Question is ⇒ When one operand is real and one integer in Pascal, which of the following operations are not allowed?, Options are ⇒ (A) + and -, (B) *, (C) /, (D) Div and Mod, (E) , Leave your comments or Download question paper.

Question is ⇒ When one operand is real and one integer in Pascal, which of the following operations are not allowed?, Options are ⇒ (A) + and -, (B) *, (C) /, (D) Div and Mod, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When one operand is real and one integer in Pascal, which of the following operations are not allowed?
A.	+ and - [Wrong Answer]
B.	* [Wrong Answer]
C.	/ [Wrong Answer]
D.	Div and Mod [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Microwave signals follow the curvature of the earth and the phenomenon
tropospheric scatter
faraday effect
duct propagation
none

⇒ A + A . B =
B
A . B
A
A or B

⇒ A transistor is operated as non-saturated switch to eliminate
turn on time
turn off time
storage time
delay time

⇒ In the above case the total power in the modulated wave double sideband, suppressed carrier AM will be
112 W
400 W
415 W
512 W

⇒ As the temperature increases the mobility of electrons __________ .
decreases because the number of carries increases with increased collisions
increases because the number of carries decreases with decreased collisions
remains same
none of the above

⇒ In a dual converter both converters work as rectifiers.
TRUE
FALSE

⇒ In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?
Get doubled
Get tripled
Remains same
Become eight times

⇒ In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will
remain the same
become three times
decrease
become one-third

⇒ A mP contains 2 MHz crystal. The time taken to complete instructions with 1000 cycles is
2 ms
1 ms
2 nx
1 ns

⇒ The first geostationary satellite was named
Intelsat I
Intelsat II
Intelsat III
Early bird

⇒ Which of the following can provide a digital signal?
Slow change in the value of a resister
Sine wave
Square wave
Gradual turning of a potentiometer

⇒ The measure of mismatch between the load and the transmission line is known as
directivity
Gain
standing wave ratio
reflection coefficient

⇒ A cycloconverter is
ac-dc converter
dc-ac converter
dc-dc converter
ac-ac converter

⇒ If there is phase error in the carrier signal for the detection of SSB signals, then
the output gets reduced, but a phase distortion results
the output is not reduced, but a phase distortion results
the output is not reduced, and also no distortion
the output is reduced, no phase distortion

⇒ A (0.75 - j50) ohm load is connected to a coaxial transmission line of Z₀ = 75 ohms at a frequency of 10 GHz Which of the following will be the best method of matching?
Connecting an inductance at the end
Connecting a short circuited stub at the load
Connecting a capacitance at some distance from the load
Connecting a short circuited stub at some specified distance from the load

⇒ Foster Seeley discriminator uses a
single tuned circuit
double tuned circuit with primary and secondary tuned to the same frequency
double tuned circuit with primary and secondary tuned to the different frequency
none of the above

⇒ A 4 bit modulo 16 ripple counter uses JK flip-flops. If the propagation delay of each FF is 50 ns. The max. clock frequency that can be used is equal to
20 MHz
10 MHz
5 MHz
4 MHz

⇒ In PCM, the information lies
in one or two properties of the pulse
in absence of pulse
in presence of pulse
in presence or absence of pulse

⇒ In a communication system, noise is most likely to affect the signal
at the receiver
at the transmitter
at the information source
in the channel

⇒ Flash ADC is
serial ADC
parallel ADC
series-parallel ADC
successive approximation ADC

⇒ Which of the following is the main advantage of PCM system?
Lower noise
Lower power
Lower bandwidth
All of the above

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ The maximum power that can be transferred to the load is resistor R_L from the voltage source in the figur
1 W
10 W
0.25 W
0.5 W

⇒ Consider the following statements about Infix and Post fix notations in Pascal

In Infix notation operators appear between the operands on which they operate.
In Post fix notation operators appear after the operand.
The Infix expression A + B - C + D will appear as AB + C - D + in post fix notation.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ In end fire array the principle direction of radiation
is perpendicular to the array axis
is perpendicular to the array axis and also to the plane containing the array elements
coincides with the direction of the array
is at 45° to the direction of array axis

⇒ The kinetic energy of photoelectrons emitted by a photo sensitive surface depends on
intensity of the incident radiation
wavelength of the incident radiation
surface conditions of the surface
angle of incidence of radiation

⇒ In Z_RC(s) has a pole at s = 0, the first element in second Foster realization is
R
C
R and C in series
R and C in parallel

⇒

Assertion (A): The function δ'(t - b) is equal to 0 for t ≠ b

Reason (R): A number of impulses spaced from one another form an impulse train.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The characteristic impedance of a cable is about
300 Ω
50 Ω
5 Ω
2 Ω

⇒ For a reactance function H(s), the slope dH (jω)/dω is
0
always positive
always negative
either 0 or positive