Question is ⇒ Which of the following can have negative temperature coefficient?, Options are ⇒ (A) Compounds of silver, (B) Liquid metals, (C) Metallic alloys, (D) Electrolytes, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following can have negative temperature coefficient?, Options are ⇒ (A) Compounds of silver, (B) Liquid metals, (C) Metallic alloys, (D) Electrolytes, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following can have negative temperature coefficient?
A.	Compounds of silver [Wrong Answer]
B.	Liquid metals [Wrong Answer]
C.	Metallic alloys [Wrong Answer]
D.	Electrolytes [Correct Answer]
View Answer 16 -9 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The flow of current in solids is due to
electrons
electrons and ions
atoms
nucleus

⇒ The dimensions of the emf of a source of current are that of
Force
Electric field
Current
Potential

⇒ Water is an excellent solvent because its molecules are
Neutral
High polar
Non-polar
Anodes

⇒ The electric current in a liquid is due to the flow of
Electrons only
Positive ions only
Negative and positive ions both
Electrons and positive ions both

⇒ An electrical lamp consumes 100 W of power. If the supply voltage is 220V the energy consumed in 30 minutes is
0.005 kWh
0.05 kWh
0.5kWh
5kWh

⇒ The resistance of human body is around
5 ohms
25 ohms
250 ohms
1000 ohms

⇒ It becomes more difficult to remove
any electron from the orbit
first electron from the orbit
second electron from the orbit
third electron from the orbit

⇒ How may 200 W/220 V incandescent lamps connected in series would consume the same total power as a single 100 W/220 V incandescent lamp?
not possible.
4
3
2

⇒ Which ofthe following lamps will have least resistance at room temperature?
25 W, 220V
100 W, 220V
200W, 220 V
60W, 220 V

⇒ Pure metals generally have
high conductivity and low temperature coefficient.
high conductivity and large temperature coefficient.
low conductivity and zero temperature coefficient.
low conductivity and high temperature coefficient.

⇒ Which is the best conductor of electricity?
Iron
Silver
Copper
Carbon

⇒ The draft velocity of electrons is
larger than speed of light.
almost equal to speed of light
equal to speed of light.
very small in comparison to speed of light.

⇒ The unit of Peltier coefficient is
JC^-1
JA^-1
JV^-1
None of these

⇒ Ohm's law is not applicable to
vacuum tubes
carbon resistors
high voltage circuits
circuits with low current densities

⇒ Which of the following is not equivalent to watts?
amperes x volts.
(amperes)² x ohm.
amperes/volt.
joules per second.

⇒ Electric pressure is also called
resistance
power
voltage
energy

⇒ The equivalent resistance in series combination is
Smaller than the largest resistance
Larger than the largest resistance
Smaller than the smaller resistance
Larger than the smallest resistance

⇒ Resistance of carbon filament lamp____as the applied voltage increases
increases
decreases
remains same
none of the above

⇒ If a very flexible wire is laid out in the shape of a hair pin with its two ends secured, what shape will the wire tend to assume if a current is passed through it?
Parabolic.
Straight line.
Circle.
Ellipse.

⇒ For a fixed supply voltage the current flowing through a conductor will increase when its
area of x-section is reduced.
length is reduced.
length is increased.
length is increased and x-sectional area is reduced.

⇒ When electric current passes through a metallic conductor, its temperature rises. This is due to
collisions between conduction electrons and atoms
the release of conduction electrons from parent atoms
mutual collisions between metal atoms
mutual collisions between conducting electrons

⇒ What is converted into heat when current is set up through a conductor ?
Electric current
Electric potential
Electric energy
None of these

⇒ Which of the following statements is incorrect?
Resistance is a passive element.
Inductor is a passive element.
Current source is a passive element.
Voltage source is an active element.

⇒ The fuse-wire is made of
Copper
Tungsten
Lead-tin alloy
Nichrome

⇒ A 100 watt light bulb burns on an average of 10 hours a day for one week. The weekly consumption of energy will be ____unit/s.
7
70
0.7
0.07

⇒ Four 100 W bulbs are connected in parallel across 200 V supply line. If one bulb gets fused
no bulb will light.
all the four bulbs will light.
rest of the three bulbs will light.
none of the above.

⇒ Which of the following relation is not correct?
P = ^V
^R²

P = VI
I = √P/R
V = √PR

⇒ One newton metre is same as
one watt
one joule
five joules
one joule second

⇒ A 500 W, 220 V bulb is supplied with 110V. Power consumption by the bulb will be
slightly less than 125 W
slightly greater than 125 W
exactly 125 W
250 W

⇒ Sparking occurs when a load is switched off because the circuit has high
resistance
inductance
capacitance
impedance