Question is ⇒ Which of the following amplifier circuits has highest input impedance?, Options are ⇒ (A) Circuit using BJT, (B) Circuit using JFET, (C) Circuit using MOSFET, (D) Either (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following amplifier circuits has highest input impedance?, Options are ⇒ (A) Circuit using BJT, (B) Circuit using JFET, (C) Circuit using MOSFET, (D) Either (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following amplifier circuits has highest input impedance?
A.	Circuit using BJT [Wrong Answer]
B.	Circuit using JFET [Wrong Answer]
C.	Circuit using MOSFET [Correct Answer]
D.	Either (a) or (b) [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The gap width in audio heads is about 0.01 mm.
TRUE
FALSE

⇒ An n channel depletion type MOSFET has
lightly doped p substrate and highly doped n source and drain
highly doped p substrate and highly doped n source and drain
highly doped p substrate and lightly doped n source and drain
lightly doped n substrate and highly doped n source and drain

⇒ A voltage v = 100 sin (100 pt + 45°) V is applied to an impedance 10 + j10 ohm. The current is
10 ∠45° A
7.07 ∠45° A
5 ∠45° A
5 ∠0 A

⇒ A carrier is simultaneously modulated by two sine waves having modulation indices of 0.4 and 0.3. The total modulation index will be
0.1
0.7
0.5
0.35

⇒ A cavity resonator is
a hollow metallic enclosure
a hollow enclosure having magnetic material as its walls
a hollow enclosure having dielectric material as its walls
either (b) or (c)

⇒ The minimum gate source voltage that creates the n-type inversion layer is called
cut off voltage
on voltage
threshold voltage
zener voltage

⇒ Among the various modulation systems, the most favoured from the point of linearity of modulation and efficiency is
anode or collector modulation
central grid modulation
screen grid modulation
modulated oscillators

⇒ The most serious problems in ac bridge measurement is
eddy currents
leakage current
residual magnetism
stray fields

⇒

Assertion (A): In totem pole output the output impedance is low.

Reason (R): TTL gate with active pull up should not be used in wired AND connection.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The poles of an RC function
are simple and lie on jω axis
are simple and lie on negative real axis
may be complex conjugate
may be anywhere in s plane

⇒

Assertion (A): If an electron having charge e is revolving in an orbit of radius R and with angular velocity ω, the magnetic dipole moment of orbit is 0.5 eωR².

Reason (R): Orbital angular momentum and magnetic dipole moment are always equal.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the stabilized reactance modulator AFC system
phase modulation is converted into amplitude modulation by the equalizer circuit
the discriminator frequency must not be too low or the system will fail
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency, better the oscillator frequency stability

⇒ A gate in which shift register is connected as shown in the figure below. How many clock pulse (after reset to '0') the contents of the shift register are '000' ag
3
6
16
8

⇒ A single phase half wave rectifier is feeding a resistive load. As firing angle is increased
dc output voltage and rms output voltage decrease in the same proportion
dc output voltage and rms output voltage decrease
dc output voltage and rms output voltage increase
dc output voltage and rms output voltage increase in the same proportion

⇒ The hexadecimal number given below represent decimal numbers which are multiples of DC, C8, BE, 46, IE
2
6
7
10

⇒ A transistor has a current gain of 0.99 in the CB mode. Its current gain in the CC mode is
100
99
1.01
0.99

⇒ CD4010 is a
inverting buffer
non-inverting hex buffer
NOR IC
NAND IC

⇒ When time constant T in any factor is varied, the shapes of log magnitude and phase angle curves remain the same.
TRUE
FALSE

⇒ Consider the following statements:

Race around condition can occur in JK flip flop when both inputs are 1
A flip flop is used to store one bit of information
A transparent latch is a D type flip flop
Master slave flip flop is used to store two bits of information

Which of the above are correct?
1, 2, 3
1, 3, 4
1, 2, 4
2, 3, 4

⇒ To ensure that only dominant TE₁₀ mode propagates in a rectangular waveguide, the operating frequency
must be more than cutoff frequency of TE₁₀ mode
must be less than cutoff frequency of TE₂₀ mode
must be more than cutoff frequency of TE₁₀ mode and less than cutoff frequency of TE₂₀ mode
must be less than cutoff frequency of TE₁₀ mode

⇒ In figure v₁ = 8 V and v₂ = 8 V. Which diode will cond
D₁ only
D₂ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ Consider the directive T : DS105. This directive
directs the assembler to reserve a sequence of 105 bytes in the memory
directs the assembler to reserve a sequence of 105 bits in the memory
directs the assembler to reserve a sequence of consecutive 105 bytes in the memory
directs the assembler to reserve a sequence of consecutive 105 bits in the memory

⇒ Two voltages are 50 ∠0 V and 75 ∠ - 60° V. The sum of these voltages is
109 ∠ - 60° V
109 ∠ - 25° V
109 ∠ - 36.6° V
100 ∠ - 50.1° V

⇒ Find L_eq if each L is
4/3 H
1/3 H
2/3 H
3/2 D

⇒ In the given figure shows a 10dB directional coupler. If power input at port 1 is 100 mW, power output at port
10 mW
15 mW
20 mW
25 mW

⇒ In most electric irons, the thermister used for controlling temperature is
vapour-filled bulb
high-expansion steel rod
bimetallic strip
thermopile

⇒

Assertion (A): The phenomenon of differential mobility is called transferred electron effect.

Reason (R): GaAs exhibits transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For an op-amp source follower circuit
input and output voltages have same magnitude
output and input voltages are in phase
output and input voltages are in phase but have different magnitudes
output and input voltages have same magnitude and are in phase

⇒ Consider the following statement: In case of a superconductor

B = 0
μ_r is high
diamagnetism is high
transition temperature varies with isotopic mass.

Of the above statements
1 and 2 are correct
2, 3, 4 are correct
1, 3, 4 are correct
2, 4 are correct

⇒ Consider the following statements about a good power supply:

The a.c. ripple should be high
S_v, (Voltage stability factor) should be low
S_T, (Temperature stability factor) should be low

Which of the above statements are correct?
1, 2 and 3
2 only
3 only
2 and 3 only