Question is ⇒ Which is a digital coding technique?, Options are ⇒ (A) PCM, (B) DM, (C) DPCM, (D) All, (E) , Leave your comments or Download question paper.

Question is ⇒ Which is a digital coding technique?, Options are ⇒ (A) PCM, (B) DM, (C) DPCM, (D) All, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which is a digital coding technique?
A.	PCM [Wrong Answer]
B.	DM [Wrong Answer]
C.	DPCM [Wrong Answer]
D.	All [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The number of bits in EBCDIC is
12
10
8
6

⇒ The inputs to logic gate are 0. The output is 1. The gate is
NAND or XOR
OR or XOR
AND or XOR
NOR or Ex-NOR

⇒

Match the following:

	List I		List II
A.	Firm ware	1.	Converts program in high level language to machine language
B.	Compiler	2.	Converts assembly language program into machine language
C.	Assembler	3.	Software embedded in hardware
D.	Virtual addressing	4.	Grouping information between various memories

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-3, B-4, C-1, D-2
A-3, B-1, C-2, D-4

⇒ ROC of sequence x[n] = δ[n] is
Not exist
z = 0
Entire Plane
Entire Plane expect z = 0, z = ∞

⇒ In the circuit shown, the device connected to Y5 can have address in the r
2000 - 20FF
2D00 - 2DFF
2E00 - 2EFF
FD00 - FDFF

⇒ AC hum is picked up from power cables
TRUE
FALSE

⇒ A parallel plate capacitor has its length, width and separation doubled. It fringing effects are neglected, to keep the capacitance same, the dielectric constant must be
halved
kept the same
doubled
made 4 times

⇒ In figure, V_CC = + 30 V, R₁ = 200 kΩ and R₂ = 100 kΩ. If V_BE = 0.7 V, the voltage a cross R_{E+20 V
+19.3 V
+10 V
+9.3 V}

⇒ A liquid has N permanent dipoles μ_p per unit volume and has been subjected to dc field for a long time such that orientation polarization is P₀. At t = 0, the field is suddenly removed, then polarization
will remain constant at P₀
will become zero at t = 0
will delay to zero with a time constant
either b or c

⇒ A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.
CMRR
bandwidth
slew rate
open-loop gain

⇒ In practical commercial FM system, channel bandwidth is
150 kHz
100 kHz
88 MHz
108 MHz

⇒ A TR (transmitter receiver) tube has
low loss for low power signals and high
high loss for low power signals and low loss for high level signal
low loss for both low level and high level signals
high loss for both low level and high level signals

⇒ A thermistor is a
thermocouple
thermometer
miniature resistance
heat sensitive explosive

⇒ If two network is connected in series-parallel connection then
h = [h_a] + [h_b]
[a_a] + [b_b]
[Z] = [Z_a] - [Z_b]
none

⇒ A tie set schedule shows
incidence of branches to nodes
incidence of branches to loops
incidence of nodes to loops
none of the above

⇒

Assertion (A): Hall effect is used to determine whether the semi- conductor is p or n type.

Reason (R): Under the influence of field, holes and electrons move in opposite direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A high pulse repetition frequency in a radar
increases the maximum range
decreases the maximum range
has no effect on the maximum range
either (a) or (b) depending on other factors

⇒ A ramp input applied to a unity feedback system results in 5% steady state error. The type number and zero frequency gain of the system are respectively.
1 and 20
0 and 20
0 and 1/20
1 and 1/20

⇒ Which of the following is not necessarily the advantage of SSB over double sideband, full carrier AM?
The signal is more noise resistant
More channel space is available
Transmitter circuits must be more stable, given better reception
Considerably less power is required for the same signal strength

⇒ Reception through space wave is limited to line of sight distance.
TRUE
FALSE

⇒ For 8 bit representation the minimum positive and minimum negative numbers are
2^-128 each
2^-28 and 2^-127
2^-127 and 2^-128
2^-127each

⇒

Match the following:

	List I		List II
A.	On-off	1.	steam kettle with different settings
B.	Proportional	2.	Elevator
C.	Cascade	3.	Robot-positioning
D.	Digital	4.	Domestic Refrigerator

A-4, B-2, C-3, D-1
A-2, B-4, C-1, D-3
A-3, B-1, C-4, D-2
A-4, B-2, C-1, D-3

⇒ In which function is each term known as minterm?
SOP
POS
Hybrid
Both SOP and POS

⇒ Which DOS command improves memory usage?
MEM MAKER
MOVE
MEM IM
None on the above

⇒ In a AM wave the carrier and one of the side bands is suppressed. If m = 0.5, the percentage saving in power is
0.5
0.833
0.944
1

⇒ Which of the following represents constant magnitude locus for M = 1?
x = -0.5
x = 0
x² + y² = 1
(x + 1)² + y² = 1

⇒ Which of the following is not the main characteristic of a FET?
Drain resistance
Forward transconductance
Temperature stability
Amplification factor

⇒ The leads in a TRIAC are denoted by
anode cathode, gate
T₁ T₂, gate
T₁, T₂, anode
T₁, T₂, T₃

⇒ The range of visible light is
300 to 2000 Å
200 - 4000 Å
4000 to 7700 Å
more than 10000 Å

⇒ In mode filter of the given figure which of the following modes is unaffe
TE₀₁
TE₁₀
TE₁₁
all TM