Question is ⇒ When a plane wave travelling in free space is incident normally on a medium having εr = 4.0, then fraction of power transmitted into the medium is given by, Options are ⇒ (A) 42956, (B) 42737, (C) 42738, (D) 42861, (E) , Leave your comments or Download question paper.

Question is ⇒ When a plane wave travelling in free space is incident normally on a medium having εr = 4.0, then fraction of power transmitted into the medium is given by, Options are ⇒ (A) 42956, (B) 42737, (C) 42738, (D) 42861, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a plane wave travelling in free space is incident normally on a medium having ε_r = 4.0, then fraction of power transmitted into the medium is given by
A.	42956 [Correct Answer]
B.	42737 [Wrong Answer]
C.	42738 [Wrong Answer]
D.	42861 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The Thevenin's equivalent of network in figure(1) is a 10 V source in series with 2 Ω resistance. If a 3 Ω resistance is connected across AB as shown in figure(2) the Thevenin's equivalen
10 V in series with 1.2 Ω resistance
6 V in series with 1.2 Ω resistance
10 V in series with 5 Ω resistance
6 V in series with 5 Ω resistance

⇒ A constant k band stop filter has cutoff frequencies of 1000 and 4000 Hz. The attenuation will be maximum when frequency is
4000 Hz
3000 Hz
2000 Hz
1000 Hz

⇒ Which of these is the most recent display device?
LED
LCD
VF
(a) and (c)

⇒ In broadcast television, the number of lines per frame is chosen to be odd number to
reduce the required bandwidth
improve resolution
reduce peak power requirement
make interlacing easier

⇒ Secondary emission is always decremental.
TRUE
FALSE

⇒ In figure, the current through 10 V batter
0
0.5 A charging
0.5 A discharging
none of the above

⇒ A signal is sampled at Nyquist rate f_s = 2f₀. The function can be recovered from its samples only. If it is a
Periodic square wave of fundamental frequency f₀
Triangular wave of fundamental frequency f₀
Periodic sine wave of fundamental frequency f₀
Unit impulse function

⇒ Measurement of non-electrical quantity involves the following subsystems

Amplifier block
Display block
Instrumentation block
Transducer block

The correct sequence of these blocks is
4, 1, 3, 2
4, 3, 1, 2
1, 3, 2, 4
1, 2, 3, 4

⇒ Digital technologies being used now-a-days are
DTL and EMOS
TTL, ECL, CMOS and RTL
TTL, ECL and CMOS
TTL, ECL. CMOS and DTL

⇒ Half power point directions for broadside is
60°
30°
45°
at any angle

⇒ In a TWT the amplitude of resultant wave travelling down the helix
increases exponentially
increases linearly
decreases exponentially
is almost constant

⇒ Even at room temperature, an intrinsic semiconductor has some holes. These holes are due to
electron
doping
thermal energy
free electrons

⇒ In an R-C circuit, the impedance is 40 Ω at a frequency of 100 Hz. At 200 Hz the impedance should be
40 Ω
80 Ω
20 Ω
more than 20 Ω but less than 40 Ω

⇒ Which of the following is not considered as a useful quantity in comparing noise performance of receivers?
Noise temperature
Noise figure
Noise resistance
Input noise voltage

⇒

Assertion (A): Even if TTL gates and CMOS gates used in a realization have the same power supply of + 5 V, suitable circuit is needed to interconnect them

Reason (R): V_OH, V_OL, V_IH and V_IL of a TTL gave are respectively 2.4, 0.4, 2 and 0.8 V respectively. If supply voltage is + 5 V. V_IL and V_IH for CMOS gate for the supply voltage of + 5 V are 1.5 V and 3.5 V respectively.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In n channel JFET
I_D and V_DS are positive but V_GS is negative
I_D and V_GS are positive but V_DS is negative
V_DS and V_GS are positive but I_D is negative
I_D, V_DS and V_GS are all positive

⇒ The impulse response h(t) of a linear time-invariant continuous time system is described by h(t) = exp (at) u(t) + exp (βt) u (- t), where u(t) denotes the unit step function, and a and β are constants. This system is stable if
a is positive and β is positive
a is negative and β is negative
a is positive and β is negative
a is negative and β is positive

⇒ In 8085, which of the following registers cannot be paired?
A
E
C
both (b) and (c)

⇒ Class C amplifier is suitable for
a narrow frequency band
a wide frequency band
audio frequencies
either (b) or (c)

⇒ The main feature of a parametric amplifier is
low noise
very high gain
broad bandwidth
both (b) and (c)

⇒ Which of the following operation are performed on linear queues?

Testing a linear queue for underflow
Enqueue operation
Dequeue operation
Testing a linear queue for overflow.

Select the correct answer using the codes given below the lists
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2, 3 and 4

⇒ Three analog signals, having bandwidths 1200 Hz, 600 Hz, 600 Hz are sampled at their Nyquist rates, encoded with 12 bit words, and time division multiplexed. The bit rate for the multiplexed signal is
115.2 kbps
28.8 kbps
57.6 kbps
38.4 kbps

⇒ If sequence currents I_a1 = 2 ∠- 90°, I_a2 = 0.2 ∠ 90° and I_a3 = 1.8 ∠ 90°, I_a =
0
1
4
8

⇒ AB + AB =
B
A
1
0

⇒ In a Weston synchronoscope, the moving coil is connected across
bus bar
incoming alternator
lamp
fixed coils

⇒ The purpose of earthing electric appliances is
to provide safety against shock
to ensure that appliance works satisfactorily
to ensure that appliance gets full voltage
all of the above

⇒

Assertion (A): In computers the data is stored in hexadecimal form

Reason (R): Hexadecimal representation is short as compared to binary representation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In figure, S is closed at t = 0. At t = t₁, I = 1 A and di/dt = 1 A/s. Then the value of
1 H
2 H
3 H
4 H

⇒ A transistor with a = 0.98 then β will be
49
50
47
48

⇒ A photo diode is
forward biased
reverse biased
either forward or reverse biased
unbiased