Question is ⇒ When a magnetic circuit is compared with an electric circuit, the equivalent of the magnetic flux is, Options are ⇒ (A) the conductivity of the lines, (B) the voltage of the source, (C) the current in the lines, (D) the conductance of the load, (E) , Leave your comments or Download question paper.

Question is ⇒ When a magnetic circuit is compared with an electric circuit, the equivalent of the magnetic flux is, Options are ⇒ (A) the conductivity of the lines, (B) the voltage of the source, (C) the current in the lines, (D) the conductance of the load, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When a magnetic circuit is compared with an electric circuit, the equivalent of the magnetic flux is
A.	the conductivity of the lines [Wrong Answer]
B.	the voltage of the source [Wrong Answer]
C.	the current in the lines [Correct Answer]
D.	the conductance of the load [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following statement about JFET is true?
In a JFET, gate and source have opposite polarity with respect to drain irrespective of the type of FET
In its schematic symbol for JFET, the arrow always points to p-type material
In an n-channel JFET, the channel is the narrowest under zero gate bias condition
In JFET, gate source cut off voltage is numerically equal to the pinch off voltage

⇒ The logic realized by the circuit shown in figure belo
F = A - C
F = A + C
F = B ⊙ C
F = B ⊕ C

⇒ Astable multivibrator has
one stable state
two stable state
two quasi-stable states
one quasi stable state

⇒ Pick the correct statement with respect to following fig
both the circuit are not identical filter Ckts
identical filter circuit at all frequencies
identical filter circuit at low frequency
identical filter circuit at high frequency

⇒ The instruction MOV r₁, r₂ in 8085
causes contents of registers r₂ to be moved to r, and uses register addressing
causes contents of registers r₁ to be moved to r₂ and uses register addressing
causes contents of registers r₁ to be moved to r₂ and uses register immediate addressing
causes contents of registers r₂ to be moved to r₁ and uses register immediate addressing

⇒ The hex number EB₁₆ represents binary number of
11101011
10010110
10101100
11101011

⇒ Which of the following conversion is incorrect?
2048.0625 = 100000000000.0001₂
100000011.1001₂ = 131.5625₁₀
101101₂ = 45₈
Hexadecimal B6C₇ = 46791₁₀

⇒ The colour code on a carbon resistor is yellow-violet-orange. The value of resistance is
17000 Ω
27000 Ω
37000 Ω
47000 Ω

⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti
0.02 V/μsec, 1.59 KHz
0.04 V/μsec, 1.59 KHz
0.02 V/μsec, 3.58 KHz
0.02 V/μsec, 1.59 KHz

⇒ The main advantage of superheterodyne receiver is
better tracking
simple cut
better alignment
improvement in selectivity and sensitivity

⇒ If a driving point function N(s) = p(s)/q(s), then
the terms of lowest degree in p(s) and q(s) may differ in degree by zero only
the terms of lowest degree in p(s) and q(s) may differ by one at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by two at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by three at the most

⇒ For the single rectangular pulse of the given fi
TRUE
FALSE

⇒ A material for permanent magnet should have
High retentivity
High permeability
Low hysteresis loss
High hysteresis loss

⇒ If temperature is increased, the temperature coefficient of a metal
increases
decreases
may increase or decrease
remains constant

⇒

Assertion (A): A VMOS can handle much larger current than other field effect transistors.

Reason (R): In a VMOS the conducting channel is very narrow.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is non-saturating?
TTL
CMOS
ECL
Both (a) and (b)

⇒ For a BJT, under the saturation condition,
I_C = βI_B
I_C = aI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ Which of the following is taken as reference antenna for directive gain?
Half wave dipole
Elementary doublet
Isotropic
Infinitesimal dipole

⇒ Which of the following is error correcting code?
EBCDIC
Gray
Hamming
ASCII

⇒ The sum of positive real function is positive real.
TRUE
FALSE

⇒ In the circuit, S was initially open. At time t = 0, S is closed. When the current through the inductor is 6 A, the rate of change of current through the resistor is 6 A/s. The value of the inductor woul
1 H
2 H
3 H
4 H

⇒ When UJT is used for thyristor gate signal, the output of UJT is
sine wave
square wave
saw tooth wave
either (a) or (c)

⇒ Which of the following functions would have only odd powers of x in its Taylor series expansion about the point x = 0?
sin (x³)
sin (x²)
cos (x³)
cos (x²)

⇒ A Weinbridge oscillator is a
VHF oscillator
RF oscillator
microwave oscillator
audio frequency oscillator

⇒ A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with ε_r = 4. The reflection coefficient for the normal incidence is
zero
0.5 ∠180°
0.33 ∠0°
0.33 ∠180°

⇒ An amplitude modulated signal occupies a frequency range from 395 kHz to 405 kHz. If can be demodulated by which of the following?
Using an envelope detector and filter
Multiplying with a 395 kHz local signal
Multiplying with a 405 kHz local signal
Low pass filtering with cut off at 400 kHz

⇒ In the circuit of figure the voltage across C at t = 0^{+0 V
20 V
very large
7.5 V}

⇒ An audio signal is band limited to 4 kHz. It is sampled at 8 kHz. What will be the spectrum of the sampled signal?
-4 kHz to 4 kHz
-8 kHz to 8 kHz
every 4n kHz repeating
every ± 8 kHz and operating as well as at zero (k integer)

⇒ A lossless transmission line with air dielectric is 6 m long. what is the phase constant?
1p rad/m
2p rad/m
0.2p rad/m
0.1p rad/m

⇒ IN 3242 is a
P-N-P transistor
N-P-N transistor
UJT
semi-conductor diode