Question is ⇒ Which antenna is a wideband antenna?, Options are ⇒ (A) Hertz antenna, (B) Marconi antenna, (C) Folded dipole, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which antenna is a wideband antenna?, Options are ⇒ (A) Hertz antenna, (B) Marconi antenna, (C) Folded dipole, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which antenna is a wideband antenna?
A.	Hertz antenna [Wrong Answer]
B.	Marconi antenna [Wrong Answer]
C.	Folded dipole [Correct Answer]
D.	None of the above [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A copper atom is neutral. Its core has a net charge of
0
1
-1
2

⇒ In which configuration is ac collector voltage zero?
CE
CB
CC
none of the above

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T⁴I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	ML²T^-3I²

A-1, B-2, C-3
A-2, B-1, C-3
A-2, B-3, C-1
A-3, B-2, C-1

⇒ QAM stands for
Quasi-Amplitude Modulation
Quadrature Angle Modulation
Quadrature Amplitude Modulation
None of the above

⇒ Fourier transform of non periodic DT signal is
aperiodic
Periodic
both a and b
None of these

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in backward direction. A moving coil ammeter is also connected in the circuit. The reading of ammeter will be
0.416666666666667
0.208333333333333
3.185 A
14.14 A

⇒ Each of two cascaded stages has a voltage gain of 30. The overall gain is
3
9
30
900

⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?
636 pF
180 pF
65 pF
30 pF

⇒ The unit for mmf is
A
Wb
T
V

⇒ A coaxial line has L = 500 nH/m and C = 50 pF/m. The characteristic impedance is
500 Ω
250 Ω
100 Ω
50 Ω

⇒ The 8085 instruction LDA FFA is an example of
Direct addressing
Register addressing
Immediate addressing
Register indirect addressing

⇒ In figure the output V₀
2V₁ + V₂ - 2V₃
2(V₁ + V₂) - V₃
V₁ + V₂ + V₃
V₁ + 2V₂ - V₃

⇒ Antenna used for T.V. broadcasting is
long dipole
metal horn
crossed dipole
log periodic

⇒ The p mode of operation of magnetron signifies that
the phase difference between adjacent anode poles is p radians
the phase difference between adjacent anode poles is a multiple of p radians
the total phase shift around the periphery is p radians
none of the above

⇒ The advantage of FET over BJT is
high input impedance
lower noise
no thermal runaway
all of the above

⇒ In a uniform plane wave E and H are related by
E/H = 1
E/H = ε/μ
E/H = μ/ε
none of the above

⇒ Two coils X of 1000 turns and Y of 2000 turns are placed such that 60% of the flux produced by coil X links coil Y. A current of 1 A in coil X produces 0.1 wb flux. The mutual inductance between coils is
0.12 H
0.08 H
0.06 H
0.04 H

⇒ Three Mod-16 counters are connected in cascade. The maximum counting range is
16
256
4096
none of the above

⇒ In a modulator it is found that the amplitude spectrum consists a component at f_c, the carrier frequency and one component each at f_c - f_s and f_c + f_s where f_s is the modulating signal frequency. Then the modulator used is
AM
AM or MBFM with modulation index 0.5
FM
PAM

⇒ Consider the cascade structure of two filte
1 and 3
only 2
2 and 3
only 3

⇒ The JFET in the circuit shown in figure has an I_DSS = 10 mA and V_p = -5V. The value of the resistance R_s for a drain current I_DS = 6.4 m
156 Ω
470 Ω
560 Ω
1 kΩ

⇒ The Depth of penetration of EM wave in medium having conductivity σ at a frequency of 1 MHz is 25 cm. The depth of penetration at a frequency of 4 MHz will be
6.25 cm
12.50 cm
50 cm
100 cm

⇒ End fire array is called a linear resonant dipole array.
TRUE
FALSE

⇒ A square corner reflector is used in
radio astronomy
tv broadcast
point to point communication
all of the above

⇒ As compared to TTL, CMOS logic has
higher speed of operation
higher power dissipation
smaller physical size
all of the above

⇒

Assertion (A): The conductivity of an n type semiconductor increases with increase in temperature and increase in density of donor atoms.

Reason (R): Diffusion of carriers occurs in semiconductors.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The addition of a pole to the open loop transfer function pulls the root locus
to the right
to the left and making the system more stable
towards right or left depending on the position of new pole
none of the above

⇒ Poor power factor
reduces load handling capability of electrical system
results in more power losses in the electrical system
overloads alternators, transformers and distribution lines
all

⇒ The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded
The diode is a silicon diode
The diode is a germanium diode
Break down voltage of the diode is 0.7 V
At 1 V rated current will pass through the diode