Question is ⇒ When a ship floats on water, Options are ⇒ (A) It displaces no water, (B) The weight of water displaced is equal to the weight of the ship, (C) The weight of water displaced is lesser than the weight of the ship, (D) The weight of water displaced is greater than the weight of the ship, (E) , Leave your comments or Download question paper.

Question is ⇒ When a ship floats on water, Options are ⇒ (A) It displaces no water, (B) The weight of water displaced is equal to the weight of the ship, (C) The weight of water displaced is lesser than the weight of the ship, (D) The weight of water displaced is greater than the weight of the ship, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a ship floats on water
A.	It displaces no water [Wrong Answer]
B.	The weight of water displaced is equal to the weight of the ship [Correct Answer]
C.	The weight of water displaced is lesser than the weight of the ship [Wrong Answer]
D.	The weight of water displaced is greater than the weight of the ship [Wrong Answer]
View Answer 36 -15 Explanation:- Answer : B Discuss it below : Bakht Baidar malak Said on 2019-10-21 01:42:15 confused ? Shriram Bairwa Said on 2018-12-04 02:32:54 May be B Sagar Said on 2017-11-01 04:13:40 option D is correct Imran Said on 2016-11-08 21:54:57 I think option D is correct !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Cavitation causes damage in turbine runner near the
Inlet on the concave side of blades
Inlet on the convex side of blades
Outlet on the convex side of blades
Outlet on the concave side of blades

⇒ The motion of air mass in a tornado is a
free vortex motion
forced vortex motion
free vortex at center and forced vortex outside
forced vortex at center and free vortex outside

⇒ The Prartdtl mixing length is.
zero at the pipe wall
maximum at the pipe wall
independent of shear stress
none of the above

⇒ A fluid of kinematic viscosity 0.4 cm2/sec flows through a 8 cm diameter pipe. The maximum velocity for laminar flow will be.
less than 1 m/sec
1 m/sec
1.5 m/sec
2 m/sec

⇒ The ratio of average velocity to maximum velocity for steady laminar flow in circular pipes is.
1/2
2/3
3/2
2

⇒ If the velocity is zero over half of the cross-sectional area and is uniform over the remaining half, then the momentum correction factor is.
1
4/3
2
4

⇒ A right circular cylinder open at the top is filled with liquid and rotated about its vertical axis at such a speed that half the liquid spills out, then the pressure intensity at the center of bottom is.
zero
one-fourth its value when cylinder was full
one-half its value when cylinder was full
cannot be predicted from the given data

⇒ In a water wheel when water enters the buckets mounted on the periphery of a wheel at its top, then it will be known as
Over shot wheel
Breast water wheel
Under shot wheel
Pelton-wheel

⇒ If a sphere of diameter 1 cm falls in castor oil of kinematic viscosity 10 stokes, with a terminal velocity of 1.5 cm/sec, the coefficient of drag on the sphere is.
less than 1
between 1 and 100
160
200

⇒ In which of the following the friction drag is generally larger than pressure drag?
a circular disc or plate held normal to flow
a sphere
a cylinder
an airfoil

⇒ The shear stress distribution for a fluid flowing in between the parallel plates, both at rest, is.
constant over the cross section
parabolic distribution across the section
zero at the mid plane and varies linearly with distance from mid plane
zero at plates and increases linearly to midpoint

⇒ In a two dimensional incompressible steady flow around an airfoil, the stream lines are 2 cm apart at a great distance from the airfoil, where the velocity is 30 m/sec. The velocity near the airfoil, where the stream lines are 1.5 cm apart, is
22.5 m/sec.
33 m/sec.
40 m/sec.
90 m/sec.

⇒ If the dynamic viscosity of a fluid is 0.5 poise and specific gravity is 0.5, then the kinematic viscosity of that fluid in stokes is.
0.25
0.50
1.0
none of the above

⇒ The turbine suitable for low heads and high flow rates is
Pelton-wheel
Francis
Keplan
All of these

⇒ For a stream line body, the predominant drag force is
Friction drag force
Pressure drag force
Total drag force
None of these

⇒ In a Sutro weir, the discharge is proportional to.
H1/2
H3/2
H5/2
H

⇒ A fluid of kinematic viscosity 0.4 cm2/sec flows through a 8 cm diameter pipe. The maximum velocity for laminar flow will be
less than 1 m/sec
1 m/sec
1.5 m/sec
2 m/sec

⇒ The discharge over a broad crested weir is maximum when the depth of flow is.
H/3
H/2
2 H/5
2 H/3

⇒ When the metacentre of a floating body is lower than the centre of gravity, then the body will be in
Unstable equilibrium
Stable equilibrium
Neutral equilibrium
None of these

⇒ An open tank contains 1 m deep water with 50 cm depth of oil of specific gravity 0.8 above it. The intensity of pressure at the bottom of tank will be.
4 kN/m2
10 kN/m2
12 kN/m2
14 kN/m2

⇒ Pitot tube is a device used in the flowing fluid for measuring
Discharge
Pressure
Velocity
Kinetic and potential energy

⇒ For a turbulent flow, the Reynold's number should be more than
4000
2700
2000
500

⇒ If the dynamic viscosity of a fluid is 0.5 poise and specific gravity is 0.5, then the kinematic viscosity of that fluid in stokes is
0.25
0.50
1.0
none of the above

⇒ Drag force is a function of.
i)    projected area of the body
ii)    mass density of the fluid
iii)    velocity of the body
The    correct answer is
(i) and (ii)
(i) and (iii)
(ii) and (iii)
(i), (ii) and (iii)

⇒ Magnus effect is very near to the
Magnetic field
Electric field
Bernoulli's theorem
Magnetic effect of current

⇒ The increase in meta centric height
i) increases stability
ii) decreases stability
iii) increases comfort for passengers
iv) decreases comfort for passengers
The correct answer is
(i) and (iii)
(i)and(iv)
(ii) and (iii)
(ii) and (iv)

⇒ Drag force is a function of
Velocity of the body
Mass density of the fluid
Projected area of the body
All of the above

⇒ In venturimeter, the ratio between throat diameter and pipe diameter is generally adopted as
1 : 2
1 : 4
1 : 8
2 : 11

⇒ Two pipes of same length and diameters d and 2d respectively are connected in series. The diameter of an equivalent pipe of same length is.
less than d
between d and 1.5 d
between 1.5 d and 2d
greater than 2d

⇒ Coefficient of velocity for Borda's mouth piece running full is.
0.611
0.707
0.855
1.00