 0
10 mA
9.3 mA
10 μA
9.3 μA