Question is ⇒ Which has volatile memory?, Options are ⇒ (A) Magnetic tape, (B) RAM, (C) Diskette, (D) Hard disk, (E) , Leave your comments or Download question paper.

Question is ⇒ Which has volatile memory?, Options are ⇒ (A) Magnetic tape, (B) RAM, (C) Diskette, (D) Hard disk, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which has volatile memory?
A.	Magnetic tape [Wrong Answer]
B.	RAM [Correct Answer]
C.	Diskette [Wrong Answer]
D.	Hard disk [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be
250 V
252 V
248 V
210 V

⇒ As access time is decreased, the cost of memory
remains the same
increases
decreases
may increase or decrease

⇒ With the switch in STOP position, Y will be equa
0
1
CLK
none of these

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
2 mA
1 mA
0.5 mA
3 mA

⇒ In a JK flip flop toggle means
set Q = 1 and Q = 0
set Q = 0 and Q = 1
change the output to the opposite state
no change in output

⇒ A Weston frequency meter is
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ An infinite ladder is constructed with 1 Ω and 2 Ω resistors as shown below. Find i
8.1818 A
0
0.375
cannot be determined

⇒ A conditionally stable system has
one phase crossover frequency
two phase crossover frequencies
two or more phase crossover frequencies
one or more phase crossover frequencies

⇒ An RL impedance function can also be realized as
RC impedance function
RC admittance function
LC impedance function
LC admittance function

⇒ In Z_RC (s) = 0 at s = ∞, the last element in first Cauer form is
R
C
R and C in series
R and C in parallel

⇒ The most effective anti jamming technique is
frequency hopping
spread-spectrum modulation
key leverage
once-only key

⇒ In figure the zener cur
is always 130 mA
may vary between 10 mA and 130 mA
may vary between 60 mA and 130 mA
is always equal to 65 mA

⇒ In figure, the reading of wattmeter will be proportio
V I cos θ
3 VI cos θ
3 VI sin θ
V I sin θ

⇒ Which of the following amplifiers has a voltage gain of less than 1?
CE
CC
CB
CE or CB

⇒ The following circuit is implementation of
Sum of full adder
Carry of half adder
Difference of full subtractor
<
(i) only
(iii) only
(ii) only
(i) and (ii)

⇒ Four memory chips of 16 x 4 size have their address buses connected together. This system will be of size
64 x 4
16 x 16
32 x 8
256 x 1

⇒ In the circuit of figure the current through 5 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ Mesh analysis is applicable __________ only.
planar network
non planar network
a circuit which contains only current sources
none

⇒ ISDN stands for
Integrated Services Digital Network
Inter Services Digital Network
Inter Subscriber Digital Network
integrated Subscriber Digital Network

⇒ Which of the following is not a non-linear element?
Transistor
Heater coil
Diode
Electric arc with unlike electrodes

⇒ The snubber circuit consists of
a capacitor connected in series with thyristor
a capacitor connected in parallel with thyristor
a resistor and capacitor in series connected across thyristor
none of the above

⇒ The signumm function written as [sgn(t)] is defined as
sgn(t) = - 1 for t < 0, = 0 for t = 0 and = 1 for t > 0
sgn(t) = 1 for t < 0, = 0 for t = 0 and = - 1 for t > 0
sgn(t) = 0 for t < 0, = 1 for t = 0 and = 0 for t > 0
sgn(t) = 0 for t < 0, = 1 for t³ 0

⇒
Assertion (A): Damping in a vibration galvanometer is small.
Reason (R): Vibration galvanometer is a PMMC instrument.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If f=0
X_L = 0 and X_C = 0
X_L = ∞, X_C = ∞
X_L = 0 and X_C = ∞
X_L = ∞ and X_C = 0

⇒ Transistor T₁ operates at 30 kHz and T₂ operates at 300 Hz. The flicker noise is
not depend on frequency
T₁ > T₂
T₁ = T₂
T₁ < T₂

⇒ In a JK Master slave flip flop
both master and slave are positively clocked
both master and slave are negatively clocked
master is positively clocked and slave is negatively clocked
master is negatively clocked and slave is positively clocked

⇒ To cover all inhabited regions of the Earth, the number of geosynchronous communication satellites required
5
3
10
2

⇒ The current I_CBO
increases with increases in temperature
is normally greater for silicon transistor than germanium transistors
mainly depends on the emitter base junction bias
depends largely on the emitter doping

⇒
Assertion (A): SSB transmitter is generally smaller than AM transmitter
Reason (R): SSB systems mostly use combined transmitter receiver.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which device changes parallel data to serial data?
Decoder
Multiplexer
Demultiplexer
Flip flop

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math