Question is ⇒ When the phase velocity of an EM wave depends on frequency in any medium the phenomenon is called, Options are ⇒ (A) scattering, (B) polarisation, (C) absorption, (D) dispersion, (E) , Leave your comments or Download question paper.

Question is ⇒ When the phase velocity of an EM wave depends on frequency in any medium the phenomenon is called, Options are ⇒ (A) scattering, (B) polarisation, (C) absorption, (D) dispersion, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When the phase velocity of an EM wave depends on frequency in any medium the phenomenon is called
A.	scattering [Wrong Answer]
B.	polarisation [Correct Answer]
C.	absorption [Wrong Answer]
D.	dispersion [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The line of sight communication requires that transmit and receive antennas to face each other. If the transmit antenna is vertically polarized, for the best reception the receive antenna should be
horizontally polarized
vertically polarized
at 45° with respect to horizontal polarization
at 45° with respect to vertical polarization

⇒ A 3-digit voltmeter having a resolution of 100 mV can be used to measure a maximum of
100 V
200 V
1000 V
5000 V

⇒ A directional coupler is used to determine
r_v
r_v and VSWR
L and C
wave velocity

⇒ Consider the following statements, regarding an OP AMP:

All types of negative feedback reduce non-linear distortion.
All types of negative feedback reduce the output offset voltage.
Non-inverting (current and voltage) feedback increases the input impedance.
Inverting (current and voltage) feedback decreases input impedance.

Which of the above statements is/are correct?
1 only
2 and 3 only
2 and 4 only
1, 2, 3 and 4

⇒ Figure is a 24 V_r stabilized power supply. The zener is 24 V, 600 mW. The minimum zener current is 10 mA. Proper values R and maximum load current
320 Ω, 10 mA
400 Ω, 15 mA
400 Ω, 10 mA
320 Ω, 15 mA

⇒

Assertion (A): ECL gate has very high speed of operation.

Reason (R): Transistors in ECL do not go into saturation region.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Consider the following statement in B
200, 250, 150 respectively
150, 200, 250 respectively
250, 200, 150 respectively
200, 150, 250 respectively

⇒ What can be the maximum dimension of an array in C language program?
3
4
5
It is compiler dependent

⇒ VSWR can have any value between
0 and 1
- 1 to + 1
0 to ∞
1 to ∞

⇒

Assertion (A): A transistor has lower voltage drop during conduction as compared to thyristor

Reason (R): Transistors are manufactured in very high voltage and current ratings.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Binary multiplication 1 x 0 =
1
0
10
11

⇒ A typical microcomputer has 65, 536 registers in its memory. It will be specified as
65.536 memory
65.536 K memory
64 K memory
8 K memory

⇒ For an npn transistor connected as shown in the figure V_BE = 0.7 volts. Given that reverse saturation current of the junction at room temperature 300K is 10^-13A, the emitter curr
30 mA
39 mA
49 mA
20 mA

⇒ In parallel in-parallel out shift register all bits are loaded and read simultaneously.
TRUE
FALSE

⇒ The first and second subscripts in models of circular waveguides depict
the number of full sine wave variations in circumference in direction and Bessel function variations in radial direction respectively
the Bessel function variations in radial direction and the number of full sine wave variations in circumference direction respectively
the Bessel function variations in circumference direction and number of full sine wave variations in radial direction respectively
none of the above

⇒ Ultra high frequency oscillators work in the range
20 Hz to 20 kHz
1 kHz to 30 kHz
30 kHz to 30 MHz
above 30 MHz

⇒ The h parameter equivalent circuit of BJT has one voltage source and one current source.
TRUE
FALSE

⇒ A 14 pin NOT gate 1C has __________ NOT gates.
8
6
5
4

⇒

Assertion (A): Snubber circuit has an RC series circuit in parallel with SCR

Reason (R): Voltage across a capacitor can not change instantaneously.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The terms RMS and average values apply only to sine waves.
TRUE
FALSE

⇒ A logical expression Y = A + AB is equal to
Y = AB
Y = AB
Y = A + B
Y = A + B

⇒ If the bandwidth is increased by 2, the γ_FM γ_AM (where γ is the ratio of SNR of output to SNR at input, FM is frequency modulation and AM is amplitude modulation) is increased by a factor of
2
3
4
6

⇒ Breakdown in dielectric may be
electrical breakdown
thermal breakdown
electrochemical breakdown
any of the above

⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
31 V
32 V
insufficient data
none of these

⇒ A stationary process has
all statistical properties independent of time
all statistical properties dependent of time
zero variance
ensemble average equal to time average

⇒ If the temperature of on extrinsic semiconductor is increased so that the intrinsic carrier concentration is doubled, then
the majority carrier density doubles
the minority carrier density doubles
the minority carrier density becomes 4 times the original value
both majority and minority carrier densities double

⇒

Assertion (A): A p-n junction is used as rectifier.

Reason (R): A p-n junction has low resistance in forward direction and high resistance in reverse direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The instruction LDA 20 in 8085 means
contents of memory location 20 are fetched into the accumulator
the value 20 is fetched into accumulator
either (a) or (b)
neither (a) nor (b)

⇒ Transverse electric (TE) waves have
electric field component E in the direction of propagation
magnetic field component H in the direction of propagation
magnetic field component H in the direction of propagation and no component of electric field E in this direction
electric field component E in the direction of propagation and no component of magnetic field H in this direction

⇒ If noise margin is high, there is lesser chance of false operation.
TRUE
FALSE