Question is ⇒ When the length of antenna is a whole wavelength, Options are ⇒ (A) the radiation at right angles is zero, (B) the radiation at right angles is maximum, (C) the radiation is zero in all directions, (D) the radiation is maximum in all directions, (E) , Leave your comments or Download question paper.

Question is ⇒ When the length of antenna is a whole wavelength, Options are ⇒ (A) the radiation at right angles is zero, (B) the radiation at right angles is maximum, (C) the radiation is zero in all directions, (D) the radiation is maximum in all directions, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When the length of antenna is a whole wavelength
A.	the radiation at right angles is zero [Correct Answer]
B.	the radiation at right angles is maximum [Wrong Answer]
C.	the radiation is zero in all directions [Wrong Answer]
D.	the radiation is maximum in all directions [Wrong Answer]
View Answer 4 -3 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ FIR filter Passes __________ Phase.
non-linear phase
linear phase
variable phase
none

⇒

Assertion (A): For networks in figure (1) and (2) sum of products of branch voltages and branch currents at any time is zero.

Reason (R): The networks in figure (1) and (2) are not the same structura
Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I		List II
A.	RC coupled amplifier	1.	Very low drift
B.	Tuned amplifier	2.	Flat frequency response from zero frequency onwards
C.	Chopper stabilized amplifier	3.	Flat frequency response with upper and lower cut off frequency
D.	DC amplifier	4.	Peak in gain frequency response

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1

⇒ When an electric field E is applied to solid and liquid insulating materials, the internal field E_i acting at the location of atom is such that
E_i = E
E_i > E
E_i < E
E_i may be equal to or less than E

⇒

Match the following:

	List I (Instrument)		List II (Measured quantity)
A.	Hot wire	1.	only voltage
B.	PMMC	2.	phase
C.	Electrostatic	3.	true RMS value
D.	Lock in Amplifier	4.	dc value

A-3, B-2, C-1, D-4
A-1, B-4, C-2, D-3
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1

⇒ In 8085 microprocessor, an interrupt service request is serviced
immediately on receipt of request
after the execution of the current instruction is completed
at the end of the current machine cycle
none

⇒

Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage

Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For parallel RLC circuit, which one of the following statements is NOT correct?
The bandwidth of the circuit deceases if R is increased
The bandwidth of the circuit remains same if L is increased
At resonance, input impedance is a real quantity
At resonance, the magnitude of input impedance attains its minimum value

⇒ In the field controlled motor the entire damping comes from
armature resistance
back emf
motor friction and load
field resistance

⇒ The analog signal m(t) is given below m(t) = 4 cos 100 pt + 8 sin 200 pt + cos 300 pt, the Nyquist sampling rate will be
1/100
1/200
1/300
1/600

⇒ The gain margin of first and second order systems is infinite.
TRUE
FALSE

⇒ The commutation method in an inverter, is
line commutation
forced commutation
either (a) or (b)
none of the above

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is
100
50
10
5

⇒ A magic tee is to be used as CW duplexer. Then port 1, port 2, port 3 (E arm), port 4 (H arm) respectively should be connected to
matched load, antenna, receiver and CW transmitter
CW transmitter, antenna, receiver and matched load
CW transmitter, receiver, antenna and matched load
CW transmitter, matched load, receiver and antenna

⇒ The unit for mmf is
A
Wb
T
V

⇒ Surface integral of the electric field intensity is
differential of volume flux
electrical charge
net flux emanating from the surface
none of the above

⇒ Which of the following best represents the output impedance of an actual op-amp?
10 ohm
100 ohm
10 k ohm
100 k ohm

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The transmission coefficient will be
1.70 - j 2.97
0.08 + j 0.32
1.32 + j 1.38
1.08 + j 0.32

⇒ The voltage e₀ in the fi
48 V
24 V
36 V
28 V

⇒ A remote control for TV uses
LED in receiver and photodiode in transmitter
LED in transmitter and photodiode in receiver
LED in both transmitter and receiver
Photodiode in both transmitter and receiver

⇒ The 6 V zener diode shown in figure has zero zener resistance and a knee current of 5 mA. The minimum value of R, so that the voltage across it does not fall below 6
1.2 kΩ
80 Ω
50 W
0

⇒ In FM, as the modulating frequency decreases and the modulating voltage amplitude
increases, the modulation index increases
decrease, the modulation index increases
remains constant, the modulation index increases
remains constant, the modulation index decreases

⇒

Assertion (A): Resistivity of a perfect single crystal of a metal goes to zero as T approaches zero.

Reason (R): Scattering of electrons is due to deviations from perfect periodicity of lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A series circuit has R = 5 Ω and C = 10 μF. It is switched on to a 12 V dc battery at t = 0. The current in the circuit will be maximum
at t = RC
at t = ∞
at t = 0⁺
none of the above

⇒ Which one of the following logic families can be operated using a supply voltage from 3 V to 15 V?
TTL
ECL
PMOS
CMOS

⇒ In a dual converter operated in circulating current mode, the circulating current flows
when load current is zero
when load current is non-zero
even when load current is zero
none of the above

⇒ The MOS symbols shown indica
1, 3, 6
2, 4, 6
1, 3, 5
2, 3, 6

⇒ Hall effect is observed in a specimen (metal or semi- conductor) when it is carrying current and is placed in a magnetic field. The resultant electric field inside the specimen is
normal to both current and magnetic field
in the same direction as current
in a direction anti parallel to magnetic field
none of the above

⇒ For a transistor the normal collector voltage is 12 V. If actually it is found to be + 28 V, the trouble could be
R_L is open
R_E is open
C_E is shorted
C_E is open

⇒ In a 741 OP-amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to
applied load
internal compensation
impedance of the source
power dissipation in the chip