Question is ⇒ When an alternator connected to the bus-bar is shut, down the bus-bar voltage will, Options are ⇒ (A) fall, (B) rise, (C) remain unchanged, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ When an alternator connected to the bus-bar is shut, down the bus-bar voltage will, Options are ⇒ (A) fall, (B) rise, (C) remain unchanged, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When an alternator connected to the bus-bar is shut, down the bus-bar voltage will
A.	fall [Wrong Answer]
B.	rise [Wrong Answer]
C.	remain unchanged [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 12 -10 Explanation:- Answer : C Discuss it below : Mohit Rathod Said on 2019-03-27 01:04:27 Why !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A conductor due to sag between two supports, takes the form of
semi-circle
triangle
ellipse
catenary

⇒ The loads on distributors systems are generally
balanced
unbalanced
either of the above
none of the above

⇒ Large industrial consumers are supplied electrical energy at
400 V
11 kV
66 kV
400 kV

⇒ The material commonly used for insulation in high voltage cables is
lead
paper
rubber
none of the above

⇒ Series capacitors on transmission lines are of little use when the load VAR requirement is
large
small
fluctuating
any of the above

⇒ The spacing between phase conductors of a 220 kV line is approximately equal to
2 m
3.5 m
6 m
8.5 m

⇒ Due to which of the following reasons aluminium is being favoured as busbar material ?
Low density
Low cost
Ease of fabrication
None of the above

⇒ A feeder, in a transmission system, feeds power to
distributors
generating stations
service mains
all of the above

⇒ In transmission lines the cross-arms are made of
copper
wood
R.C.C.
steel

⇒ Distribution lines in India generally use
wooden poles
R.C.C. poles
steel towers
none of the above

⇒ To increase the capacity of a transmission line for transmitting power which of the following must be decreased ?
Capacitance
Line inductance
Voltage
All of the above

⇒ Resistance grounding is used for voltage between
33 kV to 11 k V
11 kV to 33 kV
33 kV to 66 kV
none of the above

⇒ A booster is a
series wound generator
shunt wound generator
synchronous generator
none of the above

⇒ The presence of ozone due to corona is harmful because it
reduces pawer factor
corrodes the material
gives odour
transfer energy to the ground

⇒ Corona results in
radio interference
power factor improvement
better regulation
none of the above

⇒ In case of transmission line conductors with the increase in atmospheric temperature
length decreases but stress increases
length increases but stress decreases
both the length and stress increase
both the length and stress decrease

⇒ The colour of the neutral of three-core flexible cable is
blue
brown
red
black

⇒ In a D.C. 3-wire distribution system, balancer fields are cross-connected in order to
boost the generated voltage
balance loads on both sides of the neutral
make both machines run as unloaded motors
equalize voltages on the positive and negative outers

⇒ The underground system cannot be operated above
440 V
11 kV
33 kV
66 kV

⇒ As compared to a 2-wire D.C. distributor, a 3-wire distributor with same maximum voltage to earth uses only
31.25 percent of copper
33.3 percent of copper
66.7 percent of copper
125 percent of copper

⇒ Which of the following characteristics should the line supports for transmission lines possess ?
Low cost
High mechanical strength
Longer life
All of the above

⇒ 310 km line is considered as
a long line
a medium line
a short line
any of the above

⇒ System grounding is done so that
inductive interference between power and communication circuits can be controlled
the floating potential on the lower voltage winding for a transformer is brought down to an insignificant value
the arcing faults to earth would not set up dangerously high voltage on healthy phases
for all above reasons

⇒ The voltage regulation in magnetic amplifier type voltage regulator is effected by
electromagnetic induction
varying the resistance
varying the reactance
variable transformer

⇒ Earthing is necessary to give protection against
danger of electric shock
voltage fluctuation
overloading
high temperature of the conductors

⇒ Transmission voltage of 11 kV is normally used for distances upto
20-25 km
40-50 km
60-70 km
80-100 km

⇒ Multicore cables generally use
square conductors
circular conductors
rectangular conductors
sector-shaped conductors

⇒ By which of the following a bus-bar is rated ?
Current only
Current and voltage
Current, voltage and frequency
Current, voltage, frequency and short time current

⇒ The wooden poles well impregnated with creosite oil or any preservative compound have life
from 2 to 5 years
10 to 15 years
25 to 30 years
60 to 70 years

⇒ Pin type insulators are generally not used for voltages beyond
1 kV
11 kV
22 kV
33 kV