Question is ⇒ When a source is delivering maximum power to a load through a network, the ratio of power delivered to the source power, Options are ⇒ (A) may be 50% or less than 50%, (B) is 50%, (C) may be 50% or more than 50%, (D) may be 50% or more less than 50%, (E) , Leave your comments or Download question paper.

Question is ⇒ When a source is delivering maximum power to a load through a network, the ratio of power delivered to the source power, Options are ⇒ (A) may be 50% or less than 50%, (B) is 50%, (C) may be 50% or more than 50%, (D) may be 50% or more less than 50%, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a source is delivering maximum power to a load through a network, the ratio of power delivered to the source power
A.	may be 50% or less than 50% [Correct Answer]
B.	is 50% [Wrong Answer]
C.	may be 50% or more than 50% [Wrong Answer]
D.	may be 50% or more less than 50% [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A thyristor has its gate current zero. To start conduction the forward voltage must exceed
about 0.5 V
forward breakover voltage
on state voltage
peak working off state forward voltage

⇒ All of the output pulses are at full transmitter power for a strong signal in all of the following except
PWM
PAM
PFM
PCM

⇒ In figure the dc emitter current of each transistor is a
4 mA
2 mA
3 mA
1 mA

⇒ The circuit shown below is the equivalent circuit of which one of the following microwave resonator ty
Butterfly resonator
Parallel-wire resonator
Cavity resonator
Coaxial line resonator

⇒

Assertion (A): In hybrid digital circuits the problem of logic race can occur.

Reason (R): In two level logic there is no problem of logic race.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a piezoelectric crystal, applications of a mechanical stress would produce
plastic deformation of the crystal
magnetic dipoles in the crystal
electrical polarization in the crystal
shift in the Fermi level

⇒ As compared to MOS memories, bipolar memories have
slower access time but are cheaper
slower access time and are costly
faster access time and are cheaper
faster access time and are costly

⇒ Which of the following statement about TRIAC is incorrect?
It is not particularly suited to A.C. or mains power control
Any one of its main terminals can be used either as cathode or as anode
It can be triggered in response to both positive and negative gate terminals
None of the above

⇒ Output of a phase splitter is
a pair of sine waves of unequal amplitude
a pair of sine waves of equal amplitudes
a pair of sine waves of equal amplitudes and opposite phase
a pair of sine waves of unequal amplitudes and opposite phase

⇒ For a BJT if β = 50, I_CEO = 3 μA and I_C = 1.2 mA then I_E
1 mA
1.2 mA
1.3 mA
1.4 mA

⇒ The circuit diagram shown in the figure consists of transistors
parallel connection
cascade connection
darlington connection
series connection

⇒ A 16 bit counter type ADC uses 1 MHz clock then its maximum conversion time is __________ .
16 μs
15 ms
6.6 ms
66 ms

⇒ Which of the following is not a special purpose peripheral?
Programmable DMA controller
Programmable Floppy disc controller
Programmable Hard disc controller
Programmable CRT controller

⇒ For a type 0 system and unit ramp input, the steady state error is
0
∞
1
1/K_V

⇒ A hot wire instrument is not affected by stray magnetic fields.
TRUE
FALSE

⇒ Leakage current approximately doubles for every 10°C increase in the temperature of a transistor has I_CBO = 400 nA at 25°C, then its leakage current at 80°C
10 μA
18 μA
20 μA
15 μA

⇒ Which of the following draws minimum power from source?
PMMC
Electronic voltmeter
Electrostatic voltmeter
Moving iron voltmeter

⇒ A three state switch has three outputs. These are
low, low and high
low, high, high
low. floating, low
low, high, floating

⇒ Which of the follow
Voltage series feedback and decrease I/P impedance.
Voltage shunt feedback and decrease I/P impedance.
Voltage series feedback and increase I/P impedance.
Voltage shunt feedback and increase I/P impedance.

⇒ In a class C power amplifier the input signal has a frequency of 250 kHz. If the collector current pulses are 0.1 μs wide, the duty cycle of current waveform is
0.5
0.25
0.025
0.0025

⇒ The relation between the apparent power, actual power and reactive power is given by
Apparent power = actual power + reactive power
Apparent power = actual power - reactive power
Apparent power = (actual power)² - (reactive power)²
Apparent power = (actual power)² + (reactive power)²

⇒ The noise generated by a resistor depends upon
its operating temperature
its resistance value
both (a) and (b)
bandwidth

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the starting torque is 100 N-m. At 25 Hz, the starting torque
will be less than 100 N-m
will be more than 100 N-m
may be more or less than 100 N-m depending on motor parameters
very small

⇒ The name field effect is related to the __________ layers of a JFET.
depletion
drain
source
gate

⇒ In a communication system, a process in which statistical averages and time averages are equal is called as,
stationary
ergodic
Gaussian
BIBO stable

⇒ For plane wave propagating in free space or two conductor transmission line, what must be the relationship between the phase velocity v_p , the group velocity v_g and speed of light c?
v_p > c > v_g
v_p < c < v_g
v_p = c = v_g
v_p < v_g < c

⇒ In a TV studio the illuminance is about
200 lux
1000 lux
10000 lux
10 lux

⇒ Consider the following rules in Fortran

A signed or unsigned real variable name or a real constant is a real expression.
Two real expressions connected by an arithmetic operator is a real expression.
A real variable or constant exponential by an integer constant or integer variable is not valid

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ n-channel MOS is
slower than p-channel MOS
faster than p-channel MOS
same as p-channel MOS
none of these

⇒ In position control system the device used for providing rate feedback voltage is
potentiometer
synchro-transmitter
synchro-transformer
tacho generator