Question is ⇒ Which camera tube has highest dark current?, Options are ⇒ (A) Plumbicon, (B) Vidicon, (C) Saticon, (D) GCD imager, (E) , Leave your comments or Download question paper.

Question is ⇒ Which camera tube has highest dark current?, Options are ⇒ (A) Plumbicon, (B) Vidicon, (C) Saticon, (D) GCD imager, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which camera tube has highest dark current?
A.	Plumbicon [Correct Answer]
B.	Vidicon [Wrong Answer]
C.	Saticon [Wrong Answer]
D.	GCD imager [Wrong Answer]
View Answer 4 -3 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following statements is incorrect regarding Balun transformer?
It changes impedance like current transformer
It changes balanced to unbalanced line
It is used to couple a co-axial line to a parallel line wire
Any of the above

⇒

Match the following:

	List I		List II
A.	Tunnel diode	1.	is also known as hot carrier diode
B.	PIN diode	2.	used with reverse bias
C.	Zener diode	3.	has an intrinsic layer
D.	Schottky diode	4.	v-i curve has shape of N

A-2, B-3, C-1, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1
A-1, B-2, C-3, D-4

⇒ A quiescent state of a transistor implies
zero bias
no output
no distortion
no input signal

⇒ In the television system in India, the aspect ratio is
0.16875
0.127777777777778
0.211111111111111
0.170138888888889

⇒ Find R_TH across the terminals A a
52.28 Ω
58.28 Ω
52.82 Ω
58.82 Ω

⇒ A transistor amplifier is operating in class A mode. If a transformer is connected for impedance matching, the efficiency will
increase
decrease
not be affected
increase or decrease

⇒ The impedance of an RC series circuit is 12 Ω at f= 50 Hz. At f= 200 Hz, the impedance will be
more than 12
less than 3
more than 3 Ω but less than 12 Ω
more than 12 Ω but less than 24 Ω

⇒ If f_s be the signal frequency and f_i be the intermediate frequency then image frequency is given by
f_s + f_i
f_s ± f_i
f_s ± 2f_i
f_s + 2f_i

⇒ Without a spectrum analyser, it is not possible to determine
carrier frequency
antenna pattern
pulse width
spurious signal strength and its location

⇒ In a microwave resistor the wall thickness is made as small as possible to
have high value of R
have low value of R
minimize capacitive effect
reduce inductance

⇒ The generally used value of EHV supply in TV receivers is
1 kV per diagonal cm
1 kV per diagonal inch
0.5 kV per diagonal cm
0, 5 kV per diagonal inch

⇒

Assertion (A): When a square periodic wave is applied to an RC circuit, the voltage across capacitor is observed to be a triangular periodic wave.

Reason (R): The RC circuit works as integrator and its time constant is much larger than time period of input wave.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Microwave signals follow the curvature of the earth and the phenomenon
tropospheric scatter
faraday effect
duct propagation
none

⇒ In a fascimile reproduction time to scan one line is 2 ms. If it has 4% blanking, the visible trace time is
1.92 ms
2.08 ms
50 ms
0.08 ms

⇒ If C is spring constant and θ is deflection, controlling torque is
Cθ
C/θ
θ/C
C²θ

⇒ A multivibrator generates
sinusoidal waveforms
non-sinusoidal waveforms
both (a) and (b)
none of the above

⇒ Consider an incremental vector element of length ΔL and angle between an electric field E and ΔL s cos &the
In the direction of E
In opposite direction of E
In the angle of 45° with E
In the angle of 60° with E

⇒ Ferrite have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ The Shannon-Hartley law
refers to noise
defines bandwidth
describes signalling rate
refers to distortion

⇒ The emitter coupled pair of BJT's gives a linear transfer relation between the differential output voltage and the differential input voltage V_id only when the magnitude of V_id is less a times the thermal voltage, where a is
4
3
2
1

⇒ The current I in the circuit show
- j1 A
j1 A
0
20 A

⇒ A Weston frequency meter is
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is
0.76, 0.24
0.95, 0.3
0.24, 0.76
0.3, 0.95

⇒

Assertion (A): The turn on time of SCR is about 1 to 4 ms.

Reason (R): The turn off time of SCR is about 10 to 300 ms.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in backward direction. A moving coil ammeter is also connected in the circuit. The reading of ammeter will be
0.416666666666667
0.208333333333333
3.185 A
14.14 A

⇒ MTSO stands for
Metropolitan Telecommunication Subscribers Office
Metropolitan Telecommunication Switching Office
Mobile Telecommunication Switching Office
Mobile Telecommunication Subscriber Office

⇒ At FM demodulator output noise power density
increases with frequency
decreases with frequency
remains unaltered
none of the above

⇒ Which of the following is a valid expression in FORTRAN 77?
B * - 3
B * (- 3)
B * * - 3
B * + 2

⇒

Assertion (A): Hall effect is used to determine whether the semi- conductor is p or n type.

Reason (R): Under the influence of field, holes and electrons move in opposite direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true