Question is ⇒ Which amplifier will be preferred for highest gain?, Options are ⇒ (A) Darlington's pair, (B) Single stage amplifier, (C) Cascade amplifier, (D) Depends on the circuitry, (E) , Leave your comments or Download question paper.

Question is ⇒ Which amplifier will be preferred for highest gain?, Options are ⇒ (A) Darlington's pair, (B) Single stage amplifier, (C) Cascade amplifier, (D) Depends on the circuitry, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which amplifier will be preferred for highest gain?
A.	Darlington's pair [Wrong Answer]
B.	Single stage amplifier [Wrong Answer]
C.	Cascade amplifier [Correct Answer]
D.	Depends on the circuitry [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In laboratory experiment the output from reflex klystron is moderated by square wave because
it is easy to generate a square wave
crystal diode operates in square law region of i-v characteristics
it prevents frequency modulation
detector circuit is less complicated

⇒ In full wave rectification, if the input frequency is 50 Hz, then frequency at the output of filter is
50 Hz
0 Hz
100 Hz
75 Hz

⇒ The circuit in figur
CE amplifier
CB amplifier
Constant voltage source
Constant current source

⇒

Match the following:

	List I (Transducer)		List II (Quantity measured)
A.	LVDT	1.	Pressure
B.	Bourden gauge	2.	Temperature
C.	Strain gauge	3.	Displacement
D.	Thermistor	4.	Stress

A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-4, B-1, C-3, D-2
A-3, B-1, C-4, D-2

⇒ A parallel ac circuit in resonance will
act like a resistor of low value
have a high impedance
have current in each section equal to the line current
have a high voltage developed across each inductive and capacitive section

⇒ Hall effect is observed in a specimen when it is carrying current and is placed in a magnetic field. The resulting electric field inside the speciment will be in
direction normal to both current and magnetic field
the direction of current
direction antiparallel to magnetic field
an arbitrary direction depend upon conductivity

⇒ In a second order system with a unit step input, the speed of response is high if system is
overdamped
undamped system
critically damped
underdamped

⇒ In a series RC circuit Z = (R² + ω²C²)^0.5.
TRUE
FALSE

⇒ When a wave reaches an open circuit
the voltage at termination is doubled the incident voltage
the current at termination is doubled the incident voltage
the voltage at termination is zero
both V and I at termination are doubled the incident voltage and current

⇒ In every practical oscillator the loop gain is slightly more than unit and amplitude of oscillations is limited by
magnitude of loop gain
onset of non-linearity
magnitude of gain
β

⇒

Match the following:

	List I		List II
A.	Resistance	1.	Current noise
B.	Diode	2.	Partition noise
C.	Triode	3.	Shot noise
D.	p-n junction	4.	Atmospheric noise
		5.	Johnson noise

A-5, B-3, C-2, D-1
A-1, B-2, C-3, D-5
A-3, B-5, C-1, D-2
A-3, B-5, C-2, D-1

⇒ The range of floating point numbers in Java is
1.4 E - 45 to 3.4 E + 38
3.4 E - 45 to 1.4 E + 38
1.4 E - 38 to 3.4 E + 45
3.4 E - 38 to 1.4 E + 45

⇒ Which of the following is not correct?
In SSB amplitude modulated system, the transmitter circuit has to be more stable leading to better reception
In SSB amplitude modulated system more channel space is available as compared to double sideband amplitude modulated system
In SSB amplitude modulated system the signal is more noise resistant as compared to double sideband system
An SSB-AM system requires lesser power (for the same signal strength) as compared to DSB-AM system

⇒ ADM stands for
Angle Delta Modulation
Angle Digital Modulation
Adaptive Delta Modulation
Adaptive Digital Modulation

⇒ A 3 bit up-down counter can count from
000 to 111
111 to 000
000 to 111 and also from 111 to 000
none of the above

⇒ For measuring a very high resistance we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (a) or (c)

⇒ Shifting digits from left to right and vice versa is needed in
storing numbers
arithmetic operations
counting
storing and counting

⇒ Alternating current can induce voltage because it has magnetic field which is
constant
time varying
stronger field than D.C.
closed loop nature.

⇒ The seven segment display used in watches and clocks generally uses
LED
LCD
Photodiode
FET

⇒ The application of gate signal decreases the break over voltage of on SCR.
TRUE
FALSE

⇒ The number of PM radio channels which can be accommodated in a spectrum of 300 MHz is about
10
100
500
1500

⇒ (sI - A)^-1 is equal to
adj (sI - A)/det (sI - A)
det (sI - A)/adj(sI - A )
[adj (sI - A)] [det(sI - A)]
none of the above

⇒

Match the following:

	List I		List II
A.	Firm ware	1.	Converts program in high level language to machine language
B.	Compiler	2.	Converts assembly language program into machine language
C.	Assembler	3.	Software embedded in hardware
D.	Virtual addressing	4.	Grouping information between various memories

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-3, B-4, C-1, D-2
A-3, B-1, C-2, D-4

⇒ Tropospheric scatter propagation is not subject to any fading.
TRUE
FALSE

⇒ The difference between sequential and combinational circuits is
Combinational circuits store bits
Combinational circuits have memory
Sequential circuits store bits
Sequential circuits have memory

⇒ Radiowaves are electromagnetic waves having frequency range
0.001 to 50 H
0.001 to 50 kHz
0.002 to 50 MHz
0.001 to 10¹⁶ Hz

⇒ In a centre tap full wave rectifier, 50 V is the peak voltage between the centre tap and one of the ends of the secondary. The maximum voltage across the reverse biased diode will be
100 V
72 V
50 V
38 V

⇒ The impedance of a coil above self-resonant frequency is
inductive
capacitive
resistive
none

⇒ In the figure, the
emits light when both S₁ and S₂ are closed
emits light when both S₁ and S₂ are open
emits light when only S₁ and S₂ is closed
does not Emit light, irrespective of the switched positions

⇒ Burden of an instrument transformer is expressed in
A
V-A
Ω
watt