Question is ⇒ Which of the following can be used to convert PPM into PWM?, Options are ⇒ (A) Integrator, (B) Astable multivibrator, (C) Bistable multivibrator, (D) Monostable multivibrator, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following can be used to convert PPM into PWM?, Options are ⇒ (A) Integrator, (B) Astable multivibrator, (C) Bistable multivibrator, (D) Monostable multivibrator, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following can be used to convert PPM into PWM?
A.	Integrator [Wrong Answer]
B.	Astable multivibrator [Wrong Answer]
C.	Bistable multivibrator [Correct Answer]
D.	Monostable multivibrator [Wrong Answer]
View Answer 1 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following characteristics of a silicon p-n junction diode make it suitable for use as ideal diode?

It has low saturation current.
It has high value of cut in voltage.
It can withstand large reverse voltage.
When compared with germanium diode, silicon diode shows a lower degree of temperature dependence under reverse conditions.

Select the answer using the given below
1 and 2
1, 2, 3, 4
2, 3, 4
1, 3

⇒ In a cascade amplifier, the intermediate stages are always in
CC configuration
CB configuration
CE configuration
any of the above

⇒ In a class C operation
V_CC is much larger than V_CE(sat)
V_CC is much smaller than V_CE(sat)
V_CC and V_CE(sat) are nearly equal
none of the above

⇒ The quantum numbers associated with electron motion are designed as
a, b, c
h, k, l
n, m, l
h, n, l

⇒ Consider the following statements regarding sources or error in a Q-meter:

If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.
If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.
The presence of distributed capacitance in a coil modifies the effective Q of the coil.

Which of the above statements are correct?
1, 2 and 3
1 and 2 only
2 and 3 only
1 and 3 only

⇒ Inverter 74 LS04 has following specifications I_0H max = - 0.4 mA, I_{0L max} = 8 mA, I_{IH max} = 20 μA, I_{IL max} = 0.
10
20
60
100

⇒ In 8085, out of interrupts given below, one particular interrupts is quite different from others, This interrupt is
RST 5.5
RST 6.5
RST 7.5
none of these

⇒ Consider the following statements: In a differential amplifier using JFET, the differential output offset is due to

mismatch between FET parameters
difference in values of resistances used in circuit
variation in supply voltage.

Of the statements, the correct statements are
1 and 2
1, 2, 3
2, 3
1, 3

⇒ Which one of the following is the correct sequence of the numbers represented in the series given below?
2, 3, 4, 5, 6......
2, 4, 6, 8, 10 .....
2, 4, 6, 10, 12......
2, 4, 6, 10, 16 .....

⇒ An iron specimen has µ_r = 1000 when B = 0.3 T. If B = 0.35 T, µ_r
will be 1000
will be less than 1000
will be more than 1000
may be more or less than 1000

⇒ A system has 12 poles and 2 zeros. Its high frequency asymptote in its magnitude plot has a slope of
-200 dB/decade
-240 dB/decade
-280 dB/decade
-320 dB/decade

⇒ The power consumption of a present day colour TV receiver is about
8 W
80 W
200 W
400 W

⇒ The amplifier network is shown bel
6.42 kΩ, 5.6 kΩ
6.42 Ω, (5.62) kΩ
6.4kΩ, (5.62) kΩ
6.42 Ω, 5.6 kΩ

⇒ The antenna current of an AM transmitter is 8 A. When only the carrier is sent, but it increases to 8.93 A. when the carrier is sinusoidally modulated. The percentage modulation is nearly
0.9
0.8
0.75
0.7

⇒ Four sig
2f₀
3f₀
4f₀
8f₀

⇒

Assertion (A): If integral control action is included in the controller the offset can be eliminated.

Reason (R): Integral control action may lead to oscillatory response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A tweeter should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ Which of the following are true for magic tee in the given figure select the answer as per given c
1, 2 and 3
1, 2 and 4
2, 3 and 4
1, 3 and 4

⇒ If i_b is plate current, e_b is plate voltage and e_c is grid voltage the v-i curve of a vacuum triode
0.5 and 1
- 2 and 1
30 and 1
30 and 1.5

⇒ In 8085 the pins for + 5 V input and ground are
20 and 40 respectively
40 and 20 respectively
1 and 2 respectively
1 and 1 respectively

⇒ The z-transform of a particular signal is gi
casual and stable
non-casual and stable
non-casual and unstable
casual and unstable

⇒ The output y(t) of a continuous-time system S for the input x(t) is given
S is linear and time-invariant
S is linear and time-varying
S is non-linear and time-invariant
S is non-linear and time-varying

⇒ A retriggerable one shot is one which
can be triggered only once
has two quasi stable states
can not be retriggered till the complete pulse appears at output
can be retriggered while the output is being generated

⇒ When Z₁ << Z, The circuit of figure work
inverting amplifier
Schmitt trigger
non-inverting amplifier
source follower

⇒ In floating point number 0110100000010101, the exponent is equal to __________ ₁₀
11
-11
10
-10

⇒ 4 bit 2's complement representation of a decimal number is 1000. The number is
8
0
-7
-8

⇒

Assertion (A): The scale a PMMC ammeter is linear.

Reason (R): The deflecting torque of PMMC is proportional to current in the coil.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In intrinsic semiconductor at 300 K, the magnitude of free electron concentration in silicon is about
15 x 10⁴ per cm³
5 x 10¹² per cm³
1.45 x 10¹⁰ per cm³
1.45 x 10⁶ per cm³

⇒ At room temperature, the current in the, intrinsic semiconductor is due to
holes
electrons
ions
holes and electrons

⇒ For the system in the given fi
y_k = u_k + 0.5 y_{k - 2}
y_k = u_k + 0.5 u_{k - 2}
y_k = u_k - 0.5 y_{k - 2}
y_k = u_k - 0.5 u_{k - 2}