Question is ⇒ Which of the following best represents the bandwidth of an actual op-amp?, Options are ⇒ (A) 100 Hz to 1 MHz, (B) 0 Hz to 100 kHz, (C) 0 Hz to 10 MHz, (D) 0 Hz to infinity, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following best represents the bandwidth of an actual op-amp?, Options are ⇒ (A) 100 Hz to 1 MHz, (B) 0 Hz to 100 kHz, (C) 0 Hz to 10 MHz, (D) 0 Hz to infinity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following best represents the bandwidth of an actual op-amp?
A.	100 Hz to 1 MHz [Wrong Answer]
B.	0 Hz to 100 kHz [Correct Answer]
C.	0 Hz to 10 MHz [Wrong Answer]
D.	0 Hz to infinity [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements in amplitude modulation

The harmonic and intermodulation distortion may occur in audio and RF amplifiers
The sum and difference frequencies are present in the output of mixer
The diode detector has audio frequencies in its output
A balanced modulator cannot produce an AM with suppressed carrier

Which of the above are true?
1, 2, 3, 4
1, 2, 3
1, 2
3, 4

⇒ Convolution of x(t + 5) with impulse function δ(t - 7) is equal to
x(t - 2)
x(t + 12)
x(t - 12)
(t + 2)

⇒ A 16:1 multiplexer has 4 select input lines.
TRUE
FALSE

⇒ i₁(t) for t > 0 is give
2.5 - 2.5e^-2t
2.5 - 1.25e^-2t
1.25 - 1.25e^-2t
None of these

⇒ A clamper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ In telephone systems, load is expressed in the unit of
erlangs
decibels
bells
watts

⇒ For a good conducting medium the intrinsic impedance is
σωμ ∠p/2
ωμ /σ ∠45°
ωμ/σ ∠p/2
ωμ/σ ∠0°

⇒ The given figure shows a control system. The maximum value of gain for which the system is stabl
3
3
4
5

⇒ The units for electrochemical equivalent are
grams
grams per coulomb
gram-coulomb
grams per ampere

⇒ A dielectric of relative permittivity ∈_r is subjected to a homogeneous electric field E. The dipole moment P per unit volume is given by
P = constant
P = ∈₀ E
P = ∈₀(∈_r - 1) E
P = ∈_r E

⇒ For the output F to be 1 in the logic circuit shown, the input combination shoul
A = 1, B = 1, C = 0
A = 1, B = 0, C = 0
A = 0, B = 1, C = 0
A = 0, B = 0, C = 1

⇒

Assertion (A): Two terminal black boxes of R and C can be identified by plotting their static V-I characteristics.

Reason (R): The V-I characteristic of resistance is a straight line of slope R passing through origin.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Compared to a p-n junction with N_A = N_D = 10¹⁴/cm³, which one of the following statements is TRUE for a p-n junction with N_A = N_D = 10²⁰/cm³?
Reverse breakdown voltage is lower and depletion capacitance is lower
Reverse breakdown voltage is higher and depletion capacitance is lower
Reverse breakdown voltage is lower and depletion capacitance is higher
Reverse breakdown voltage is higher and depletion capacitance is higher

⇒ In the network shown in figure, the voltage drops across R₂ and R₃ are 10 V and 16 V with polarities as shown. The current in R_{1is 9 A and directed towards node 0
is 9 A and directed away from node 0
is 9 A but directed of current cannot be found
is impossible to be found}

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then Find width of major lobe for broadside
6°
5.73
51.25
0°

⇒ The characteristic equation of an SR flip-flop in given by
Q_n+1 = S + RQ_n
Q_n+1 = RQ_n + SQ_n
Q_n+1 = S + RQ_n
Q_n+1 = S + RQ_n

⇒ In a resistor the current is i and the voltage is v. The rate of dissipation of heat at any time t is
vi
vit
vt
vit²

⇒ The numerical value of directivity of current element of half-wave dipole is 1.76 and 2.15 dB respectively. The directive gain of half-wave dipole over current element will be
3.91 dB
1.95 dB
0.39 dB
0.195 dB

⇒ In the given figure the ratio T/d is the duty fac
TRUE
FALSE

⇒ Panel instruments are generally mounted vertically.
TRUE
FALSE

⇒ A helical antenna is used for satellite tracking due to its
good front to back ratio
broad bandwidth
circular polarization
both (a) and (b)

⇒ A push pull amplifier is a
power amplifier
voltage amplifier
current amplifier
both power and current amplifier

⇒ X COPY is an internal DOS command.
TRUE
FALSE

⇒ At present, the radio-frequency band mainly used by most satellites is
EHF
UHF
VHF
SHF

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ Given I_s = 20 A, V_s = 20 V, the current I in the 3 Ω resistance is give
0.166666666666667
0.333333333333333
0.0833333333333333
16 A

⇒ There is no radiation at right angles to the plane of the array, is end fire array.
TRUE
FALSE

⇒ The presence of some holes in an intrinsic semiconductor at room temperature is due to
valence electrons
doping
free electrons
thermal energy

⇒ The direction of pick up in a CD is
linear from centre towards edge
linear from edge to centre
nonlinear from centre to edge
nonlinear from edge to center

⇒ The capacitance of a parallel plate capacitor varies as per the equation C(t) = C₀ (1 - cos ωt). It is connected to a battery of V volts. The equation for current is
ωC₀V (1 - cos ωt)
ωC₀V(1 - sin ωt)
ωC₀V (1 - sin 2ωt)
ωC₀V sin ωt