Question is ⇒ Which coupling produces the minimum interference with frequency response?, Options are ⇒ (A) RC coupling, (B) Transformer coupling, (C) Direct coupling, (D) Impedance coupling, (E) , Leave your comments or Download question paper.

Question is ⇒ Which coupling produces the minimum interference with frequency response?, Options are ⇒ (A) RC coupling, (B) Transformer coupling, (C) Direct coupling, (D) Impedance coupling, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which coupling produces the minimum interference with frequency response?
A.	RC coupling [Wrong Answer]
B.	Transformer coupling [Wrong Answer]
C.	Direct coupling [Correct Answer]
D.	Impedance coupling [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A high resistance was measured by loss of charge method. The voltmeter resistance was 10¹⁰ ohms. The calculation gave the value of unknown resistance as 0.8 x 10⁹ ohms. The true value of resistance is
0.8 x 10⁹ Ω
less than 0.8 x 10⁹ Ω
more than 0.8 x 10⁹ Ω
either (b) or (c)

⇒ The bridge is balanced when the value of R is
50 Ω
100 Ω
200 Ω
250 Ω

⇒ Which of the following exhibits negative resistance in a portion of its characteristics?
Tunnel diode
Zener diode
JFET
MOSFET and tunnel diode

⇒ IF V_CC = 15 V, V_CEQ = 5 V and I_CQ = 50 mA, the efficiency in class A operation is
1
0.5
0.25
0.167

⇒ An RLC series circuit is underdamped. To make it overdamped, the value of R
has to be increased
has to be decreased
has to be increased to infinity
has to be reduced to zero

⇒ When a TTL is driving an CMOS gates it is necessary to ensure that
V_OL(for TTL) ≤ V_IL (for CMOS) and V_0H (for TTL) ≥ VIH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS)
V_0H (for TTL) ≤ V_IH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS) and V_0H (for TTL) ≤ VIH (for CMOS)

⇒ Satellite communication systems use the frequency band
10 to 20 MHz
50 to 70 MHz
3 to 6 GHz
100 to 120 GHz

⇒ A system has high gain and phase margin. The system is
very stable
sluggish
very stable and sluggish
oscillatory

⇒ A 4 line to 16 line decoder has
16 inputs and 4 outputs
4 inputs and 16 outputs
either (a) or (b)
neither (a) nor (b)

⇒ The given figure shows a constant current source driving a parallel RC circuit. It is equivalen
a lag network
a lead network
a lag-lead network
either (a) or (b)

⇒ In which material do conduction and valence bands overlap
insulators
conductors
both conductor and semiconductor
semiconductors

⇒ In a rectangular waveguide cutoff wavelength for TE₁₀mode is 8 cm. Then cutoff wavelength for TE₂₀ mode is
8 cm
6 cm
4 cm
2 cm

⇒ The capacitance of a cylindrical capacitor is directly proportional to its length.
TRUE
FALSE

⇒ Which mode is called dominant mode in rectangular wave guide?
TE₀₁
TE₁₁
TE₁₀
TE₂₀

⇒ Which of the following memories normally has highest storage capacity?
Magnetic disc
Magnetic tape
Semiconductor memory
Core memory

⇒ If antenna diameter is increased four times, the maximum range is increased by a factor of
2
2
4
0.2

⇒ How many zone bits are th
2
4
8
16

⇒ The maximum concentration of the element which can be dissolved in solid silicon at a given temperature is termed as
Solid solubility
Dissolution coefficient
Solidification index
Concentration index

⇒ What is the minimum value of VSWR that may exist on a transmission line?
Less than zero
Zero
One
10

⇒ An LED has a rating of 2 V and 10 mA. It is used along with 6V battery. The range of series resistance is
0 to 200 Ω
200 - 400 Ω
200 Ω and above
400 Ω and above

⇒ The discrete time system describes by y(n) = x(n²) is
casual, Linear, time varying
casual, non-linear, timevari
non-casual, Linear, time invariant
non-casual, non-linear, time variant

⇒ A fully controlled bridge converter can operate in quadrants
1
1 and 2
1 and 3
1 and 4

⇒ The dead zone in a pyrometer is 0.125% of span. The calibration is 400°C to 1000°C. What temperature change might occur before it is detected.
0.125°C
0.75°C
0.4°C
1°C

⇒ The damping ratio of a pair of complex poles when expressed in terms of angle θ measured from jω axis equal to
sin θ
cos θ
tan θ
cot θ

⇒ The system in the given figur
type 0 system
type 1 system
type 2 system
type 3 system

⇒ In a dynamometer instrument, the moving coil is pressure coil.
TRUE
FALSE

⇒ In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is
9 kΩ
6 kΩ
3 kΩ
2 kΩ

⇒ Find resistance R_B to bring transistor to threshold of saturation (V_CB = 0), V_BE = 0.7 V, a =
1.5 KΩ
15 KΩ
10 KΩ
1 KΩ

⇒ The distance of a direct broadcasting satellite from earth's surface is about
1000 km
10000 km
36000 km
55000 km

⇒ The electrical power to a megger is provided by
battery
inverter
permanent magnet dc generator
ac generator