Question is ⇒ Which of the following circuits can operate class AB for audio power output?, Options are ⇒ (A) Emitter follower, (B) Push pull, (C) Cascade, (D) Darlington pair, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following circuits can operate class AB for audio power output?, Options are ⇒ (A) Emitter follower, (B) Push pull, (C) Cascade, (D) Darlington pair, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following circuits can operate class AB for audio power output?
A.	Emitter follower [Wrong Answer]
B.	Push pull [Wrong Answer]
C.	Cascade [Wrong Answer]
D.	Darlington pair [Correct Answer]
View Answer 3 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz?
0.6698
0.7698
0.503
0.6598

⇒ Three analog signals, having bandwidths 1200 Hz, 600 Hz, 600 Hz are sampled at their Nyquist rates, encoded with 12 bit words, and time division multiplexed. The bit rate for the multiplexed signal is
115.2 kbps
28.8 kbps
57.6 kbps
38.4 kbps

⇒ The resonance frequency is
ω_r = a
ω_r = b
ω_r = k
ω_r = ba

⇒ In the transformer shown in figure, the inductance measured across terminal 1 and 2 was 4 H with terminals 3 and 4 open. It was 3H when terminals 3 and 4 are short circuited. The coefficient of couplin
1
0.707
0.5
indeterminate due to insufficient data

⇒ The maximum effective aperture of λ/2 (half-wave) antenna is
0.013 λ²
0.13 λ²
1.3 λ²
13 λ²

⇒ In a two stage cascade amplifier, each stage has a gain of 10 dB and noise figure of 10 dB. The overall noise factor is
10
1.09
1
10.9

⇒ Two identical FETs each having parameters g_m and r_d are connected is parallel. The composite FET has parameters
0.5 g_m and 2 r_d
0.5 g_m and 0.5 r_d
2 g_m and 2 r_d
2 g_m and 0.5 r_d

⇒ The current I_CBO
increases with increases in temperature
is normally greater for silicon transistor than germanium transistors
mainly depends on the emitter base junction bias
depends largely on the emitter doping

⇒ In a radio receiver with simple AGC
the highest AGC voltage is produced between stations
an increase in signal strength produces more AGC
the audio stage gain is normally controlled by AGC
the faster the time constant of AGC, more accurate the output

⇒ In a series RLC circuit excited by e = E_m sin ωt is seen that LC < 1/ω². Then
I lags E
I leads E
I leads E are in phase
voltage across L and C are equal

⇒ Consider the following statements regarding sources or error in a Q-meter:

If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.
If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.
The presence of distributed capacitance in a coil modifies the effective Q of the coil.

Which of the above statements are correct?
1, 2 and 3
1 and 2 only
2 and 3 only
1 and 3 only

⇒ The resistance of a dc galvanometer is 20 Ω. A current of 10 mA causes full scale deflection. To convert it into 0-300 V voltmeter, we have to use a series resistance of
30000 Ω
29980 Ω
6000 Ω
15 Ω

⇒ A single-sideband (SSB) signal contains 3 kW. The power content of the carrier is __________ kW.
2
2
3
0

⇒ Which of the following has a major role in implementation of functions calls in C?
Processor's registers
Data segment
The heap
System stack

⇒

Assertion (A): The reverse current in a p-n junction is nearly constant.

Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ With increasing temperature, the electrical conductivity of metals
increases
decreases
increases first and then decreases
remains unaffected

⇒ The most important set of specifications of transformer oil includes
dielectric strength and viscosity
dielectric strength and flash point
flash point and viscosity
dielectric strength, flash point and viscosity

⇒ 110.11₂ x 110₂ = __________ ₁₀
40.5
30.5
20.5
10.5

⇒ Which of the following circuits can operate class AB for audio power output?
Emitter follower
Push pull
Cascade
Darlington pair

⇒ Number of cards read per minute by a card reader may be of the order of
20
1
10000
300

⇒ The widely used binary multiplication method is
repeated addition
add and shift
shift and add
any of the above

⇒ Karnaugh map can not be drawn when the number of variables is more than 4
TRUE
FALSE

⇒ Narrow band FM signal can be represented as
A cos (2pf_ct) - βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_mt) - βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_ct) + βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_mt) + βA sin (2pf_mt) sin (2pf_ct)

⇒

Assertion (A): 2's complement arithmetic is preferred in digital computers

Reason (R): The hardware required to obtain 2's complement is simple.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In an R-S latch, race condition occurs when
R is low and S is high
R and S are high
R and S are low
R is high and S is low

⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output frequency of the carrier will be
26 kHz
260 kHz
26 MHz
260 MHz

⇒ The phase angle of lead circuit is
between 0 and -90°
between 0 and +90°
90°
more than 90°

⇒ The properties of FETs resemble closely to
UJT
current transformer
thyristor
thermionic valves

⇒ A square in which each (i, j)^th element of matrix is equal to the negative of the conjugate complex of (j, i)^th element, is called
Hermitian matrix
Skew symmetric matrix
Conjugate anti-symmetric matrix
Skew-Hermitian matrix

⇒ Which of the following characteristics of a silicon p-n junction diode make it suitable for use as ideal diode?

It has low saturation current.
It has high value of cut in voltage.
It can withstand large reverse voltage.
When compared with germanium diode, silicon diode shows a lower degree of temperature dependence under reverse conditions.

Select the answer using the given below
1 and 2
1, 2, 3, 4
2, 3, 4
1, 3