Question is ⇒ Which of the following amplifier circuit using junction transistor has the best gain?, Options are ⇒ (A) Common base, (B) Common emitter, (C) Common collector, (D) All have the same gain, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following amplifier circuit using junction transistor has the best gain?, Options are ⇒ (A) Common base, (B) Common emitter, (C) Common collector, (D) All have the same gain, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following amplifier circuit using junction transistor has the best gain?
A.	Common base [Wrong Answer]
B.	Common emitter [Correct Answer]
C.	Common collector [Wrong Answer]
D.	All have the same gain [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In Modulation, "carrier" is
resultant wave
speech voltage to be transmitted
voltage with constant frequency, phase or amplitude
voltage for which frequency, phase or amplitude is varied

⇒ For full wave rectification four diode bridge rectifier is claimed to have following advantages:

Less expensive transformer
Small size transformer
Suitable for higher voltage applications

Which of these are correct?
1 and 2 only
1 and 3 only
2 and 2 only
1, 2, 3

⇒ On the basis of the type of chemical bonds, solids may be classified into
ionic crystals
ionic and valence crystals
ionic crystal, valence crystals and metals
ionic crystals, valence crystals, metal and vander wall crystals

⇒ Microprocessor 386SX is a 16/32 bit microprocessor. It has
16 bit registers and 32 bit data bus
16 bit registers and 16 bit data bus
32 bit registers and 32 bit data bus
32 bit register and 16 bit data bus

⇒ In an ac single phase energy meter, the potential coil is put on
both side limbs, of upper magnet
central limb of upper magnet
one side limb of upper magnet
either (a) or (b)

⇒ In a piezoelectric crystal, the application of mechanical force will cause
plastic deformation of crystal
magnetic dipoles in the crystal
electrical polarization in the crystal
shift in Fermi level

⇒ Which of the following does not cause losses in optical fibre cables?
Stepped index operation
Impurities
Microbending
Attenuation in glass

⇒ A 555 timer can be used as
an astable multivibrator
monostable multivibrator
frequency Divider only
any of the above

⇒ Consider the following Statements regarding resistance strain gauge

The gauge factor is in the range of 2 to 5.
The resistance changes due to change in specific resistance with strain.
The resistance increases with increase in temperature.

Of the above statements, which are correct?
1, 2, 3
1 and 2
2 and 3
1 and 3

⇒ Schmitt trigger can be used as a
comparator
square-wave generator
flip-flop
all of these

⇒ Volume control found on the front panel of television receivers
a ganged resistor
a variable resistor of logarithmic type
a variable resistor of linear type
a trimmer potentiometer

⇒ The ROC of sequence in the Z.T. of sequence x[n] = aⁿ ∪ [n] is
z > a
z < a
|z| > a
|z| < a

⇒ For a P-N junction diode, the current in reverse bias may be
few amperes
between 0.5 A and 1 A
few milliamperes
few micro or nanoamperes

⇒ The best excited reflector from a wave guide is
horn
parabolic
biconical
corner

⇒ In an n channel JFET, the gate is
n type
p type
either n or p
partially n & partially p

⇒ Windows have a user friendly program called 'Front Page Express' for creating web pages.
TRUE
FALSE

⇒ A radio wave is incident on a layer of ionosphere at an angle of 30° with the vertical. If the critical frequency is, 1.2 MHz, the maximum usable frequency is
1.2 MHz
2.4 MHz
0.6 MHz
1.386 MHz

⇒

Assertion (A): The maximum efficiency of a class B push pull amplifier is 78.5%

Reason (R): A current mirror uses a compensating diode in parallel with the emitter diode

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ An 8 bit transistor register has output voltage of low-high-low-high-low-high-low-high. The decimal number stored is
105
95
85
75

⇒ Consider an angle modulated si
10W
18W
20W
28W

⇒ In floating point representation, the accuracy is
10 bit
9 bit
8 bit
6 bit

⇒ A certain JK FF has t_pd = 12 nsec. The largest MOD counter that can be constructed from these FFs and still operate up to 10 MHz is
any
8
256
10

⇒ The applications of shift registers are

Time delay
Ring counter
Serial to parallel data conversion
Serial to serial data conversion

Which of the above are correct?
1, 2, 3
2, 3, 4
1, 2, 3, 4
1, 2, 4

⇒ A rectangular waveguide is a
rectangular conducting wire to propagate electromagnetic waves
hollow rectangular walled room carrying electromagnetic wave
hollow rectangular conducting tube through which electromagnetic waves can be propagated
tube antenna to transmit and receive electromagnetic waves

⇒ A Schottky diode clamp is used along with switching BJT for
reducing the power dissipation
reducing the switching time
increasing the value of β
reducing the base current

⇒ Let JCOKE = 98 and LPEPSI = 42 Consider the statement 103
106
109
none of the above

⇒ In a three phase to single phase full wave bridge cycloconverter, the number of thyristors is
36
18
12
8

⇒ When a semi-conductor is doped, its electrical conductivity
increases
decreases in the direct ratio of the doped material
decreases in the inverse ratio of the doped material
remains unaltered

⇒ For a transfer function the coefficients of the numerator and denominator polynomials in s must be real.
TRUE
FALSE

⇒ Identify which of the following is not a tree of the graph shown in fi
bcgh
defg
abfg
aegh