Question is ⇒ When large amount of power is required, a push pull amplifier is designed for operation as, Options are ⇒ (A) class A, (B) class B, (C) class C, (D) class AB, (E) , Leave your comments or Download question paper.

Question is ⇒ When large amount of power is required, a push pull amplifier is designed for operation as, Options are ⇒ (A) class A, (B) class B, (C) class C, (D) class AB, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When large amount of power is required, a push pull amplifier is designed for operation as
A.	class A [Wrong Answer]
B.	class B [Correct Answer]
C.	class C [Wrong Answer]
D.	class AB [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In orthogonal BFSK, the energy of information bearing term is
the same as total transmitted energy
one-half of total transmitted energy
one-fourth of total transmitted energy
none of the above

⇒ In a RL circuit, the angle, θ by which the current lags the voltage is
0 > θ > - 90°
90°
0°
0 < θ < 90°

⇒ Minimum number of 2-input NAND gates required to implement the function F = (x + y) (Z + W) is
3
4
5
6

⇒ Each cell of a static RAM has
4 MOS transistors
4 MOS transistors and 2 capacitors
2 MOS transistors and two capacitors
1 MOS transistor and 1 capacitor

⇒ Which of the following is not necessarily the advantage of SSB over double sideband, full carrier AM?
The signal is more noise resistant
More channel space is available
Transmitter circuits must be more stable, given better reception
Considerably less power is required for the same signal strength

⇒ When an SCR is reverse biased
two junctions are reverse biased and one junction is forward biased.
all the three junctions are reverse biased.
one junction is reverse biased and two junctions are forward biased.
any of the above depending on the magnitude of reverse bias.

⇒ Two 2's complement number having sign bits X and Y are added and the sign bit of the result is Z. then, the occurrence of overflow is indicated by the Boolean function.
XYZ
X Y Z
X YZ + XY Z
XY + YZ + ZX

⇒ Which characteristic of a memory chip is called ac characteristics?
Power consumption
Bus loading
Timing characteristic
All of the above

⇒ In the circuit shown the voltage V_s has a phase angle of __________ with respect to V_{L120°
60 °
-90 °
0°}

⇒ Which of the following circuits cannot be demodulate SSB?
Product detector
Balanced modulator
Phase discriminator
BFO

⇒ Trinitron is a monochrome picture tube.
TRUE
FALSE

⇒ Zener breakdown occurs
due to rapture of covalent band
mostly in germanium junctions
in lightly doped junctions
due to thermally generated minority carriers

⇒ The circuit of figure is generally employed
bridge
low-pass filter
peaking network
high-pass filter

⇒ In the given circuit, the switch has been in position 1 for quite a long time. At t = 0 the switch is moved to position 2. At this position what is the time const
0.1 s
1 s
0.11 s
1.11 s

⇒ What kind of signal does the times produce?
Single pulse
Square wave
Continuous pulse
No signal

⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?
636 pF
180 pF
65 pF
30 pF

⇒ A line has L = 0.8 µH/m and C = 32 pF/m. Z₀ =
6000
600
158
15.8

⇒ 268₁₀ = __________ .
10A₁₆
10B₁₆
10C₁₆
10D₁₆

⇒ In the given figure x_{6de(ax₁ + bx₂ + cx₃)
(a + b + c) (x₁ + x₂ + x₃) (d + e)
(ax₁ + bx₂ + cx₃) (d + e)
a b c d e (x₁ + x₂ + x₃)}

⇒ Radar antennas are usually
dipoles
yagi antennas
parabolic dishes
none of the above

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the base current will be
35 μA
25 μA
15 μA
5 μA

⇒ Transition capacitance is associated with __________ and depletion capacitance is associated with __________ diodes.
reverse bias and forward bias
forward bias and reverse bias
reverse bias and reverse bias
forward bias and forward bias

⇒ For representing two sinusoidal voltages on a phasor diagram
Both voltages must be of the same frequency
Both voltages must be sinusoidal but may be of different frequencies
One of the voltages must be of 50 Hz
The frequency of one must be integral of that of other

⇒ In audio cassettes the width of each recording track is
5 mm
2.5 mm
1.5 mm
1 mm

⇒ Two ammeters A and B both 0-10 A have internal resistance of 1 Ω and 0.5 Ω respectively. They are connected in parallel. If total current is 15 A, then
I_A = I_B = 7.5 A
I_A = 5 A, I_B = 10 A
I_A = 10 A, I_B = 5 A
I_A = 9 A, I_B = 6 A

⇒ The number of spectral component of impulse wave is
1
0
2
∞

⇒ If the variance σ_x² of d(n) = x(n) - x(n - 1) is one-tenth the variance σ_x² of a stationary zero mean discrete time signal x(n), then the normalized autocorrelation function R_xx(x)/σ_x² at k = 1 is
0.95
0.9
0.1
0.05

⇒ Voice signal band limited to 3.4 KHz is sampled and pulse code modulated using 64 quantization levels. Ten such signals are time division multiplexed using one 5-bit synchronizing word every alternate frame. The minimum channel bandwidth required for transmission of the TDM signal is
100 KHz
200 KHz
50 KHz
150 KHz

⇒ A single phase electric heater uses phase controlled thyristors. The firing angle is 90°. The degree of heating is
25% of maximum
50% of maximum
75% of maximum
none of the above

⇒ As compared to BJT, MOSFET has
lower switching losses and higher conduction losses
higher switching losses and higher conduction losses
higher switching losses and lower conduction losses
lower switching losses and lower conduction losses