Question is ⇒ When there is an electric current through a conducting wire along its length, then an electric field must exist., Options are ⇒ (A) Outside the wire but normal to it, (B) Outside the wire but parallel to it, (C) Inside the wire but parallel to it, (D) Inside the wire but normal to it, (E) , Leave your comments or Download question paper.

Question is ⇒ When there is an electric current through a conducting wire along its length, then an electric field must exist., Options are ⇒ (A) Outside the wire but normal to it, (B) Outside the wire but parallel to it, (C) Inside the wire but parallel to it, (D) Inside the wire but normal to it, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When there is an electric current through a conducting wire along its length, then an electric field must exist.
A.	Outside the wire but normal to it [Wrong Answer]
B.	Outside the wire but parallel to it [Wrong Answer]
C.	Inside the wire but parallel to it [Correct Answer]
D.	Inside the wire but normal to it [Wrong Answer]
View Answer 6 -17 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Two lamps 100 W and 40 W are connected in series across 230 V (alternating). Which of the following statement is correct?
100 W lamp will glow brighter
40 W lamp will glow brighter
Both lamps will glow equally bright
40 W lamp will fuse

⇒ A 500 W, 220 V bulb is supplied with 110V. Power consumption by the bulb will be
slightly less than 125 W
slightly greater than 125 W
exactly 125 W
250 W

⇒ "The total electric flux through any closed surface surrounding charges is equal to the amount of charges enclosed."
The above statement is based on
Maxwell's law.
Ampere's law.
Gauss's law.
Coulomb's law.

⇒ How may 200 W/220 V incandescent lamps connected in series would consume the same total power as a single 100 W/220 V incandescent lamp?
not possible.
4
3
2

⇒ Which of the following relation is incorrect?
P = VI
P = IR
P = V/R²
P = V²/R

⇒ Out of the following which is not a poor conductor?
Cast iron
Copper
Carbon
Tungsten

⇒ The resistance of human body is around
5 ohms
25 ohms
250 ohms
1000 ohms

⇒ What is the nature of graph between temperature and thermoelectric power ?
Parabola
Straight line
Hyperbola
None of these

⇒ The flow of electric current in a conductor is due to flow of
electrons.
protons.
electrons and ions.
charged particles.

⇒ The electric current in a liquid is due to the flow of
Electrons only
Positive ions only
Negative and positive ions both
Electrons and positive ions both

⇒ Three 6 ohm resistors are connected to form a triangle. What is the resistance between any two corners?
3/2 ω
6 ω
4 ω
8/3 ω

⇒ The unit of Peltier coefficient is
JC^-1
JA^-1
JV^-1
None of these

⇒ Which of the following statement is correct?
A semi-conductor is a material whose conductivity is same as between that of a conductor and an insulator
A semi-conductor is a material which has conductivity having average value of conductivity of metal and insulator
A semi-conductor is one which conducts only half of the applied voltage
A semi-conductor is a material made of alternate layers of conducting material and insulator

⇒ An electric fìlamentbulb can be worked from
D.C. supply only
AC. supply only
Battery supply only
All above

⇒ The dimensions of the emf of a source of current are that of
Force
Electric field
Current
Potential

⇒ Two wires A and B of the same material and length l and 2l have radius r and 2r respectively. The ratio of their specific resistance will be
1 : 1
1 : 2
1 : 4
1 : 8

⇒ If the efficiency of a machine is to be high, what should be low?
Input power
Losses
True component of power
kWh consumed

⇒ Ohm's law in point form in field theory can be expressed as
V = RI
J = ^E/_σ
J = σE
R = ρ^l/_A

⇒ The minimum charge on an ion is
equal to the atomic number of the atom
equal to the charge of an electron
equal to the charge of the number of electrons in an atom
zero

⇒ The minimum requirements for causing flow of current are
a voltage source, a resistor and a switch.
a voltage source and a conductor.
a power source and a bulb.
a voltage source, a conductor, an ammeter and a switch.

⇒ Switching of a lamp in house produces noise in the radio. This is because switching operation produces
arcs across separating contacts
mechanical noise of high intensity
both mechanical noise and arc between contacts
none of the above

⇒ For testing appliances, the wattage of test lamp should be
very low
low
high
any value

⇒ Which of the following could be th value of resistivity of copper?
1.72 x 10^-4 ω-m
1.72 x 10^-5 ω-m
1.72 x 10^-6 ω-m
1.72 x 10^-7 ω-m

⇒ Three conductances in parallel have the values G1 = 2000 µ mho, G2 = 3000 µ mho and Gs = 4000 µ mho. The total conductance will be
6000 µ mho
7000 µ mho
9000 µ mho
10000 µ mho

⇒ Current velocity through a copper conductor is
the same as propagation velocity of electric energy
independent of current strength
of the order of a few µs/m
nearly 3x 10⁸ m/s

⇒ If Two bulbs of 500W and 200 W rated at 250 V will have resistance ratio as
4 : 25
25 : 4
2 : 5
5 : 2

⇒ The draft velocity of electrons is
larger than speed of light.
almost equal to speed of light
equal to speed of light.
very small in comparison to speed of light.

⇒ 1 microvolt is
1 x 10^-3 V
1 x 10^-4 V
1 x 10^-5 V
1 x 10^-6 V

⇒ Four 100 W bulbs are connected in parallel across 200 V supply line. If one bulb gets fused
no bulb will light.
all the four bulbs will light.
rest of the three bulbs will light.
none of the above.

⇒ Two bulbs 100 W, 250 V and 200 W, 250 V are connected in series across a 500 V line. Then
100 W bulb will be fused
200 W bulb will be fused
Both bulbs will be fused
No bulb will be fused