Question is ⇒ Which of the following antennas is λ /4 length?, Options are ⇒ (A) Dipole, (B) Marconi, (C) Monopole, (D) Parabolic, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following antennas is λ /4 length?, Options are ⇒ (A) Dipole, (B) Marconi, (C) Monopole, (D) Parabolic, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following antennas is λ /4 length?
A.	Dipole [Correct Answer]
B.	Marconi [Wrong Answer]
C.	Monopole [Wrong Answer]
D.	Parabolic [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Fourier analysis indicate that a square wave can be represented as
a fundamental sine wave and odd harmonics
a fundamental sine wave and even harmonics
a fundamental sine wave and harmonics
fundamental and subharmonic sine waves

⇒ In a 7 segment LED display, the minimum number of segments is activated when the input decimal number is
0
1
2
3

⇒ Ohmic range of carbon composition resistors is
10 to 100 ohms
10 to 10 K ohms
10 to 200 ohms
10 to 25 M ohms

⇒ A n-channel JFET has I_DSS = 2 mA, Gate to source voltage V_GS = - 2 V and trans-conductance is 0.5 mW then pinch-off voltage is __________ .
- 2 V
2 V
- 4 V
4 V

⇒ In a synchro error detector, the output voltage is proportional to [ω(t)]ⁿ, where ω(t) is the rotor velocity and n equals :
-2
-1
1
2

⇒ The conversion or collector circuit efficiency is a measure
how successfully the active device converts D.C. power to A.C. signal power
how much distortion in output is reduced with respect to input
how successfully the active device converts A.C. power to D.C. signal power
none of the above

⇒ Which of the following devices exhibit negative resistance characteristics?
UJT
PUT
Both UJT and PUT
UJT, PUT and SBS

⇒ In drawing phasor diagram
rms values are used
peak values are used
either rms or peak values are used
either rms or peak or averages values are used

⇒ An SSB-AM signal cannot be demodulated by
Balanced modulator
Complete phase shift generator
Diode balanced modulator
Product detector

⇒ The input 3-dB frequency is :
100 Hz
148 Hz
100 kHz
None

⇒ In figure, capacitor is used to develop pulses of short duration and large duty cycle across R₂ when switch is closed. Which of the following combinations is best sui
R₁ and R₂ large but C small
R₁ and R₂ small but C large
R₁ and C large and R₂ small
R₂ and C large but R₁ small

⇒ In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
all calculations done earlier have to be repeated
replace all calculated voltages by reverse values
replace all calculated currents by reverse values
replace all calculated voltages and currents by reverse values

⇒ An RLC series circuit is excited by a step voltage E. The circuit current at t = 0 is
E/R
E/LC
zero
infinity

⇒ In a base driver amplifier the voltage gain is the ratio of
ac collector voltage to ac base voltage
ac emitter voltage to ac base voltage
ac collector voltage to ac emitter voltage
ac base voltage to ac emitter voltage

⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
31 V
32 V
insufficient data
none of these

⇒ The sampling frequency in CD is 10 kHz.
TRUE
FALSE

⇒ The effect of lead resistance is important in measurement of
resistance of shunt
resistance of shunt winding
resistance of ammeter
both (a) and (c)

⇒ A dc separately excited motor has constant field current. The armature is fed from a single phase supply through a full converter. When a = 0, speed is 500 rpm. If a = 45°, the speed is likely to be
about 350 rpm
about 250 rpm
about 175 rpm
about 125 rpm

⇒ Consider the following:

Coupling capacitor
Emitter by-pass capacitor
Emitter to base diffusion capacitance of the BJT
Stray capacitance of the circuit.

Which of these components in a R-C coupled amplifier control the lower cut-off frequency of the amplifier?
1 and 2
2 and 3
3 and 4
l and 4

⇒ In AM receiver the oscillator frequency is
always equal to signal frequency
always equal to 455 kHz
always higher than signal frequency
always lower than signal frequency

⇒ In order to achieve accuracy, the slide wire of a potentiometer should be
as long as possible
as short as possible
neither too long nor too short
very thin

⇒ Which of the following 8 bit microprocessors has maximum addressing modes?
8085
Z 80
6800
6809

⇒ The units for electric dipole moment are
coulombs
colomb-metre
coulomb/metre
coulomb/m²

⇒ A 4 bit down counter starts counting from 1111 irrespective of modulus.
TRUE
FALSE

⇒ For a short dipole having an effective length less than half the wavelength the radiation resistance is
proportional to length
proportional to square root of length
proportional to square of length
none of the above

⇒ Some features of advanced mobile phone service are

To provide telephone communication to a large number of telephone users within the area of a metropolitan only
To use minimum amount of frequency spectrum
To permit hand held as well as vehicle operation of telephone

Which of the above are true?
1 and 2 only
1, 2, 3
1 and 3 only
2 and 3 only

⇒ Power monitor and reflectometer use the principle of
directional coupler
klystron amplifier
Gunn diode
TWT

⇒ The decimal equivalent of binary 1101.11 is
9.75
13.75
11.5
11.75

⇒ As compared to a BJT amplifier circuit, a JFET amplifier circuit
has low input impedance
has high input impedance
has very low input impedance
may have either low or high input impedance

⇒ The earliest uses of electromagnetic waves were
point to point communication
radar
both (a) and (b)
neither (a) nor (b)