Question is ⇒ Which of the following are the constants of the transmission lines ?, Options are ⇒ (A) Resistance, (B) Inductance, (C) Capacitance, (D) All of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following are the constants of the transmission lines ?, Options are ⇒ (A) Resistance, (B) Inductance, (C) Capacitance, (D) All of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following are the constants of the transmission lines ?
A.	Resistance [Wrong Answer]
B.	Inductance [Wrong Answer]
C.	Capacitance [Wrong Answer]
D.	All of the above [Correct Answer]
View Answer 13 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a D.C. 3-wire distribution system, balancer fields are cross-connected in order to
boost the generated voltage
balance loads on both sides of the neutral
make both machines run as unloaded motors
equalize voltages on the positive and negative outers

⇒ If the height of transmission tower is increased, which of the following; parameters is likely to change ?
Capacitance
Inductance
Resistance
All of the above

⇒ For an overhead line, the surge impedance is taken as
20-40 ohms
70-80 ohms
100-200 ohms
500-1000 ohms

⇒ Which of the following is not a constituent for making porcelain insulators ?
Quartz
Kaolin
Felspar
Silica

⇒ A 3-phase 4 wire system is commonly used on
primary transmission
secondary transmission
primary distribution
secondary distribution

⇒ By using bundle conductors, the critical voltage for the formation of corona will
remain same
decrease
increase
not occur

⇒ Poles which carry transformers are usually
circular
I-type
A-type
H-type

⇒ Which of the following is usually not the generating voltage ?
6.6 kV
8.8 kV
11 kV
13.2 kV

⇒ Which of the following is neglected in the analysis of short transmission lines ?
Series impedance
Shunt admittance
I²R loss
None of the above

⇒ If the voltage is increased x times, the size of the conductor would be
reduced to 1/x² times
reduced to 1/x times
increased x times
increased to x² times

⇒ Besides a method of trial and error, which of the following methods is employed for solution o f network problems in interconnected system ?
Circulating current method
Thevenin's theorem
Superposition of currents
Direct application of Kirchhoff's laws

⇒ The use of strain type insulators is made where the conductors are
dead ended
at intermediate anchor towers
any of the above
none of the above

⇒ The frequency of voltage generated, in case of generators, can be increased by
using reactors
increasing the load
adjusting the governor
reducing the terminal voltage

⇒ Corona usually occurs when the electrostatic stress in air around the conductor exceeds
6.6 kV (r.m.s. value)/cm
11 kV (r.m.s. value)/cm
22 kV (maximum value)/cm
30 kV (maximum value)/cm

⇒ Overhead system can be designed for operation upto
11 kV
33 kV
66 kV
400 kV

⇒ When the interconnector between two stations has large reactance
the transfer of power will take place with voltage fluctuation and noise
the transfer of power will take place with least loss
the stations will fall out of step because oflarge angular displacement, between the stations
none of the above

⇒ For which of the following, the excitation control method is satisfactory ?
Low voltage lines
High voltage lines
Short lines
Long lines

⇒ The string efficiency of an insulator can be increased by
correct grading of insulators of various capacitances
reducing the number of strings
increasing the number of strings in the insulator
none of the above

⇒ The effective resistance of a conductor will be the same as 'ohmic resistance' when
power factor is unity
current is uniformly distributed in the conductor cross-section
voltage is low
current is in true sine wave form

⇒ In aluminium conductors, steel core is provided to
compensate for skin effect
neutralise proximity effect
reduce line inductance
increase the tensile strength

⇒ Multicore cables generally use
square conductors
circular conductors
rectangular conductors
sector-shaped conductors

⇒ The ground ring transmission lines are used to
reduce the transmission losses
reduce the earth capacitance of the lowest unit
increase the earth capacitance of the lowest unit
none of the above

⇒ The charging current in the cables
leads the voltage by 180°
leads the voltage by 90°
lags the voltage by 90°
lags the voltage by 180°

⇒ The voltage regulation in magnetic amplifier type voltage regulator is effected by
electromagnetic induction
varying the resistance
varying the reactance
variable transformer

⇒ The size of the earth wire is determined by
the atmospheric conditions
the voltage of the service wires
the ampere capacity of the service wires
none of the above

⇒ The electrostatic stress in underground cables is
zero at the conductor as well as on the sheath
same at the conductor and sheath
minimum at the condactor and minimum at the sheath
maximum at the conductor and minimum at the sheath

⇒ Skin effect is noticeable only at ____ frequencies
audio
low
high
all

⇒ In overhead transmission lines the effect of capacitance can be neglected when the length of line is less than
80 km
110 km
150 km
210 km

⇒ The operating voltage of high voltage cable's is upto
1.1 kV
3.3 kV
6.6 kV
11 kV

⇒ The material used for the manufacture of grounding wires is
cast iron
aluminium
stainless steel
galvanised steel