Question is ⇒ When Z<sub>1</sub> << Z, The circuit of figure work, Options are ⇒ (A) inverting amplifier, (B) Schmitt trigger, (C) non-inverting amplifier, (D) source follower, (E) , Leave your comments or Download question paper.

Question is ⇒ When Z<sub>1</sub> << Z, The circuit of figure work, Options are ⇒ (A) inverting amplifier, (B) Schmitt trigger, (C) non-inverting amplifier, (D) source follower, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When Z₁ << Z, The circuit of figure work
A.	inverting amplifier [Wrong Answer]
B.	Schmitt trigger [Wrong Answer]
C.	non-inverting amplifier [Wrong Answer]
D.	source follower [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Microwave resonators are used in
microwave oscillators
microwave narrow band amplifier
microwave frequency metres
all of the above

⇒ The SID data received is
LSB first
LSB last
1
none of these

⇒ The secondary constants of a line are
Z₀
Z₀ and γ
Z₀, γ and wave velocity
Z₀, γ and L

⇒ For a given voltage four heating coils will give maximum heat when connected
in parallel
in series
with two parallel pairs in series
with one pair in parallel and the other two in series

⇒ For the circuit in figure, fed by a unit step voltage, v_{c1 - e^-t/RC
e^-t/RC
e^t/RC
1}

⇒ In all metals
conductivity decreases with increase in temperature
current flow by electrons as well as by holes
resistivity decreases with increase in temperature
the gap between valence and conduction bands is small

⇒ The temperature coefficient of resistance for a thermistor is
low and negative
low and positive
high and negative
high and positive

⇒ Which mode is usually preferred for cascading?
CE
CB
CC
Any of the above

⇒ The chemical effect of current is used in
dc ampere hour meter
dc ammeter
ac energy meter
all of the above

⇒ A conditionally stable system is stable for the value of gain between two critical values. It is unstable if
the gain is increased beyond upper critical value
the gain is decreased below lower critical value
both (a) and (b)
none of the above

⇒ The accuracy of a multimeter is about
± 0.5%
± 3%
± 0.01%
± 10%

⇒ In a Hurwitz polynomial
all coefficients are non-negative
the coefficients may be positive or negative
all coefficients are negative
all coefficients are non-negative and all zeros should be either in left half plane or simple on the imaginary axis

⇒ DS directive in 8085
forces the assembler to reserve one byte of memory
forces the assembler to reserve a specified number of bytes in the memory
forces the assembler to reserve a specified number of consecutive bytes in the memory
none of the above

⇒ The minimum decimal equivalent of the number 11C0 is
183
194
268
269

⇒

Assertion (A): When a square periodic wave is applied to an RC circuit, the voltage across capacitor is observed to be a triangular periodic wave.

Reason (R): The RC circuit works as integrator and its time constant is much larger than time period of input wave.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Astable multivibrator has
one stable state
two stable state
two quasi-stable states
one quasi stable state

⇒ If output power of a radio receiver is doubled, its volume is increased by __________ dB.
2
3
1
-3

⇒ Consider the following stateme
1 and 2
1 and 3
2 and 3
3 only

⇒ The impedance parameter z₂₁ is
transfer impedance at port 1 with port 2 open circuited
transfer impedance at port 1 with port 2 short circuited
transfer impedance at port 2 with port 1 open circuited
transfer impedance at port 2 with port 1 short circuited

⇒ A transistor amplifier with 85% efficiency is expected to be
class A
class B
class C
class AB

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ In a telephone system, the grade of service means
the quality of sound reception at the receiver telephone
the probability that a called for connection is established
the type of wires cables used for the system
none of the above

⇒ If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.
800 to 1000
200, 800, 1000, 1800
only 200
only 1800

⇒ A Shockley diode can be used
in place of SCR
as a trigger switch for SCR
in place of UJT
both in place of SCR and as a trigger switch for SCR

⇒ A medium is said to be isotropic when
∈ = 0
∈ = μ
∈ = σ
∈ is scalar constant

⇒ In the circuit shown below, the outputs Y₁ and Y₂ for the given initial condition Y₁ = Y₂ = 1 and after four input pulses wil
Y₁ = 1, Y₂ = 0
Y₁ = 0, Y₂ = 0
Y₁ = 0, Y₂ = 1
Y₁ = 1, Y₂ = 1

⇒ Consider the following symbols

Letters A to Z and a to z
Digits 0 to 9
Logical operators and, or, not
Parenthesis ( )

Which of the above symbols are available in Pascal?
1 and 2 only
1, 2 and 3 only
1, 2 and 4 only
All

⇒ Metals approach superconductivity conditions
near absolute zero temperature
near critical temperature
at triple point
under the conditions of high temperature and pressure

⇒ The radix of a hexadecimal system is
2
3
8
16

⇒ The sensitivity of a voltmeter using 0-5 mA meter movement is
50 Ω/V
100 Ω/V
200 Ω/V
500 Ω/V